A study on Deformation and Densification characteristics of P/M Fe-C-Mn alloy Steels under cold upset

被引：2
|
作者：
Vishnuraj, J. T. [1 ]
Kandavel, T. K. [1 ]
Kishan, I. Sai [1 ]
Akash, G. [1 ]
机构：
[1] SASTRA Univ, Sch Mech Engn, Shanmugha Arts Sci Technol & Res Acad, Thanjavur 613401, Tamil Nadu, India
来源：
MATERIALS TODAY-PROCEEDINGS | 2018年 / 5卷 / 08期
关键词：
Powder metallurgy; Sintering; Deformation; Densification; Plain carbon steel; cold upsetting; MECHANICAL-PROPERTIES; SINTERED IRON; MICROSTRUCTURE;
D O I：
10.1016/j.matpr.2018.06.039
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
The present investigation has been undertaken to study the deformation and densification characteristics of Mn added P/M plain carbon steel. Cold upsetting was carried out on the sintered preforms of Fe-0.2%C, Fe-0.2%C-0.5%Mn, Fe-0.2%C-2.0%Mn low alloy steels using flat dies. Dimensional changes of the preforms after uniform incremental loads were accurately measured and the density was also evaluated. Further, the photomicrographs of the alloy steels reveal that addition of Mn leads to the formation of undissolved carbides in the grain structure. Increased Mn content leads to work hardening effect during cold deformation thereby reducing the deformation as well as densification. (C) 2017 Elsevier Ltd. All rights reserved.
引用
收藏
页码：16740 / 16747
页数：8
相关论文
共 47 条
  • [41] STRUCTURAL CHARACTERISTICS AND FRACTURE MECHANISM UNDER COLD TENSION OF FE-33MN-8AL-1.4SI ALLOYS WITH 0.6 AND 0.8-PERCENT-C
    ARABE, MVC
    SILVA, EMP
    JOURNAL OF METALS, 1985, 37 (11): : A1 - A1
  • [42] Thermodynamic and kinetic behavior of low-alloy steels: An atomic level study using an Fe-Mn-Si-C modified embedded atom method (MEAM) potential
    Aslam, I.
    Baskes, M. I.
    Dickel, D. E.
    Adibi, S.
    Li, B.
    Rhee, H.
    Zaeem, M. Asle
    Horstemeyer, M. F.
    MATERIALIA, 2019, 8
  • [43] A study of mechanical properties and weldability in weldment of cold-rolled Fe-19Mn-5.5Cr-3.5A1-0.25C alloy at cryogenic temperature
    Kim, YP
    Kim, WS
    Hong, SH
    ADVANCES IN CRYOGENIC ENGINEERING MATERIALS, VOL 44, PTS A AND B, 1998, 44 : 121 - 128
  • [44] Effect of corrosion in 0.1 M Na2SO4 on the structure and properties of a soft-magnetic Fe-P-Si-Mn-V-C alloy in an amorphous and a relaxed state
    Vavilova, V. V.
    Baldokhin, Yu. V.
    Zabolotnyi, V. T.
    Anosova, M. O.
    Korneev, V. P.
    Gavrilov, D. A.
    INORGANIC MATERIALS, 2013, 49 (11) : 1113 - 1122
  • [45] Effect of corrosion in 0.1 M Na2SO4 on the structure and properties of a soft-magnetic Fe-P-Si-Mn-V-C alloy in an amorphous and a relaxed state
    V. V. Vavilova
    Yu. V. Baldokhin
    V. T. Zabolotnyi
    M. O. Anosova
    V. P. Korneev
    D. A. Gavrilov
    Inorganic Materials, 2013, 49 : 1113 - 1122
  • [46] Study on the Cutting Characteristics and Chip Formation Mechanism of Typical Amorphous Alloy Fe40Ni40P14B6 under Micro Cutting Conditions
    He G.
    Li L.
    Liu X.
    Jiang T.
    Zou J.
    Jixie Gongcheng Xuebao/Journal of Mechanical Engineering, 2020, 56 (03): : 223 - 232
  • [47] A comparative study of the thermal dehydration characteristics of MCl2•2H2O (where M = Mn2+, Fe2+, Co2+, Ni2+ and Cu2+) under dynamic condition
    Kanungo, SB
    JOURNAL OF THE INDIAN CHEMICAL SOCIETY, 2005, 82 (11) : 1000 - 1002
12345