High temperature storage reliability investigation of the Al-Cu wire bond interface

被引：34

作者：

Pelzer, R. ^{[1
]}

Nelhiebel, M. ^{[1
,2
]}

Zink, R. ^{[1
]}

Woehlert, S. ^{[1
]}

Lassnig, A. ^{[3
]}

Khatibi, G. ^{[3
]}

机构：

[1] Infineon Technol Austria AG, A-9500 Villach, Austria

[2] KAI Competence Ctr Automot & Ind Elect, A-9524 Villach, Austria

[3] Univ Vienna, Fac Phys, A-1090 Vienna, Austria

来源：

MICROELECTRONICS RELIABILITY | 2012年 / 52卷 / 9-10期

关键词：

ALUMINUM; IMC;

D O I：

10.1016/j.microrel.2012.06.070

中图分类号：

TM [电工技术]; TN [电子技术、通信技术];

学科分类号：

0808 ; 0809 ;

摘要：

In this study the intermetallic compound (IMC) formation of annealed 50 mu m copper wires, thermosonically nailhead bonded to thick Al-0.5 wt.% Cu pads, was investigated. The annealing experimental matrix covered the full range of Al consumption. The IMC thickness (growth behavior), obtained from FIB cuts, follows an Arrhenius type equation. TEM was used to identify the three formed intermetallic phases - CuAl2, CuAl and Cu9Al4 - which were detected in several interface FIB cuts. The activation energy for the growth of the total IMC stack was found to be 1.26 eV. The impact on bond strength was studied using ball shear test. The test results did not show a significant decrease in interface strength across the full experimental matrix even Al being fully consumed. Special procedures were applied to improve pad surface condition and wire bonding process parameters to get parallel and homogeneous IMC layer growth, and therefore reliable data. (C) 2012 Elsevier Ltd. All rights reserved.

引用

页码：1966 / 1970

页数：5

共 50 条

[21] The Electrical Reliability of Silver Wire Bonds under High Temperature Storage
Mayer, Michael
Xu, Di Erick
Ratcliffe, Kieran
2016 IEEE 66TH ELECTRONIC COMPONENTS AND TECHNOLOGY CONFERENCE (ECTC), 2016, : 654 - 659
[22] Re-investigation of phase equilibria in the system Al-Cu and structural analysis of the high-temperature phase η1-Al1-δCu
Ponweiser, Norbert
Lengauer, Christian L.
Richter, Klaus W.
INTERMETALLICS, 2011, 19 (11) : 1737 - 1746
[23] Reliability of Cu wire bonding to Al metallization
England, Luke
Jiang, Tom
57TH ELECTRONIC COMPONENTS & TECHNOLOGY CONFERENCE, 2007 PROCEEDINGS, 2007, : 1604 - +
[24] Cu Wire Bonding: Reliability Improvement for High Temperature in Plastic Packages
Passagrilli, C.
Vitali, B.
Tiziani, R.
Azzopardi, C.
2009 EUROPEAN MICROELECTRONICS AND PACKAGING CONFERENCE (EMPC 2009), VOLS 1 AND 2, 2009, : 167 - +
[25] ULTRASONIC ATTENUATION IN AL AND AL-CU ALLOYS AT LOW TEMPERATURE
KAMIGAKI, K
HIRONE, T
JOURNAL OF THE PHYSICAL SOCIETY OF JAPAN, 1961, 16 (10) : 2077 - &
[26] HIGH-TEMPERATURE INTERNAL-FRICTION PEAKS IN AL-CU ALLOYS
KISS, S
MOLNAR, B
KEDVES, FJ
HARANGOZO, IZ
SCRIPTA METALLURGICA, 1977, 11 (03): : 165 - 167
[27] On the Evolution of Nano-Structures at the Al-Cu Interface and the Influence of Annealing Temperature on the Interfacial Strength
Wang, Xiaoli
Cheng, Guang
Zhang, Yang
Wang, Yuxin
Liao, Wenjun
Venkatesh, T. A.
NANOMATERIALS, 2022, 12 (20)
[28] Investigation of PECS current pass and temperature distribution on sintered Al-Cu eutectic alloy
KAWAKAMI Y.
SAKAMAKI T.
MISAWA T.
ENDO K.
KAWAHARA M.
Funtai Oyobi Fummatsu Yakin/Journal of the Japan Society of Powder and Powder Metallurgy, 2020, 67 (11): : 649 - 655
[29] Investigation of thermal properties of Al-Cu eutectic alloy for phase change energy storage applications
Manasijevic, Dragan
Balanovic, Ljubisa
Cimpoesu, Nicanor
Markovic, Ivana
Gorgievski, Milan
Stamenkovic, Uros
Stepanovic, Aleksandra
JOURNAL OF THERMAL ANALYSIS AND CALORIMETRY, 2025, 150 (01) : 77 - 85
[30] Effects of Reliability Testing Methods on Microstructure and Strength At the Cu Wire-Al Pad Interface
Su, Peng
Seki, Hidetoshi
Ping, Chen
Itoh, Shingo
Huang, Louie
Liao, Nicholas
Liu, Bill
Chen, Curtis
Tai, Winnie
Tseng, Andy
2013 IEEE 63RD ELECTRONIC COMPONENTS AND TECHNOLOGY CONFERENCE (ECTC), 2013, : 179 - 185

← 1 2 3 4 5 →