A detailed multidimensional simulation for the cold start process of a gasoline direct injection engine using a fractal engine simulation model

被引:0
|
作者
Li, Delong [1 ]
Hu, Jinghu [1 ]
Hall, Matthew [1 ]
Matthews, Ron [1 ]
机构
[1] Univ Texas Austin, Walker Dept Mech Engn, 204 E Dean Keeton St C2200, Austin, TX 78712 USA
关键词
Fractal engine simulation (FES) model; gasoline direct injection (GDI) engine; cold start; cylinder-to-cylinder differences; improved strategy; COMBUSTION;
D O I
10.1177/14680874231191589
中图分类号
O414.1 [热力学];
学科分类号
摘要
The cold start process for a gasoline direct injection (GDI) engine was studied through multidimensional simulations using a Fractal Engine Simulation (FES) model integrated into CONVERGE CFD. The simulations were focused on the very first firing cycle in the cold start process, as most of the hydrocarbon emissions derive from this cycle. The dramatically changing engine speed and low wall temperatures in the cylinder present challenges for simulation. It turned out that the FES model was able to predict the in-cylinder pressure traces for all four cylinders for the first firing cycle, and gave good agreement with the experimental measurements under these extremely transient conditions. More comprehensive analysis demonstrated the causes for the different behavior of the combustion in different cylinders: more injected fuel and a higher induced tumble ratio in cylinder 3, the first to fire, led to a higher average equivalence ratio and better fuel distribution, which resulted in the highest peak pressure; the worse fuel distribution from the lower tumble ratio, together with the lower normalized turbulence, caused weaker combustion in cylinder 4; the peak pressures were similar and on the low side for cylinders 2 and 1, mainly determined by the low average equivalence ratio. An improved strategy with multiple injections was proposed, with the first two in the intake stroke and two later injections in the compression stroke rather than one injection during each stroke. Although the total injected fuel was the same as the baseline strategy, more fuel evaporated due to the enhanced fuel evaporation from both droplets and wall films, resulting in a higher average equivalence ratio in the cylinder. The peak cylinder pressure and IMEP rose by 33.3% and 8.4%, respectively, using the 4-injection strategy compared to the baseline 2-injection strategy, and the 4-injection strategy was verified by the experiments, as well.
引用
收藏
页码:111 / 124
页数:14
相关论文
共 50 条
  • [31] Simulation of direct injection diesel engine combustion and emission
    Liu, S.
    Hu, J.
    Zhou, L.
    Jiang, D.
    Pan, K.
    Hsi-An Chiao Tung Ta Hsueh/Journal of Xi'an Jiaotong University, 2001, 35 (07): : 666 - 669
  • [32] Numerical simulation on combustion process of a hydrogen direct-injection stratified gasoline Wankel engine by synchronous and asynchronous ignition modes
    Shi, Cheng
    Ji, Changwei
    Wang, Shuofeng
    Yang, Jinxin
    Li, Xueyi
    Ge, Yunshan
    ENERGY CONVERSION AND MANAGEMENT, 2019, 183 : 14 - 25
  • [33] Simulation of a single cylinder diesel engine under cold start conditions using Simulink
    Liu, HQ
    Chalhoub, NG
    Henein, N
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2001, 123 (01): : 117 - 124
  • [34] Effects of using vortex tubes on events during cold start of a direct injection diesel engine
    Celik, Adem
    Ceviz, Mehmet Akif
    Yilmaz, Mehmet
    Oner, Ilhan Volkan
    Karagoz, Sendogan
    JOURNAL OF RENEWABLE AND SUSTAINABLE ENERGY, 2013, 5 (02)
  • [35] Research on simulation model of gasoline engine based on torque control
    He Shiquan
    Du aimin
    PROCEEDINGS OF THE 2006 IEEE INTERNATIONAL CONFERENCE ON VEHICULAR ELECTRONICS AND SAFETY, 2006, : 394 - +
  • [36] Combustion Model for a Homogeneous Turbocharged Gasoline Direct-Injection Engine
    Tolou, Sedigheh
    Vedula, Ravi Teja
    Schock, Harold
    Zhu, Guoming
    Sun, Yong
    Kotrba, Adam
    JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER-TRANSACTIONS OF THE ASME, 2018, 140 (10):
  • [37] COMBUSTION MODEL FOR A HOMOGENEOUS TURBOCHARGED GASOLINE DIRECT-INJECTION ENGINE
    Tolou, Sedigheh
    Vedula, Ravi Teja
    Schock, Harold
    Zhu, Guoming
    Sun, Young
    Kotrba, Adam
    PROCEEDINGS OF THE ASME INTERNAL COMBUSTION ENGINE FALL TECHNICAL CONFERENCE, 2017, VOL 2, 2017,
  • [38] Large eddy simulation of combustion process in a boosted and downsized gasoline engine
    Wang, Fang
    Wang, Zhi
    Shuai, Shi-Jin
    Wang, Jian-Xin
    Neiranji Xuebao/Transactions of CSICE (Chinese Society for Internal Combustion Engines), 2013, 31 (04): : 331 - 336
  • [39] Transient simulation of working process for four-valve gasoline engine
    Du A.
    Wu J.
    Duan L.
    Tongji Daxue Xuebao/Journal of Tongji University, 2010, 38 (07): : 1074 - 1078
  • [40] Sharpness simulation and optimization of a direct injection diesel engine noise
    Mao, J.
    Wang, X.
    Hao, Z. Y.
    Zheng, X.
    Jing, G. X.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE, 2014, 228 (16) : 2915 - 2924