A detailed multidimensional simulation for the cold start process of a gasoline direct injection engine using a fractal engine simulation model

被引:0
|
作者
Li, Delong [1 ]
Hu, Jinghu [1 ]
Hall, Matthew [1 ]
Matthews, Ron [1 ]
机构
[1] Univ Texas Austin, Walker Dept Mech Engn, 204 E Dean Keeton St C2200, Austin, TX 78712 USA
关键词
Fractal engine simulation (FES) model; gasoline direct injection (GDI) engine; cold start; cylinder-to-cylinder differences; improved strategy; COMBUSTION;
D O I
10.1177/14680874231191589
中图分类号
O414.1 [热力学];
学科分类号
摘要
The cold start process for a gasoline direct injection (GDI) engine was studied through multidimensional simulations using a Fractal Engine Simulation (FES) model integrated into CONVERGE CFD. The simulations were focused on the very first firing cycle in the cold start process, as most of the hydrocarbon emissions derive from this cycle. The dramatically changing engine speed and low wall temperatures in the cylinder present challenges for simulation. It turned out that the FES model was able to predict the in-cylinder pressure traces for all four cylinders for the first firing cycle, and gave good agreement with the experimental measurements under these extremely transient conditions. More comprehensive analysis demonstrated the causes for the different behavior of the combustion in different cylinders: more injected fuel and a higher induced tumble ratio in cylinder 3, the first to fire, led to a higher average equivalence ratio and better fuel distribution, which resulted in the highest peak pressure; the worse fuel distribution from the lower tumble ratio, together with the lower normalized turbulence, caused weaker combustion in cylinder 4; the peak pressures were similar and on the low side for cylinders 2 and 1, mainly determined by the low average equivalence ratio. An improved strategy with multiple injections was proposed, with the first two in the intake stroke and two later injections in the compression stroke rather than one injection during each stroke. Although the total injected fuel was the same as the baseline strategy, more fuel evaporated due to the enhanced fuel evaporation from both droplets and wall films, resulting in a higher average equivalence ratio in the cylinder. The peak cylinder pressure and IMEP rose by 33.3% and 8.4%, respectively, using the 4-injection strategy compared to the baseline 2-injection strategy, and the 4-injection strategy was verified by the experiments, as well.
引用
收藏
页码:111 / 124
页数:14
相关论文
共 50 条
  • [21] A Simulation Study of Water Injection Position and Pressure on the Knock, Combustion, and Emissions of a Direct Injection Gasoline Engine
    Li, Aqian
    Zheng, Zhaolei
    Song, Yukun
    ACS OMEGA, 2021, 6 (28): : 18033 - 18053
  • [22] A parametric study to improve first firing cycle emissions of a gasoline direct injection engine during cold start
    Hu, Jinghu
    Li, Delong
    Hall, Matthew
    Matthews, Ron
    Moilanen, Peter
    Wooldridge, Steven
    Yi, Jianwen
    INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2023, 24 (08) : 3428 - 3444
  • [23] Modelling soot formation from wall films in a gasoline direct injection engine using a detailed population balance model
    Wang, Buyu
    Mosbach, Sebastian
    Schmutzhard, Sebastian
    Shuai, Shijin
    Huang, Yaqing
    Kraft, Markus
    APPLIED ENERGY, 2016, 163 : 154 - 166
  • [24] Three-dimensional numerical simulation of spray, mixed gas formation and combustion process for gasoline direct injection engine
    Bai, Yun-Long
    Wang, Zhi
    Shuai, Shi-Jin
    Wang, Jian-Xin
    Ranshao Kexue Yu Jishu/Journal of Combustion Science and Technology, 2010, 16 (02): : 97 - 103
  • [25] Simulation Study of Super Knock in Turbocharged Direct Injection Engine with Ethanol-Gasoline Blends
    Xu B.
    Li R.
    Qi Y.
    Qi A.
    1600, Chinese Society for Internal Combustion Engines (38): : 312 - 319
  • [26] Numerical Simulation Study on the Effect of Port Water Injector Position on the Gasoline Direct Injection Engine
    Zhang, Zhongjie
    Dai, Xuejiao
    Zheng, Zhaolei
    PROCESSES, 2022, 10 (10)
  • [27] CFD simulation of stratified combustion process in a direct injection spark ignition engine
    Miyagawa, H
    Nomura, Y
    Koike, M
    Tomoda, T
    JSME INTERNATIONAL JOURNAL SERIES B-FLUIDS AND THERMAL ENGINEERING, 2003, 46 (02) : 332 - 339
  • [28] Research on Simulation Calculation of Gasoline Mixing Process in GDI Engine
    Li Xuejun
    Zhang Liying
    Xu Ting
    2018 CHINESE AUTOMATION CONGRESS (CAC), 2018, : 1258 - 1262
  • [29] Simulation of Scavenging Process in a Two-Stroke Gasoline Engine
    Li, Changyuan
    Tang, Dong
    Li, Nan
    ADVANCES IN POWER AND ELECTRICAL ENGINEERING, PTS 1 AND 2, 2013, 614-615 : 376 - +
  • [30] Detailed multi-zone thermodynamic simulation for direct-injection diesel engine combustion
    Xue, Xingyu
    Caton, Jerald A.
    INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2012, 13 (04) : 340 - 356