Effects of alumina addition on electrical properties of alumina-toughened zirconia for application in low- and intermediate-temperature solid oxide fuel cells

被引:1
|
作者
Lubszczyk, Marta [1 ]
Grabowy, Marek [2 ,3 ]
Wojteczko, Agnieszka [1 ]
Komarek, Sebastian [1 ]
Brylewski, Tomasz [1 ]
Pedzich, Zbigniew [1 ]
机构
[1] AGH Univ Krakow, Fac Mat Sci & Ceram, 30 Mickiewicza Ave, PL-30059 Krakow, Poland
[2] IEN Inst Power Engn, 8 Mory St, PL-01330 Warsaw, Poland
[3] Ceram Branch CEREL, 1 TechSt, PL-36040 Boguchwala, Poland
关键词
Alumina-toughened zirconia; Composites; Impedance spectroscopy; Solid oxide fuel cells; Tetragonal zirconia; Ionic conductivity; GRAIN-BOUNDARY RESISTIVITY; SPACE-CHARGE; MECHANICAL-PROPERTIES; IONIC-CONDUCTIVITY; DEFECT STRUCTURE; BLOCKING; AL2O3; MICROSTRUCTURE; COMPOSITES; IMPEDANCE;
D O I
10.1016/j.ceramint.2023.12.241
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
One of the priorities in the field of hydrogen energy is the development of intermediate-temperature (IT-SOFCs) and low-temperature solid oxide fuel cells (LT-SOFCs), which are capable of highly efficient operation in the range of 500-800 degrees C. The currently applied 8-YSZ electrolytes are expected to be replaced by one based on tetragonal zirconia (3Y-TZP), which is characterized not only by high ionic conductivity below 700 degrees C, but also significantly higher mechanical strength. One of the candidates is alumina-toughened zirconia (ATZ) with extraordinary mechanical properties (flexural strength of up to 1 GPa and outstanding fracture toughness (K-Ic) in excess of 10 MPa m(0.5)). A series of composites with a nanometric alumina content of 2.3, 10, and 20 vol% were obtained and investigated to evaluate the effects of aluminum addition on the electrical properties of the materials in relation to their microstructure, chemical and phase composition. Measurements performed by means of electrochemical impedance spectroscopy over the range of 300-650 degrees C showed that the total electrical conductivity of the obtained ATZ samples decreased slightly with increasing content of alumina inclusions and it was around one-third of an order of magnitude lower than that of the reference 3Y-TZP sinter prepared from the commercially available oxide powder containing 3 mol% of yttrium oxide (TOSOH). This is a consequence of the fact that ATZ sinters exhibited a lower specific conductivity of grain boundaries than 3Y-TZP whilst having comparable electrical conductivity of grain interiors. The total electrical conductivity values determined for the ATZ sinters at 700 and 800 degrees C are approximately the same as the electrical conductivity of 3Y-TZP, and they can therefore be considered a viable alternative to 8-YSZ electrolytes in applications such as IT-SOFCs or LT-SOFCs.
引用
收藏
页码:9250 / 9262
页数:13
相关论文
共 50 条
  • [41] Interface engineering to improve electrochemical performance of intermediate-temperature solid oxide fuel cells
    Yoo, Hyun Sik
    Kim, Seo Ju
    Megra, Yonas Tsegaye
    Lee, Jongseo
    Suk, Ji Won
    Lee, Wonyoung
    APPLIED SURFACE SCIENCE, 2023, 639
  • [42] Gradual internal methane reforming in intermediate-temperature solid-oxide fuel cells
    Vernoux, P
    Guindet, J
    Kleitz, M
    JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 1998, 145 (10) : 3487 - 3492
  • [43] Fe-based perovskites as electrodes for intermediate-temperature solid oxide fuel cells
    Hou, Shu-en
    Aguadero, Ainara
    Antonio Alonso, Jose
    Goodenough, John B.
    JOURNAL OF POWER SOURCES, 2011, 196 (13) : 5478 - 5484
  • [44] Nanoengineered BSCF Cathode Materials for Intermediate-Temperature Solid-Oxide Fuel Cells
    Darab, Mahdi
    Toprak, Muhammet S.
    Syvertsen, Guttorm Ernst
    Muhammed, Mamoun
    JOURNAL OF THE ELECTROCHEMICAL SOCIETY, 2009, 156 (08) : K139 - K143
  • [45] Performance Characteristics of Composite Film Electrolytes for Intermediate-Temperature Solid Oxide Fuel Cells
    Tsoga, A.
    Gupta, A.
    Stoever, D.
    IONICS, 1999, 5 (3-4) : 175 - 182
  • [46] Development of intermediate-temperature solid oxide fuel cells for direct utilization of hydrocarbon fuels
    Lu, C
    An, S
    Worrell, WL
    Vohs, JM
    Gorte, RJ
    SOLID STATE IONICS, 2004, 175 (1-4) : 47 - 50
  • [47] NICKEL-BASED LAYERED PEROVSKITE CATHODE MATERIALS FOR APPLICATION IN INTERMEDIATE-TEMPERATURE SOLID OXIDE FUEL CELLS
    Han, Juan
    Zheng, Kun
    Swierczek, Konrad
    FUNCTIONAL MATERIALS LETTERS, 2011, 4 (02) : 151 - 155
  • [48] Performance characteristics of composite film electrolytes for intermediate-temperature solid oxide fuel cells
    A. Tsoga
    A. Gupta
    D. Stöver
    Ionics, 1999, 5 : 175 - 182
  • [49] Influence of Thermal Conductivity on the Thermal Behavior of Intermediate-Temperature Solid Oxide Fuel Cells
    Aman, Nurul Ashikin Mohd Nazrul
    Muchtar, Andanastuti
    Rosli, Masli Irwan
    Baharuddin, Nurul Akidah
    Somalu, Mahendra Rao
    Kalib, Noor Shieela
    JOURNAL OF ELECTROCHEMICAL SCIENCE AND TECHNOLOGY, 2020, 11 (02) : 132 - 139
  • [50] Advanced intermediate temperature solid oxide fuel cells for electrical vehicles
    Zhu, B
    HYDROGEN ENERGY PROGRESS XIII, VOLS 1 AND 2, PROCEEDINGS, 2000, : 750 - 755