The power of glove: Soft microbial fuel cell for low-power electronics

被引:40
|
作者
Winfield, Jonathan [1 ]
Chambers, Lily D. [2 ]
Stinchcombe, Andrew [1 ]
Rossiter, Jonathan [3 ]
Ieropoulos, Ioannis [1 ]
机构
[1] Univ W England, Bristol Robot Lab, Bristol BS34 8QZ, Avon, England
[2] Univ Bristol, Bristol Robot Lab, Bristol BS34 8QZ, Avon, England
[3] Univ Bristol, Dept Engn Math, Bristol BS8 1TR, Avon, England
基金
英国工程与自然科学研究理事会; 比尔及梅琳达.盖茨基金会;
关键词
Microbial fuel cell; Natural rubber; Power management system; Urine; Conductive latex; Energy harvesting; ELECTRICITY-GENERATION;
D O I
10.1016/j.jpowsour.2013.10.096
中图分类号
O64 [物理化学(理论化学)、化学物理学];
学科分类号
070304 ; 081704 ;
摘要
A novel, soft microbial fuel cell (MFC) has been constructed using the finger-piece of a standard laboratory natural rubber latex glove. The natural rubber serves as structural and proton exchange material whilst untreated carbon veil is used for the anode. A soft, conductive, synthetic latex cathode is developed that coats the outside of the glove. This inexpensive, lightweight reactor can without any external power supply, start up and energise a power management system (PMS), which steps-up the MFC output (0.06-0.17 V) to practical levels for operating electronic devices (>3 V). The MFC is able to operate for up to 4 days on just 2 mL of feedstock (synthetic tryptone yeast extract) without any cathode hydration. The MFC responds immediately to changes in fuel-type when the introduction of urine accelerates the cycling times (35 vs. 50 min for charge/discharge) of the MFC and PMS. Following starvation periods of up to 60 h at 0 mV the MFC is able to cold start the PMS simply with the addition of 2 mL fresh feedstock. These findings demonstrate that cheap MFCs can be developed as sole power sources and in conjunction with advancements in ultra-low power electronics, can practically operate small electrical devices. (C) 2013 Elsevier B.V. All rights reserved.
引用
收藏
页码:327 / 332
页数:6
相关论文
共 50 条
  • [11] Demands are high for low-power electronics
    Saini, Angela
    MRS BULLETIN, 2015, 40 (07) : 556 - 557
  • [12] Energy harvesting with low-power electronics
    Jannson, Tomasz
    Forrester, Thomas
    Degrood, Kevin
    Gans, Eric
    Lee, Kang
    Nguyen, Kathy
    Walter, Kevin
    Kostrzewski, Andrew
    SENSORS, AND COMMAND, CONTROL, COMMUNICATIONS, AND INTELLIGENCE (C3I) TECHNOLOGIES FOR HOMELAND SECURITY AND HOMELAND DEFENSE IX, 2010, 7666
  • [13] Demands are high for low-power electronics
    Angela Saini
    MRS Bulletin, 2015, 40 : 556 - 557
  • [14] SPECIAL ISSUE ON LOW-POWER ELECTRONICS
    TERMAN, LM
    YAN, RH
    PROCEEDINGS OF THE IEEE, 1995, 83 (04) : 495 - 497
  • [15] Energy harvesting technologies for low-power electronics
    Alvarado, U.
    Juanicorena, A.
    Adin, I.
    Sedano, B.
    Gutierrez, I.
    No, J.
    TRANSACTIONS ON EMERGING TELECOMMUNICATIONS TECHNOLOGIES, 2012, 23 (08): : 728 - 741
  • [16] Special section on low-power electronics and design
    Chandrakasan, A
    Sha, EHM
    IEEE TRANSACTIONS ON VERY LARGE SCALE INTEGRATION (VLSI) SYSTEMS, 1998, 6 (04) : 518 - 519
  • [17] SPECIAL ISSUE ON LOW-POWER ELECTRONICS - FOREWORD
    ISHIGURO, T
    NEC RESEARCH & DEVELOPMENT, 1995, 36 (01): : R1 - R1
  • [18] LOW-POWER ELECTRONICS TAKES TOP PRIORITY
    STORK, H
    IEEE CIRCUITS AND DEVICES MAGAZINE, 1994, 10 (03): : 51 - &
  • [19] Recyclable, Flexible, Low-Power Oxide Electronics
    Martins, Rodrigo F. P.
    Ahnood, Arman
    Correia, Nuno
    Pereira, Luis M. N. P.
    Barros, Raquel
    Barquinha, Pedro M. C. B.
    Costa, Ricardo
    Ferreira, Isabel M. M.
    Nathan, Arokia
    Fortunato, Elvira E. M. C.
    ADVANCED FUNCTIONAL MATERIALS, 2013, 23 (17) : 2153 - 2161
  • [20] Guest editorial: Low-power electronics and design
    Mach, E
    Verbauwhede, I
    IEEE TRANSACTIONS ON VERY LARGE SCALE INTEGRATION (VLSI) SYSTEMS, 2002, 10 (02) : 69 - 70