The power of glove: Soft microbial fuel cell for low-power electronics

被引:40
|
作者
Winfield, Jonathan [1 ]
Chambers, Lily D. [2 ]
Stinchcombe, Andrew [1 ]
Rossiter, Jonathan [3 ]
Ieropoulos, Ioannis [1 ]
机构
[1] Univ W England, Bristol Robot Lab, Bristol BS34 8QZ, Avon, England
[2] Univ Bristol, Bristol Robot Lab, Bristol BS34 8QZ, Avon, England
[3] Univ Bristol, Dept Engn Math, Bristol BS8 1TR, Avon, England
基金
英国工程与自然科学研究理事会; 比尔及梅琳达.盖茨基金会;
关键词
Microbial fuel cell; Natural rubber; Power management system; Urine; Conductive latex; Energy harvesting; ELECTRICITY-GENERATION;
D O I
10.1016/j.jpowsour.2013.10.096
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
A novel, soft microbial fuel cell (MFC) has been constructed using the finger-piece of a standard laboratory natural rubber latex glove. The natural rubber serves as structural and proton exchange material whilst untreated carbon veil is used for the anode. A soft, conductive, synthetic latex cathode is developed that coats the outside of the glove. This inexpensive, lightweight reactor can without any external power supply, start up and energise a power management system (PMS), which steps-up the MFC output (0.06-0.17 V) to practical levels for operating electronic devices (>3 V). The MFC is able to operate for up to 4 days on just 2 mL of feedstock (synthetic tryptone yeast extract) without any cathode hydration. The MFC responds immediately to changes in fuel-type when the introduction of urine accelerates the cycling times (35 vs. 50 min for charge/discharge) of the MFC and PMS. Following starvation periods of up to 60 h at 0 mV the MFC is able to cold start the PMS simply with the addition of 2 mL fresh feedstock. These findings demonstrate that cheap MFCs can be developed as sole power sources and in conjunction with advancements in ultra-low power electronics, can practically operate small electrical devices. (C) 2013 Elsevier B.V. All rights reserved.
引用
收藏
页码:327 / 332
页数:6
相关论文
共 50 条
  • [31] Low-Power Electronics in Energy Harvesting Autonomous Systems
    Maurath, Dominic
    Peters, Christian
    Hehn, Thorsten
    Lotze, Niklas
    Mohamed, Sherif A.
    Manoli, Yiannos
    TM-TECHNISCHES MESSEN, 2009, 76 (12) : 560 - 567
  • [32] Low-Power Fuel Delivery With Concentration Regulation for Micro Direct Methanol Fuel Cell
    Yang, Yuming
    Liang, Yung C.
    Yao, Kui
    Ong, Choon Kiat
    IEEE TRANSACTIONS ON INDUSTRY APPLICATIONS, 2011, 47 (03) : 1470 - 1479
  • [33] Soft errors issues in low-power caches
    Degalahal, V
    Li, L
    Narayanan, V
    Kandemir, M
    Irwin, MJ
    IEEE TRANSACTIONS ON VERY LARGE SCALE INTEGRATION (VLSI) SYSTEMS, 2005, 13 (10) : 1157 - 1166
  • [34] Low-Power Soft Error Hardened Latch
    Alidash, Hossein Karimiyan
    Oklobdzija, Vojin G.
    INTEGRATED CIRCUIT AND SYSTEM DESIGN: POWER AND TIMING MODELING, OPTIMIZATION AND SIMULATION, 2010, 5953 : 256 - +
  • [35] Low-Power Soft Error Hardened Latch
    Alidash, Hossein Karimiyan
    Oklobdzija, Vojin G.
    JOURNAL OF LOW POWER ELECTRONICS, 2010, 6 (01) : 218 - 226
  • [36] FUEL PIN COOLABILITY IN LOW-POWER VOIDING
    DUNN, FE
    TRANSACTIONS OF THE AMERICAN NUCLEAR SOCIETY, 1978, 28 (JUN): : 430 - 431
  • [37] Low-Power Testing for Low-Power Devices
    Wen, Xiaoqing
    2010 IEEE 25TH INTERNATIONAL SYMPOSIUM ON DEFECT AND FAULT TOLERANCE IN VLSI SYSTEMS (DFT 2010), 2010, : 261 - 261
  • [38] Low-power filtering via minimum power soft error cancellation
    Choi, Jun Won
    Shim, Byonghyo
    Singer, Andrew C.
    Cho, Nam Ik
    IEEE TRANSACTIONS ON SIGNAL PROCESSING, 2007, 55 (10) : 5084 - 5096
  • [39] Low Power Electrical Generator from Soil Microbial Fuel Cell
    Mulyadi
    Arsianti, Rika Wahyuni
    2018 ELECTRICAL POWER, ELECTRONICS, COMMUNICATIONS, CONTROLS, AND INFORMATICS SEMINAR (EECCIS), 2018, : 85 - 89
  • [40] LOW-POWER LOW-NOISE MONOLITHIC DETECTOR READOUT ELECTRONICS
    BUTTLER, W
    HOSTICKA, BJ
    LUTZ, G
    ZIMMER, G
    NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION A-ACCELERATORS SPECTROMETERS DETECTORS AND ASSOCIATED EQUIPMENT, 1987, 253 (03): : 439 - 443