Deposition and characterization of Ti(C,N,O) coatings by unbalanced magnetron sputtering

被引：38

作者：

Hsieh, JH ^{[1
]}

Wu, W

Li, C

Yu, CH

Tan, BH

机构：

[1] Nanyang Technol Univ, Sch MPE, Singapore 639798, Singapore

[2] Natl Chung Hsing Univ, Dept Mat Engn, Taichung 402, Taiwan

[3] Gint Inst Mfg Technol, Singapore 638075, Singapore

来源：

SURFACE & COATINGS TECHNOLOGY | 2003年 / 163卷

关键词：

magnetron sputtering; hard coating; X-ray diffraction; wear;

D O I：

10.1016/S0257-8972(02)00494-2

中图分类号：

TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

Several TiCNO coatings were deposited using an unbalanced magnetron sputtering system. The coating properties as a function of oxygen/nitrogen flow ratio were studied using glow discharge optical spectrometer, X-ray diffraction, scratch testing and nanoindentation measurement. The tribological properties of the coatings were then investigated using a ball-on-disk setup with alumina balls. The results show that coating properties and performance are greatly affected by the flow rate of oxygen. With oxygen flow rate at 4 seem during deposition, the TiCNO coating shows the lowest wear rate among all. Further increase in oxygen flow rate caused a decrease of hardness, adhesion and wear resistance, while together with the increase of friction coefficient. Also found is that the color of these coatings changes as a function of oxygen flow rate, indicating that these coatings can be used as decorating thin films with wide variety of choices. (C) 2002 Elsevier Science B.V. All rights reserved.

引用

页码：233 / 237

页数：5

共 50 条

[31] Synthesis and characterization of (C,N)-alloyed stainless steel coatings by high energy ion assisted magnetron sputtering deposition
Grigore, E.
Ruset, C.
Li, X.
Dong, H.
MULTI-FUNCTIONAL MATERIALS AND STRUCTURES, PTS 1 AND 2, 2008, 47-50 : 1482 - +
[32] Deposition of ultrahard Ti–Si–N coatings by pulsed high-current reactive magnetron sputtering
K. V. Oskomov
A. N. Zakharov
S. V. Rabotkin
A. A. Solov’ev
Technical Physics, 2016, 61 : 215 - 220
[33] S-phase coatings by unbalanced magnetron sputtering
Dahm, KL
Dearnley, PA
SURFACE MODIFICATION TECHNOLOGIES IX, 1996, : 437 - 454
[34] Protective multilayer (Ti, Al) N coatings deposited at low temperature by closed-field unbalanced magnetron sputtering
Cholakova, T. M.
Chitanov, V. A.
Kolaklieva, L. P.
Kakanakov, R. D.
Kovacheva, D. G.
Stefanov, P. K.
Rabadzhiyska, S. N.
Korina, E. A.
Kopanov, V. I.
BULGARIAN CHEMICAL COMMUNICATIONS, 2016, 48 : 384 - 390
[35] Deposition and characterization Zr-Al-N coatings prepared by magnetron sputtering for tribological applications
Kumarasubramanian, R.
Kumar, D. Dinesh
Preetham, R. Muni Sai
Reddy, P. Bharath Kumar
MATERIALS TODAY-PROCEEDINGS, 2021, 44 : 3701 - 3706
[36] Characterization of nanostructured Ti-B-(N) coatings produced by direct current magnetron sputtering
Lopez-Cartes, C.
Martinez-Martinez, D.
Sanchez-Lopez, J. C.
Fernandez, A.
Garcia-Luis, A.
Brizuela, M.
Onate, J. J.
THIN SOLID FILMS, 2007, 515 (7-8) : 3590 - 3596
[37] Oxidation behavior of Ti-B-C-N coatings deposited by reactive magnetron sputtering
Chen, Xiangyang
Ma, Shengli
Xu, Kewei
Chu, Paul K.
VACUUM, 2012, 86 (10) : 1505 - 1512
[38] Deposition of amorphous thin films by unbalanced magnetron sputtering
Hsieh, JH
Tan, BH
Liu, YC
Zeng, XT
PROCESSING AND FABRICATION OF ADVANCED MATERIALS VI, VOLS 1 & 2, 1998, : 1209 - 1218
[39] Deposition of Ti-Zr-O-N films by reactive magnetron sputtering of Zr target with Ti ribbons
da Silva Oliveira, C., I
Martinez-Martinez, D.
Cunha, L.
Lanceros-Mendez, S.
Martins, P.
Alves, E.
Barradas, N. P.
Apreutesei, M.
SURFACE & COATINGS TECHNOLOGY, 2021, 409
[40] Nanostructure transition in Cr-C-N coatings deposited by pulsed closed field unbalanced magnetron sputtering
Wu, Z. L.
Lin, J.
Moore, J. J.
Lei, M. K.
THIN SOLID FILMS, 2012, 520 (13) : 4264 - 4269

← 1 2 3 4 5 →