Residual stress in pearlitic steel rods during progressively cold drawing measured by X-ray diffraction

被引：15

作者：

Yang, F. ^{[1
]}

Jiang, J. Q. ^{[1
]}

Wang, Y. ^{[1
]}

Ma, C. ^{[1
]}

Fang, F. ^{[1
]}

Zhao, K. L. ^{[2
]}

Li, W. ^{[2
]}

机构：

[1] SE Univ, Coll Mat Sci & Engn, Nanjing 211189, Peoples R China

[2] Harbin Bearing Grp Co, Ctr Tech, Harbin 150036, Peoples R China

来源：

MATERIALS LETTERS | 2008年 / 62卷 / 16期

关键词：

pearlitic steels; cold drawing; residual stress; X-ray diffraction;

D O I：

10.1016/j.matlet.2007.11.054

中图分类号：

T [工业技术];

学科分类号：

08 ;

摘要：

This research aims to investigate the residual stress evolution in pearlitic steels during progressively cold drawing. To this end, pearlitic steel rods of 13 mm, diameter are continuously cold-drawn to wires of 5.3 mm, and then the residual stresses of multi-pass drawing rods are evaluated by X-ray diffraction technique. The XRD results indicate that the residual stresses of pearlitic steel rods increase gradually with the growing of drawing strain, from stress-free of original rod to high tensile stress of 650 MPa in the last pass drawing wire. (c) 2007 Elsevier B.V. All rights reserved.

引用

页码：2219 / 2221

页数：3

共 50 条

[1] Neutron and X-ray diffraction study of residual and internal stress evolution in pearlitic steel during cold drawing
Kriska, M.
Tacq, J.
Van Acker, K.
Seefeldt, M.
Van Petegem, S.
5TH EUROPEAN CONFERENCE ON NEUTRON SCATTERING, 2012, 340
[2] Neutron and X-ray diffraction analysis of residual stresses in cold-rolled pearlitic steel sheet
Seefeldt, Marc
Walentek, Artur
Van Houtte, Paul
Vrana, Miroslav
Lukas, Petr
RESIDUAL STRESSES VII, 2006, 524-525 : 375 - 380
[3] Effect of varying cold-drawing deformation on residual stresses measured by neutron diffraction in steel rods
Ruiz-Hervias, J.
Luzin, V.
Prask, H.
Gnaeupel-Herold, T.
Elices, M.
STRESS EVALUATION IN MATERIALS USING NEUTRONS AND SYNCHROTRON RADIATION, 2008, 571-572 : 51 - +
[4] Residual stress profiling in the ferrite and cementite phases of cold-drawn steel rods by synchrotron X-ray and neutron diffraction
Martinez-Perez, ML
Mompean, FJ
Ruiz-Hervias, J
Borlado, CR
Atienza, JM
Garcia-Hernandez, M
Elices, M
Gil-Sevillano, J
Peng, RL
Buslaps, T
ACTA MATERIALIA, 2004, 52 (18) : 5303 - 5313
[5] Influence of Local Electropolishing Conditions on Ferritic-Pearlitic Steel on X-Ray Diffraction Residual Stress Profiling
Holmberg, Jonas
Berglund, Johan
Stormvinter, Albin
Andersson, Par
Lundin, Per
JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2024, 33 (08) : 3682 - 3690
[6] EFFECTS OF SMALL DRAWING REDUCTIONS ON RESIDUAL SURFACE STRESSES IN THIN COLD-DRAWN STEEL WIRE, AS MEASURED BY X-RAY DIFFRACTION.
Willemse, P.F.
Naughton, B.P.
Materials Science and Technology, 1985, 1 (01): : 41 - 44
[7] Residual stress determination in cold drawn steel wire by FEM simulation and X-ray diffraction
He, S
Van Bael, A
Li, SY
Van Houtte, P
Mei, F
Sarban, A
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2003, 346 (1-2): : 101 - 107
[8] Residual stress determination in cold drawn steel wire by FEM simulation and X-ray diffraction
Van Houtte, P
He, S
Mei, F
Sarban, A
ECRS 6: PROCEEDINGS OF THE 6TH EUROPEAN CONFERENCE ON RESIDUAL STRESSES, 2002, 404-7 : 205 - 212
[9] Neutron and X-ray residual stress analysis of steel parts produced by cold forward extrusion and tube drawing
Genzel, C
Reimers, W
Malek, R
Pohlandt, K
MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 1996, 205 (1-2): : 79 - 90
[10] Neutron and x-ray residual stress analysis of steel parts produced by cold forward extrusion and tube drawing
Hahn-Meitner-Inst Berlin, Berlin, Germany
Mater Sci Eng A Struct Mater Prop Microstruct Process, 1-2 (79-90):

← 1 2 3 4 5 →