A detailed multidimensional simulation for the cold start process of a gasoline direct injection engine using a fractal engine simulation model

被引:0
|
作者
Li, Delong [1 ]
Hu, Jinghu [1 ]
Hall, Matthew [1 ]
Matthews, Ron [1 ]
机构
[1] Univ Texas Austin, Walker Dept Mech Engn, 204 E Dean Keeton St C2200, Austin, TX 78712 USA
关键词
Fractal engine simulation (FES) model; gasoline direct injection (GDI) engine; cold start; cylinder-to-cylinder differences; improved strategy; COMBUSTION;
D O I
10.1177/14680874231191589
中图分类号
O414.1 [热力学];
学科分类号
摘要
The cold start process for a gasoline direct injection (GDI) engine was studied through multidimensional simulations using a Fractal Engine Simulation (FES) model integrated into CONVERGE CFD. The simulations were focused on the very first firing cycle in the cold start process, as most of the hydrocarbon emissions derive from this cycle. The dramatically changing engine speed and low wall temperatures in the cylinder present challenges for simulation. It turned out that the FES model was able to predict the in-cylinder pressure traces for all four cylinders for the first firing cycle, and gave good agreement with the experimental measurements under these extremely transient conditions. More comprehensive analysis demonstrated the causes for the different behavior of the combustion in different cylinders: more injected fuel and a higher induced tumble ratio in cylinder 3, the first to fire, led to a higher average equivalence ratio and better fuel distribution, which resulted in the highest peak pressure; the worse fuel distribution from the lower tumble ratio, together with the lower normalized turbulence, caused weaker combustion in cylinder 4; the peak pressures were similar and on the low side for cylinders 2 and 1, mainly determined by the low average equivalence ratio. An improved strategy with multiple injections was proposed, with the first two in the intake stroke and two later injections in the compression stroke rather than one injection during each stroke. Although the total injected fuel was the same as the baseline strategy, more fuel evaporated due to the enhanced fuel evaporation from both droplets and wall films, resulting in a higher average equivalence ratio in the cylinder. The peak cylinder pressure and IMEP rose by 33.3% and 8.4%, respectively, using the 4-injection strategy compared to the baseline 2-injection strategy, and the 4-injection strategy was verified by the experiments, as well.
引用
收藏
页码:111 / 124
页数:14
相关论文
共 50 条
  • [1] Development of a fractal engine simulation model in a multidimensional simulation for the cold start process of a gasoline direct injection engine
    Li, Delong
    Hu, Jinghu
    Hall, Matthew
    Matthews, Ron
    INTERNATIONAL JOURNAL OF ENGINE RESEARCH, 2023, 24 (09) : 3830 - 3849
  • [2] Simulation of mixture formation in cylinder for gasoline direct injection engine at cold idle
    Zhu, Hang
    Liu, Guo-Qing
    Yang, Jun-Wei
    Liu, Yi-Ke
    Zhu, Hang, 1600, Chinese Society for Internal Combustion Engines (35): : 69 - 76
  • [3] APPLICATION OF HYPERBOLIC TANGENT APPROXIMATION MODEL TO GASOLINE DIRECT INJECTION ENGINE SIMULATION
    Hosaka, Tomoyuki
    Sugii, Taisuke
    Ishii, Eiji
    Oryoji, Kazuhiro
    Sukegawa, Yoshihiro
    PROCEEDINGS OF THE ASME INTERNAL COMBUSTION ENGINE FALL TECHNICAL CONFERENCE, 2017, VOL 2, 2017,
  • [4] Numerical Simulation on Spray Characteristics in Direct Injection Gasoline Engine
    Li, Shuhua
    Gao, Ying
    Li, Jun
    Yang, Shichun
    2011 ASIA-PACIFIC POWER AND ENERGY ENGINEERING CONFERENCE (APPEEC), 2011,
  • [5] 3-D Numerical Simulation on the Working Process of a Gasoline Direct Injection Engine
    Feng Li-yan
    Zhang Chun-huan
    Tian Jiang-ping
    Long Wu-qiang
    Li Jun
    Li Jin-cheng
    Gong Yan-feng
    25TH WORLD BATTERY, HYBRID AND FUEL CELL ELECTRIC VEHICLE SYMPOSIUM AND EXHIBITION PROCEEDINGS, VOLS 1 & 2, 2010, : 1172 - 1176
  • [6] COLD-START CFD SIMULATION OF SPARK-IGNITION DIRECT-INJECTION ENGINE
    Yang, Xiaofeng
    Kuo, Tang-Wei
    Singh, Kulwinder
    Hattar, Rafat
    Zeng, Yangbing
    PROCEEDINGS OF THE ASME INTERNAL COMBUSTION ENGINE FALL TECHNICAL CONFERENCE, 2017, VOL 2, 2017,
  • [7] Effects of Fuel Injection and Ignition on the Direct-Start Process of a Gasoline Direct Injection (GDI) Engine
    Chen, Tao
    Du, Zhengyu
    Liu, Zihan
    Xiao, Maoyu
    Zhang, Zhe
    Shi, Lei
    FDMP-FLUID DYNAMICS & MATERIALS PROCESSING, 2025, 21 (02): : 405 - 426
  • [8] Effect of injection strategy on quick start of gasoline direct injection engine
    Du, Aimin
    Li, Mengmeng
    Li, Junhui
    Yin, Jianmin
    Tongji Daxue Xuebao/Journal of Tongji University, 2014, 42 (05): : 762 - 768
  • [9] Direct start of a gasoline direct-injection engine without a starter
    Xie, Fangxi
    Hong, Wei
    Su, Yan
    Wang, Qingnian
    Zhu, Hang
    Gu, Chunshan
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART D-JOURNAL OF AUTOMOBILE ENGINEERING, 2016, 230 (04) : 491 - 502
  • [10] Study on warm start mode of gasoline direct injection engine
    Han, Li-Wei
    Gao, Ding-Wei
    Yang, Shi-Chun
    Wang, Chong
    Li, Bing-Nan
    Neiranji Gongcheng/Chinese Internal Combustion Engine Engineering, 2015, 36 (02): : 45 - 49