A study on Deformation and Densification characteristics of P/M Fe-C-Mn alloy Steels under cold upset

被引：2

作者：

Vishnuraj, J. T. ^{[1
]}

Kandavel, T. K. ^{[1
]}

Kishan, I. Sai ^{[1
]}

Akash, G. ^{[1
]}

机构：

[1] SASTRA Univ, Sch Mech Engn, Shanmugha Arts Sci Technol & Res Acad, Thanjavur 613401, Tamil Nadu, India

来源：

MATERIALS TODAY-PROCEEDINGS | 2018年 / 5卷 / 08期

关键词：

Powder metallurgy; Sintering; Deformation; Densification; Plain carbon steel; cold upsetting; MECHANICAL-PROPERTIES; SINTERED IRON; MICROSTRUCTURE;

D O I：

10.1016/j.matpr.2018.06.039

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

The present investigation has been undertaken to study the deformation and densification characteristics of Mn added P/M plain carbon steel. Cold upsetting was carried out on the sintered preforms of Fe-0.2%C, Fe-0.2%C-0.5%Mn, Fe-0.2%C-2.0%Mn low alloy steels using flat dies. Dimensional changes of the preforms after uniform incremental loads were accurately measured and the density was also evaluated. Further, the photomicrographs of the alloy steels reveal that addition of Mn leads to the formation of undissolved carbides in the grain structure. Increased Mn content leads to work hardening effect during cold deformation thereby reducing the deformation as well as densification. (C) 2017 Elsevier Ltd. All rights reserved.

引用

页码：16740 / 16747

页数：8

共 47 条

[31] CREEP DEFORMATION-BEHAVIOR OF AL-7.4FE-3.4CE P/M ALLOY AT 315-C
SPECK, JS
JONES, JW
JOURNAL OF METALS, 1983, 35 (08): : A63 - A63
[32] Deformation and recrystallization behavior of a Fe-20Mn-3Si-3Al-0.045C steel under cold-rolling
SHEN Yongfeng~(1))
Baosteel Technical Research, 2010, 4(S1) (S1) : 48 - 48
[33] Impact of Magnetic State of Austenite on the Phase and Structure Transformations of Wear-Resistant Fe-C-Mn-Cr Steels under Plastic Deformation
Snizhnoi, G. V.
Sobyr, S. V.
METALLOFIZIKA I NOVEISHIE TEKHNOLOGII, 2012, 34 (10): : 1355 - 1365
[34] A Preliminary Study of New Experimental Low-Cost Fe-P-Based and Mn-Fe-P-Based Brazing Filler Metals for Brazing of Non-Alloy and Low-Alloy Steels
Zorc, Matija
Zorc, Borut
Medved, Jozef
Nagode, Ales
METALS, 2023, 13 (09)
[35] Influence of Tungsten on Dry Sliding Wear Behaviour of Sintered/Hot Extruded P/M Alloy Steels (Fe-C-W-Ti)
Prabu, S. Senthur
Prathiba, S.
Asokan, M. A.
Sreelekh, M. K.
Steff, Francis
Sai, Mounish
MATERIALS RESEARCH-IBERO-AMERICAN JOURNAL OF MATERIALS, 2017, 20 (04): : 1050 - 1056
[36] In Situ 3D Neutron Depolarization Study of the Transformation Kinetics and Grain Size Evolution During Cyclic Partial Austenite-Ferrite Phase Transformations in Fe-C-Mn Steels
Fang, H.
van der Zwaag, S.
van Dijk, N. H.
METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2018, 49A (12): : 5962 - 5975
[37] In Situ 3D Neutron Depolarization Study of the Transformation Kinetics and Grain Size Evolution During Cyclic Partial Austenite-Ferrite Phase Transformations in Fe-C-Mn Steels
H. Fang
S. van der Zwaag
N. H. van Dijk
Metallurgical and Materials Transactions A, 2018, 49 : 5962 - 5975
[38] Study on Microstructure and In Situ Tensile Deformation Behavior of Fe-25Mn-xAl-8Ni-C Alloy Prepared by Vacuum Arc Melting
Bai, Yaping
Li, Meng
Cheng, Chao
Li, Jianping
Guo, Yongchun
Yang, Zhong
METALS, 2021, 11 (05)
[39] Characteristics of Non-uniform Deformation Behavior in Fe-10%Mn-0.1%C Alloy with Ultrafine-grained Multi-phase Martensitic Structure
Maeda, Takuya
Matsuda, Kyosuke
Takanashi, Misa
Masumura, Takuro
Tsuchiyama, Toshihiro
Shirahata, Hiroyuki
Uemori, Ryuji
TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN, 2024, 110 (03): : 268 - 278
[40] Comparative study on microstructures and mechanical properties of Q&P steels prepared with hot-rolled and cold-rolled C-Si-Mn sheets
Cheng, Y. Y.
Zhao, G.
Xu, D. M.
Mao, X. P.
Bao, S. Q.
Yang, G. W.
JOURNAL OF MATERIALS RESEARCH AND TECHNOLOGY-JMR&T, 2022, 20 : 1226 - 1242

← 1 2 3 4 5 →