Demonstration of a solar combi-system utilizing stable supercooling of sodium acetate trihydrate for heat storage

被引:26
|
作者
Englmair, Gerald [1 ,2 ]
Kong, Weiqiang [1 ]
Berg, Jakob Brinko [1 ]
Furbo, Simon [1 ]
Fan, Jianhua [1 ]
机构
[1] Tech Univ Denmark, Dept Civil Engn, Brovej 118, DK-2800 Lyngby, Denmark
[2] Univ Chinese Acad Sci, Sino Danish Ctr, 380 Huaibeizhuang, Beijing, Peoples R China
关键词
Solar heating system; System demonstration; Control strategy; Heat storage prototype; Phase change material; Stable supercooling; THERMAL-ENERGY STORAGE; PHASE-CHANGE MATERIALS; HOT-WATER TANK; ACTIVE-HOUSES; DRUM REACTOR; IMPROVEMENT; COMPOSITES; SOLIDIFICATION; SIMULATIONS; UNITS;
D O I
10.1016/j.applthermaleng.2019.114647
中图分类号
O414.1 [热力学];
学科分类号
摘要
Achieving a high fraction of solar heat in heat supply for domestic buildings would reduce the use of fossil fuels for heat generation and has been a goal for a long time. Combined short and long-term heat storage has been identified as one way of achieving solar fractions higher than 50 percent in heat supply for domestic buildings. To this end, a laboratory solar heating system was built with heat-pipe tubular collectors 22.4 m(2) in aperture and a heat-storage prototype consisting of a 735 L water tank and four PCM units each containing 200 kg sodium acetate trihydrate (SAT) composite. The SAT composite was utilized as sensible heat storage with the additional ability to release heat of fusion on demand. Operation was demonstrated with the space heating and hot water demand patterns of a standard-size Passive House in the Danish climate. A strategy was developed to control the system. Seven operation modes enabled combined charging of water tank and PCM units, heat transfer from PCM units to the water tank when heat was in demand, and the right timing of auxiliary heating. We present the controller settings identified and the heat transfer fluid flow rates applied. Sequences of water tank charging, and single and parallel PCM unit charging were used to match the collector power available and the heat transfer limitations of the stores. During the charging of PCM units, the flow temperature was kept between 70 and 95 degrees C to allow continuous heat transfer rates of up to 16 kW. Peaks of up to 36 kW occurred when PCM units were added to the charging circuit. During heat transfer from PCM units to the water tank, flow temperatures were close to the SAT composite temperature and thermal power of up to 6 kW was measured. The heat stores were efficiently utilized in spring and autumn. The developed control strategy and measurement data from system demonstration will form the basis for numerical performance investigations.
引用
收藏
页数:12
相关论文
共 50 条
  • [1] A solar combi-system utilizing stable supercooling of sodium acetate trihydrate for heat storage: Numerical performance investigation
    Englmair, Gerald
    Moser, Christoph
    Schranzhofer, Hermann
    Fan, Jianhua
    Furbo, Simon
    APPLIED ENERGY, 2019, 242 : 1108 - 1120
  • [2] Design and functionality of a segmented heat-storage prototype utilizing stable supercooling of sodium acetate trihydrate in a solar heating system
    Englmair, Gerald
    Moser, Christoph
    Furbo, Simon
    Dannemand, Mark
    Fan, Jianhua
    APPLIED ENERGY, 2018, 221 : 522 - 534
  • [3] Experimental investigations on prototype heat storage units utilizing stable supercooling of sodium acetate trihydrate mixtures
    Dannemand, Mark
    Dragsted, Janne
    Fan, Jianhua
    Johansen, Jakob Berg
    Kong, Weiqiang
    Furbo, Simon
    APPLIED ENERGY, 2016, 169 : 72 - 80
  • [4] Experimental investigation of a tank-in-tank heat storage unit utilizing stable supercooling of sodium acetate trihydrate
    Englmair, Gerald
    Furbo, Simon
    Dannemand, Mark
    Fan, Jianhua
    APPLIED THERMAL ENGINEERING, 2020, 167
  • [5] Laboratory test of a prototype heat storage module based on stable supercooling of sodium acetate trihydrate
    Dannemand, Mark
    Kong, Weiqiang
    Fan, Jianhua
    Johansen, Jakob Berg
    Furbo, Simon
    INTERNATIONAL CONFERENCE ON SOLAR HEATING AND COOLING FOR BUILDINGS AND INDUSTRY, SHC 2014, 2015, 70 : 172 - 181
  • [6] Experimental investigations on cylindrical latent heat storage units with sodium acetate trihydrate composites utilizing supercooling
    Dannemand, Mark
    Johansen, Jakob Berg
    Kong, Weiqiang
    Furbo, Simon
    APPLIED ENERGY, 2016, 177 : 591 - 601
  • [7] SUPERCOOLING STABILITY OF SODIUM ACETATE TRIHYDRATE COMPOSITES IN MULTIPLE HEAT STORAGE UNITS
    Dannemand, M.
    Furbo, S.
    12TH IIR/IIF INTERNATIONAL CONFERENCE ON PHASE-CHANGE MATERIALS AND SLURRIES FOR REFRIGERATION AND AIR CONDITIONING (PCM 2018), 2018, : 227 - 231
  • [8] Experimental investigations on stable supercooling performance of sodium acetate trihydrate PCM for thermal storage
    Zhou, Guobing
    Xiang, Yutong
    SOLAR ENERGY, 2017, 155 : 1261 - 1272
  • [9] Experimental investigations of multiple heat storage units utilizing supercooling of sodium acetate trihydrate: Stability in application size units
    Dannemand, Mark
    Englmair, Gerald
    Kong, Weiqiang
    Furbo, Simon
    JOURNAL OF ENERGY STORAGE, 2024, 86
  • [10] Development of seasonal heat storage based on stable supercooling of a sodium acetate water mixture
    Furbo, Simon
    Fan, Jianhua
    Andersen, Elsa
    Chen, Ziqian
    Perers, Bengt
    1ST INTERNATIONAL CONFERENCE ON SOLAR HEATING AND COOLING FOR BUILDINGS AND INDUSTRY (SHC 2012), 2012, 30 : 260 - 269