Demonstration of a solar combi-system utilizing stable supercooling of sodium acetate trihydrate for heat storage

被引:26
|
作者
Englmair, Gerald [1 ,2 ]
Kong, Weiqiang [1 ]
Berg, Jakob Brinko [1 ]
Furbo, Simon [1 ]
Fan, Jianhua [1 ]
机构
[1] Tech Univ Denmark, Dept Civil Engn, Brovej 118, DK-2800 Lyngby, Denmark
[2] Univ Chinese Acad Sci, Sino Danish Ctr, 380 Huaibeizhuang, Beijing, Peoples R China
关键词
Solar heating system; System demonstration; Control strategy; Heat storage prototype; Phase change material; Stable supercooling; THERMAL-ENERGY STORAGE; PHASE-CHANGE MATERIALS; HOT-WATER TANK; ACTIVE-HOUSES; DRUM REACTOR; IMPROVEMENT; COMPOSITES; SOLIDIFICATION; SIMULATIONS; UNITS;
D O I
10.1016/j.applthermaleng.2019.114647
中图分类号
O414.1 [热力学];
学科分类号
摘要
Achieving a high fraction of solar heat in heat supply for domestic buildings would reduce the use of fossil fuels for heat generation and has been a goal for a long time. Combined short and long-term heat storage has been identified as one way of achieving solar fractions higher than 50 percent in heat supply for domestic buildings. To this end, a laboratory solar heating system was built with heat-pipe tubular collectors 22.4 m(2) in aperture and a heat-storage prototype consisting of a 735 L water tank and four PCM units each containing 200 kg sodium acetate trihydrate (SAT) composite. The SAT composite was utilized as sensible heat storage with the additional ability to release heat of fusion on demand. Operation was demonstrated with the space heating and hot water demand patterns of a standard-size Passive House in the Danish climate. A strategy was developed to control the system. Seven operation modes enabled combined charging of water tank and PCM units, heat transfer from PCM units to the water tank when heat was in demand, and the right timing of auxiliary heating. We present the controller settings identified and the heat transfer fluid flow rates applied. Sequences of water tank charging, and single and parallel PCM unit charging were used to match the collector power available and the heat transfer limitations of the stores. During the charging of PCM units, the flow temperature was kept between 70 and 95 degrees C to allow continuous heat transfer rates of up to 16 kW. Peaks of up to 36 kW occurred when PCM units were added to the charging circuit. During heat transfer from PCM units to the water tank, flow temperatures were close to the SAT composite temperature and thermal power of up to 6 kW was measured. The heat stores were efficiently utilized in spring and autumn. The developed control strategy and measurement data from system demonstration will form the basis for numerical performance investigations.
引用
收藏
页数:12
相关论文
共 50 条
  • [21] NUCLEATION OF SODIUM-ACETATE TRIHYDRATE IN THERMAL HEAT-STORAGE CYCLES
    GUION, J
    TEISSEIRE, M
    SOLAR ENERGY, 1991, 46 (02) : 97 - 100
  • [22] Ageing stability of sodium acetate trihydrate with and without additives for seasonal heat storage
    Kong, Weiqiang
    Dannemand, Mark
    Johansen, Jakob Berg
    Fan, Jianhua
    Dragsted, Janne
    Furbo, Simon
    PROCEEDINGS OF THE ISES SOLAR WORLD CONFERENCE 2015, 2015, : 1486 - 1495
  • [23] Visualization of the phase change behavior of sodium acetate trihydrate for latent heat storage
    Ouchi, Yasunori
    Someya, Satoshi
    Munakata, Tetsuo
    Ito, Hiroshi
    APPLIED THERMAL ENGINEERING, 2015, 91 : 547 - 555
  • [24] Study on solidification process of sodium acetate trihydrate for seasonal solar thermal energy storage
    Ma, Zhiwei
    Bao, Huashan
    Roskilly, Anthony Paul
    SOLAR ENERGY MATERIALS AND SOLAR CELLS, 2017, 172 : 99 - 107
  • [25] Development of new PCM using sodium acetate trihydrate and characteristic evaluation of capsule type heat storage system
    Kakiuchi, H
    Yabe, M
    Yamazaki, M
    Chihara, S
    Kubokawa, S
    KAGAKU KOGAKU RONBUNSHU, 2001, 27 (01) : 7 - 14
  • [26] HEAT-STORAGE CAPACITY OF SODIUM-ACETATE TRIHYDRATE DURING THERMAL CYCLING
    WADA, T
    YAMAMOTO, R
    MATSUO, Y
    SOLAR ENERGY, 1984, 33 (3-4) : 373 - 375
  • [27] Thermal characteristics of a long-term heat storage unit with sodium acetate trihydrate
    Wang, Gang
    Dannemand, Mark
    Xu, Chao
    Englmair, Gerald
    Furbo, Simon
    Fan, Jianhua
    APPLIED THERMAL ENGINEERING, 2021, 187
  • [28] Effect of Ultrasonic Irradiation on the Crystallization of Sodium Acetate Trihydrate Utilized as Heat Storage Material
    Seo, Kiwamu
    Suzuki, Shunpei
    Kinoshita, Takuya
    Hirasawa, Izumi
    CHEMICAL ENGINEERING & TECHNOLOGY, 2012, 35 (06) : 1013 - 1016
  • [29] Experimental investigation on the supercooling and heat conduction of sodium acetate trihydrate/copper foam/YSZ composite phase change material
    He, Yu
    Song, Yanlin
    Yuan, Yanping
    Yang, Li
    Zhang, Nan
    JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2021, 143 (04) : 3275 - 3284
  • [30] Experimental investigation on the supercooling and heat conduction of sodium acetate trihydrate/copper foam/YSZ composite phase change material
    Yu He
    Yanlin Song
    Yanping Yuan
    Li Yang
    Nan Zhang
    Journal of Thermal Analysis and Calorimetry, 2021, 143 : 3275 - 3284