Rehabilitation of reinforced concrete slab-column connections

The paper presents work on punching shear rehabilitation and strengthening of existing slab-column connections. Four full-scale specimens representing slab-column edge connections were built and tested to failure. Three slabs were then repaired and strengthened and tested again. In the originally tested slabs, which were chosen for repair, one slab had an opening in front of the column and contained shear reinforcement, one slab had an opening and no shear reinforcement, and one had no opening and no reinforcement. The dimensions of the slabs were 1540 x 1020 x 120 mm with square columns (250 x 250 mm). The openings in the specimens were square (150 x 150 mm) with the sides parallel to the sides of the column. The slabs were made using normal weight concrete (28-day average compressive strength of 32 MPa) and reinforced with a reinforcement ratio of 0.75%. The slabs were repaired by replacing old-damaged concrete with new concrete of the same properties. Strengthening was carried out using shear studs for the two slabs, which originally did not have shear reinforcement. The rehabilitation increased the punching shear strength (by 26-41%) and the ductility of the connections. All repaired specimens failed in flexure.