Three dimensional optimization of small-scale axial turbine for low temperature heat source driven organic Rankine cycle

被引:37
|
作者
Al Jubori, Ayad [1 ,2 ]
Al-Dadah, Raya K. [1 ]
Mahmoud, Saad [1 ]
Ennil, A. S. Bahr [1 ]
Rahbar, Kiyarash [1 ]
机构
[1] Univ Birmingham, Sch Engn, Dept Mech Engn, Birmingham B15 2TT, W Midlands, England
[2] Univ Technol Baghdad, Baghdad, Iraq
关键词
Small-scale axial turbine; ORC; Mean-line design; CFD; 3D optimization; Multi-objective genetic algorithm; MULTIOBJECTIVE OPTIMIZATION; WORKING FLUIDS; OPTIMUM DESIGN; ORC; EXPANDERS; MIXTURES;
D O I
10.1016/j.enconman.2016.10.060
中图分类号
O414.1 [热力学];
学科分类号
摘要
Advances in optimization techniques can be used to enhance the performance of turbines in various applications. However, limited work has been reported on using such optimization techniques to develop small-scale turbines for organic Rankine cycles. This paper investigates the use of multi-objective genetic algorithm to optimize the stage geometry of a small-axial subsonic turbine. This optimization is integrated with organic Rankine cycle analysis using wide range of high density organic working fluids like R123, R134a, R141b, R152a, R245fa and isobutane suitable for low temperature heat sources <100 degrees C such as solar energy to achieve the best turbine design and highest organic Rankine cycle efficiency. The isentropic efficiency of the turbine in most of the reported organic Rankine cycle studies was assumed constant, while the current work allows the turbine isentropic efficiency to change (dynamic value) with both operating conditions and working fluids. Three-dimensional computational fluid dynamics analysis and multi-objective genetic algorithm optimization were performed using three-dimensional Reynolds-averaged Navier-Stokes equations with k-omega shear stress transport turbulence model in ANSYS(R17)-CFX and design exploration for various working fluids. The optimization was carried out using eight design paraMeters for the turbine stage geometry optimization including stator and rotor number of blades, rotor leading edge beta angle, trailing edge beta angle, stagger angle, throat width, trailing half wedge angle and shroud tip clearance. Results showed that using working fluid R123 for a turbine with mean diameter of 70 mm, the maximum isentropic efficiency was about 88% and power output of 6.3 kW leading to cycle thermal efficiency of 10.5% showing an enhancement of 14.08% compared to the baseline design. Such results highlight the potential of the 3D optimization technique to improve the organic Rankine cycle performance. (C) 2016 Elsevier Ltd. All rights reserved.
引用
收藏
页码:411 / 426
页数:16
相关论文
共 50 条
  • [31] Analysis of a novel gravity driven organic Rankine cycle for small-scale cogeneration applications
    Li, Jing
    Pei, Gang
    Li, Yunzhu
    Ji, Jie
    APPLIED ENERGY, 2013, 108 : 34 - 44
  • [32] Numerical Investigation on the Performance of a Regenerative Flow Turbine for Small-Scale Organic Rankine Cycle Systems
    Moradi, Ramin
    Cioccolanti, Luca
    Bocci, Enrico
    Villarini, Mauro
    Renzi, Massimiliano
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2019, 141 (09):
  • [33] Numerical predicting the dynamic behavior of heat exchangers for a small-scale Organic Rankine Cycle
    Liu, Liuchen
    Pan, Yu
    Zhu, Tong
    Gao, Naiping
    4TH INTERNATIONAL SEMINAR ON ORC POWER SYSTEMS, 2017, 129 : 419 - 426
  • [34] Parameter Optimization of the Subcritical Organic Rankine Cycle System Coupled With Low-Temperature Heat Source
    Zhang, Chao
    Fu, Jing-Lun
    Fu, Wen-Cheng
    Wang, Zhi-Gang
    Kung Cheng Je Wu Li Hsueh Pao/Journal of Engineering Thermophysics, 2017, 38 (09): : 1837 - 1843
  • [35] Thermodynamic optimization and fluid selection of organic Rankine cycle driven by a latent heat source
    Xu Peng
    Lu Jian
    Li Tai-lu
    Zhu Jia-ling
    JOURNAL OF CENTRAL SOUTH UNIVERSITY, 2017, 24 (12) : 2829 - 2841
  • [36] Thermodynamic optimization and fluid selection of organic Rankine cycle driven by a latent heat source
    徐鹏
    吕建
    李太禄
    朱家玲
    JournalofCentralSouthUniversity, 2017, 24 (12) : 2829 - 2841
  • [37] Thermodynamic optimization and fluid selection of organic Rankine cycle driven by a latent heat source
    Peng Xu
    Jian Lu
    Tai-lu Li
    Jia-ling Zhu
    Journal of Central South University, 2017, 24 : 2829 - 2841
  • [38] REVIEW OF EXPANDER SELECTION FOR SMALL-SCALE ORGANIC RANKINE CYCLE
    Saghlatoun, Saeedeh
    Zhuge, Weilin
    Zhang, Yangjun
    PROCEEDINGS OF THE ASME FLUIDS ENGINEERING DIVISION SUMMER MEETING - 2014, VOL 1B: SYMPOSIA, 2014,
  • [39] Construction and dynamic test of a small-scale organic rankine cycle
    Pei, Gang
    Li, Jing
    Li, Yunzhu
    Wang, Dongyue
    Ji, Jie
    ENERGY, 2011, 36 (05) : 3215 - 3223
  • [40] Thermo-economic optimization of small-scale Organic Rankine Cycle: A case study for low-grade industrial waste heat recovery
    Peris, Bernardo
    Navarro-Esbri, Joaquin
    Mateu-Royo, Carlos
    Mota-Babiloni, Adrian
    Moles, Francisco
    Gutierrez-Trashorras, Antonio J.
    Amat-Albuixech, Marta
    ENERGY, 2020, 213