Deposition and characterization of Ti(C,N,O) coatings by unbalanced magnetron sputtering

被引：38
|
作者：
Hsieh, JH [1 ]
Wu, W
Li, C
Yu, CH
Tan, BH
机构：
[1] Nanyang Technol Univ, Sch MPE, Singapore 639798, Singapore
[2] Natl Chung Hsing Univ, Dept Mat Engn, Taichung 402, Taiwan
[3] Gint Inst Mfg Technol, Singapore 638075, Singapore
来源：
SURFACE & COATINGS TECHNOLOGY | 2003年 / 163卷
关键词：
magnetron sputtering; hard coating; X-ray diffraction; wear;
D O I：
10.1016/S0257-8972(02)00494-2
中图分类号：
TB3 [工程材料学];
学科分类号：
0805 ; 080502 ;
摘要：
Several TiCNO coatings were deposited using an unbalanced magnetron sputtering system. The coating properties as a function of oxygen/nitrogen flow ratio were studied using glow discharge optical spectrometer, X-ray diffraction, scratch testing and nanoindentation measurement. The tribological properties of the coatings were then investigated using a ball-on-disk setup with alumina balls. The results show that coating properties and performance are greatly affected by the flow rate of oxygen. With oxygen flow rate at 4 seem during deposition, the TiCNO coating shows the lowest wear rate among all. Further increase in oxygen flow rate caused a decrease of hardness, adhesion and wear resistance, while together with the increase of friction coefficient. Also found is that the color of these coatings changes as a function of oxygen flow rate, indicating that these coatings can be used as decorating thin films with wide variety of choices. (C) 2002 Elsevier Science B.V. All rights reserved.
引用
收藏
页码：233 / 237
页数：5
相关论文
共 50 条
  • [41] Preparation of CrN/Cr2N multilayer coatings by unbalanced magnetron sputtering
    Zeng, XT
    Zhang, S
    Tan, BH
    Liu, YC
    SURFACE MODIFICATION TECHNOLOGIES X, 1997, : 899 - 908
  • [42] Ti-B-C nanocomposite coatings deposited by magnetron sputtering
    Lauridsen, J.
    Nedfors, N.
    Jansson, U.
    Jensen, J.
    Eklund, P.
    Hultman, L.
    APPLIED SURFACE SCIENCE, 2012, 258 (24) : 9907 - 9912
  • [43] Composition and oxidation resistance of Ti-B-C and Ti-B-C-N coatings deposited by magnetron sputtering
    Zhong, D
    Moore, JJ
    Mishra, BM
    Ohno, T
    Levashov, EA
    Disam, J
    SURFACE & COATINGS TECHNOLOGY, 2003, 163 : 50 - 56
  • [44] Influence of the sputtering reactive gas on the oxide and oxynitride La-Ti-O-N deposition by RF magnetron sputtering
    Lu, Y.
    Le Paven-Thivet, C.
    Benzerga, R.
    Le Gendre, L.
    Sharaiha, A.
    Tessier, F.
    Chevire, F.
    APPLIED SURFACE SCIENCE, 2013, 264 : 533 - 537
  • [45] Development of dark Ti(C,O,N) coatings prepared by reactive sputtering
    Chappe, J. M.
    Vaz, F.
    Cunha, L.
    Moura, C.
    De Lucas, M. C. Marco
    Imhoff, L.
    Bourgeois, S.
    Pierson, J. F.
    SURFACE & COATINGS TECHNOLOGY, 2008, 203 (5-7): : 804 - 807
  • [46] Deposition of ultrahard Ti-Si-N coatings by pulsed high-current reactive magnetron sputtering
    Oskomov, K. V.
    Zakharov, A. N.
    Rabotkin, S. V.
    Solov'ev, A. A.
    TECHNICAL PHYSICS, 2016, 61 (02) : 215 - 220
  • [47] Effect of oxygen incorporation on structural and properties of Ti-Si-N nanocomposite coatings deposited by reactive unbalanced magnetron sputtering
    Ding, X. Z.
    Zeng, X. T.
    Liu, Y. C.
    Zhao, L. R.
    JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 2006, 24 (04): : 974 - 977
  • [48] Influence of Bias Voltage on Properties of Ti-Al-N Coatings Deposited by Closed Field Unbalanced Magnetron Sputtering Technology
    Duo, Shu Wang
    Luo, Chen Gang
    Shang, Jin
    Zhang, Hao
    MANUFACTURING, DESIGN SCIENCE AND INFORMATION ENGINEERING, VOLS I AND II, 2015, : 793 - 797
  • [49] Magnetron sputtering deposition Ti-B-C-N films by Ti/B4C compound target
    Tang, Guangze
    Ma, Xinxin
    Sun, Mingren
    Xu, Shuyan
    SURFACE & COATINGS TECHNOLOGY, 2009, 203 (09): : 1288 - 1291
  • [50] Deposition, microstructure, and properties of nanocrystalline Ti(C,O,N) coatings
    Ruppi, S
    Larsson, A
    JOURNAL OF VACUUM SCIENCE & TECHNOLOGY A, 2003, 21 (01): : 66 - 75
12345