Effects of alumina addition on electrical properties of alumina-toughened zirconia for application in low- and intermediate-temperature solid oxide fuel cells

被引:1
|
作者
Lubszczyk, Marta [1 ]
Grabowy, Marek [2 ,3 ]
Wojteczko, Agnieszka [1 ]
Komarek, Sebastian [1 ]
Brylewski, Tomasz [1 ]
Pedzich, Zbigniew [1 ]
机构
[1] AGH Univ Krakow, Fac Mat Sci & Ceram, 30 Mickiewicza Ave, PL-30059 Krakow, Poland
[2] IEN Inst Power Engn, 8 Mory St, PL-01330 Warsaw, Poland
[3] Ceram Branch CEREL, 1 TechSt, PL-36040 Boguchwala, Poland
关键词
Alumina-toughened zirconia; Composites; Impedance spectroscopy; Solid oxide fuel cells; Tetragonal zirconia; Ionic conductivity; GRAIN-BOUNDARY RESISTIVITY; SPACE-CHARGE; MECHANICAL-PROPERTIES; IONIC-CONDUCTIVITY; DEFECT STRUCTURE; BLOCKING; AL2O3; MICROSTRUCTURE; COMPOSITES; IMPEDANCE;
D O I
10.1016/j.ceramint.2023.12.241
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
One of the priorities in the field of hydrogen energy is the development of intermediate-temperature (IT-SOFCs) and low-temperature solid oxide fuel cells (LT-SOFCs), which are capable of highly efficient operation in the range of 500-800 degrees C. The currently applied 8-YSZ electrolytes are expected to be replaced by one based on tetragonal zirconia (3Y-TZP), which is characterized not only by high ionic conductivity below 700 degrees C, but also significantly higher mechanical strength. One of the candidates is alumina-toughened zirconia (ATZ) with extraordinary mechanical properties (flexural strength of up to 1 GPa and outstanding fracture toughness (K-Ic) in excess of 10 MPa m(0.5)). A series of composites with a nanometric alumina content of 2.3, 10, and 20 vol% were obtained and investigated to evaluate the effects of aluminum addition on the electrical properties of the materials in relation to their microstructure, chemical and phase composition. Measurements performed by means of electrochemical impedance spectroscopy over the range of 300-650 degrees C showed that the total electrical conductivity of the obtained ATZ samples decreased slightly with increasing content of alumina inclusions and it was around one-third of an order of magnitude lower than that of the reference 3Y-TZP sinter prepared from the commercially available oxide powder containing 3 mol% of yttrium oxide (TOSOH). This is a consequence of the fact that ATZ sinters exhibited a lower specific conductivity of grain boundaries than 3Y-TZP whilst having comparable electrical conductivity of grain interiors. The total electrical conductivity values determined for the ATZ sinters at 700 and 800 degrees C are approximately the same as the electrical conductivity of 3Y-TZP, and they can therefore be considered a viable alternative to 8-YSZ electrolytes in applications such as IT-SOFCs or LT-SOFCs.
引用
收藏
页码:9250 / 9262
页数:13
相关论文
共 50 条
  • [21] The development of intermediate-temperature solid oxide fuel cells for the next millennium
    Choy, K
    Bai, W
    Clarojrochkul, S
    Steele, BCH
    JOURNAL OF POWER SOURCES, 1998, 71 (1-2) : 361 - 369
  • [22] Direct utilization of ammonia in intermediate-temperature solid oxide fuel cells
    Ma, Qianli
    Peng, RanRan
    Tian, Longzhang
    Meng, Guangyao
    ELECTROCHEMISTRY COMMUNICATIONS, 2006, 8 (11) : 1791 - 1795
  • [23] Development of the Sealing Materials for Intermediate-Temperature Solid Oxide Fuel Cells
    Fan, Ling-zhi
    Cheng, Ji-gui
    Jiang, Qiu-mei
    PROCEEDINGS OF THE 7TH NATIONAL CONFERENCE ON CHINESE FUNCTIONAL MATERIALS AND APPLICATIONS (2010), VOLS 1-3, 2010, : 1476 - +
  • [24] Sintering Mechanisms of Cobalt-Doped Ceria and Zirconia Electrolytes in Intermediate-Temperature Solid Oxide Fuel Cells
    Mori, Masashi
    Wang, Zhenwei
    Itoh, Takanori
    SOLID OXIDE FUEL CELLS 11 (SOFC-XI), 2009, 25 (02): : 1625 - 1634
  • [25] Sintering Mechanisms of Cobalt-Doped Ceria and Zirconia Electrolytes in Intermediate-Temperature Solid Oxide Fuel Cells
    Mori, Masashi
    Wang, Zhenwei
    Itoh, Takanori
    JOURNAL OF FUEL CELL SCIENCE AND TECHNOLOGY, 2011, 8 (01):
  • [26] Effects of sintering curves on microstructure, physical and mechanical properties and on low temperature degradation of zirconia-toughened alumina
    Zadorozhnaya, O. Yu.
    Khabas, T. A.
    Kamyshnaya, K. S.
    Kutugin, V. A.
    Malykhin, S. E.
    JOURNAL OF THE EUROPEAN CERAMIC SOCIETY, 2021, 41 (16) : 274 - 281
  • [27] Structural and electrical properties of co-doped zirconia electrolyte for intermediate temperature solid oxide fuel cell application
    Suresh, M. Buchi
    Johnson, Roy
    INTERNATIONAL JOURNAL OF ENERGY RESEARCH, 2012, 36 (14) : 1291 - 1297
  • [28] CHARACTERIZATION OF POROUS STAINLESS STEEL 430 FOR LOW- AND INTERMEDIATE-TEMPERATURE SOLID OXIDE FUEL CELL (SOFC) SUBSTRATES
    Rose, Lars
    Kesler, Olivera
    Deces-Petit, Cyrille
    Troczynski, Tom
    Maric, Radenka
    INTERNATIONAL JOURNAL OF GREEN ENERGY, 2009, 6 (06) : 638 - 645
  • [29] Promising alloys for intermediate-temperature solid oxide fuel cell interconnect application
    Geng, Shujiang
    Zhu, Jiahong
    JOURNAL OF POWER SOURCES, 2006, 160 (02) : 1009 - 1016
  • [30] LaSrMnCoO5+δ as cathode for intermediate-temperature solid oxide fuel cells
    Zhou, Qingjun
    Wei, W. C. J.
    Guo, Yajie
    Jia, Dan
    ELECTROCHEMISTRY COMMUNICATIONS, 2012, 19 : 36 - 38