Residual stress in pearlitic steel rods during progressively cold drawing measured by X-ray diffraction

被引：15

作者：

Yang, F. ^{[1
]}

Jiang, J. Q. ^{[1
]}

Wang, Y. ^{[1
]}

Ma, C. ^{[1
]}

Fang, F. ^{[1
]}

Zhao, K. L. ^{[2
]}

Li, W. ^{[2
]}

机构：

[1] SE Univ, Coll Mat Sci & Engn, Nanjing 211189, Peoples R China

[2] Harbin Bearing Grp Co, Ctr Tech, Harbin 150036, Peoples R China

来源：

MATERIALS LETTERS | 2008年 / 62卷 / 16期

关键词：

pearlitic steels; cold drawing; residual stress; X-ray diffraction;

D O I：

10.1016/j.matlet.2007.11.054

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This research aims to investigate the residual stress evolution in pearlitic steels during progressively cold drawing. To this end, pearlitic steel rods of 13 mm, diameter are continuously cold-drawn to wires of 5.3 mm, and then the residual stresses of multi-pass drawing rods are evaluated by X-ray diffraction technique. The XRD results indicate that the residual stresses of pearlitic steel rods increase gradually with the growing of drawing strain, from stress-free of original rod to high tensile stress of 650 MPa in the last pass drawing wire. (c) 2007 Elsevier B.V. All rights reserved.

引用

页码：2219 / 2221

页数：3

共 50 条

[31] X-ray stress and residual stress analysis of Charpy steel specimens
Hoffmann, Joachim Ernst
Clemens, Helmut
MATERIALPRUFUNG, 2007, 49 (11-12): : 588 - 595
[32] Texture and lattice strain evolution in a pearlitic steel during shear deformation: An in situ synchrotron X-ray diffraction study
da Silva, Carlos Samuel Alves
Saraiva, Breno Rabelo Coutinho
Novotny, Ladislav
Sarvezuk, Paulo Willian Carvalho
Masoumi, Mohammad
Silva, Cleiton Carvalho
Herculano, Luis Flavio Gaspar
Cardoso, Jorge Luiz
de Abreu, Hamilton Ferreira Gomes
Beres, Miloslav
INTERNATIONAL JOURNAL OF PLASTICITY, 2024, 181
[33] X-RAY DIFFRACTION ANALYSIS OF THE RESIDUAL AUSTENITE OF QUENCHED STEEL.
Yershov, V.M.
Physics of Metals and Metallography, 1973, 35 (04): : 119 - 123
[34] X-ray diffraction in thermal treatments: Determination of residual austenite by X-ray diffraction
Bach, M
Broll, N
Cornet, A
Gaide, L
JOURNAL DE PHYSIQUE IV, 1996, 6 (C4): : 887 - 895
[35] Adaptation of the x-ray diffraction technique to the analysis of residual stress in carbo-nitrided steel layers
Sprauel, JM
Michaud, H
RESIDUAL STRESSES VII, PROCEEDINGS, 2005, 490-491 : 125 - 130
[36] Study by X-ray diffraction and mechanical analysis of the residual stress generation during thermal spraying
Pina, J
Dias, A
Lebrun, JL
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2003, 347 (1-2): : 21 - 31
[37] X-ray Diffraction for the Determination of Residual Stress of Crystalline Material: An Overview
Lodh, Arijit
Thool, Khushahal
Samajdar, Indradev
TRANSACTIONS OF THE INDIAN INSTITUTE OF METALS, 2022, 75 (04) : 983 - 995
[38] Distribution and Anisotropy of Dislocations in Cold-drawn Pearlitic Steel Wires Analyzed Using Micro-beam X-ray Diffraction
Sato, Shigeo
Shobu, Takahisa
Satoh, Kozue
Ogawa, Hiromi
Wagatsuma, Kazuaki
Kumagai, Masayoshi
Imafuku, Muneyuki
Tashiro, Hitoshi
Suzuki, Shigeru
ISIJ INTERNATIONAL, 2015, 55 (07) : 1432 - 1438
[39] Calibration of X-Ray Diffraction Instruments for Residual-Stress Measurement
Trofimov V.N.
Karmanov V.V.
Shiryaev A.A.
Zvonov S.N.
Russian Engineering Research, 2019, 39 (03) : 276 - 278
[40] Applications of X-ray diffraction technique in the residual stress measurement of films
School of Materials Science and Engineering, Southeast University, Nanjing 211189, China
不详
Gongneng Cailiao, 2007, 11 (1745-1749): : 1745 - 1749

← 1 2 3 4 5 →