Effects of alumina addition on electrical properties of alumina-toughened zirconia for application in low- and intermediate-temperature solid oxide fuel cells

被引:1
|
作者
Lubszczyk, Marta [1 ]
Grabowy, Marek [2 ,3 ]
Wojteczko, Agnieszka [1 ]
Komarek, Sebastian [1 ]
Brylewski, Tomasz [1 ]
Pedzich, Zbigniew [1 ]
机构
[1] AGH Univ Krakow, Fac Mat Sci & Ceram, 30 Mickiewicza Ave, PL-30059 Krakow, Poland
[2] IEN Inst Power Engn, 8 Mory St, PL-01330 Warsaw, Poland
[3] Ceram Branch CEREL, 1 TechSt, PL-36040 Boguchwala, Poland
关键词
Alumina-toughened zirconia; Composites; Impedance spectroscopy; Solid oxide fuel cells; Tetragonal zirconia; Ionic conductivity; GRAIN-BOUNDARY RESISTIVITY; SPACE-CHARGE; MECHANICAL-PROPERTIES; IONIC-CONDUCTIVITY; DEFECT STRUCTURE; BLOCKING; AL2O3; MICROSTRUCTURE; COMPOSITES; IMPEDANCE;
D O I
10.1016/j.ceramint.2023.12.241
中图分类号
TQ174 [陶瓷工业]; TB3 [工程材料学];
学科分类号
0805 ; 080502 ;
摘要
One of the priorities in the field of hydrogen energy is the development of intermediate-temperature (IT-SOFCs) and low-temperature solid oxide fuel cells (LT-SOFCs), which are capable of highly efficient operation in the range of 500-800 degrees C. The currently applied 8-YSZ electrolytes are expected to be replaced by one based on tetragonal zirconia (3Y-TZP), which is characterized not only by high ionic conductivity below 700 degrees C, but also significantly higher mechanical strength. One of the candidates is alumina-toughened zirconia (ATZ) with extraordinary mechanical properties (flexural strength of up to 1 GPa and outstanding fracture toughness (K-Ic) in excess of 10 MPa m(0.5)). A series of composites with a nanometric alumina content of 2.3, 10, and 20 vol% were obtained and investigated to evaluate the effects of aluminum addition on the electrical properties of the materials in relation to their microstructure, chemical and phase composition. Measurements performed by means of electrochemical impedance spectroscopy over the range of 300-650 degrees C showed that the total electrical conductivity of the obtained ATZ samples decreased slightly with increasing content of alumina inclusions and it was around one-third of an order of magnitude lower than that of the reference 3Y-TZP sinter prepared from the commercially available oxide powder containing 3 mol% of yttrium oxide (TOSOH). This is a consequence of the fact that ATZ sinters exhibited a lower specific conductivity of grain boundaries than 3Y-TZP whilst having comparable electrical conductivity of grain interiors. The total electrical conductivity values determined for the ATZ sinters at 700 and 800 degrees C are approximately the same as the electrical conductivity of 3Y-TZP, and they can therefore be considered a viable alternative to 8-YSZ electrolytes in applications such as IT-SOFCs or LT-SOFCs.
引用
收藏
页码:9250 / 9262
页数:13
相关论文
共 50 条
  • [1] Low temperature degradation of alumina-toughened zirconia in artificial saliva
    Zhao Yongqi
    Jiang Li
    Liao Yunmao
    Wang Chuanyong
    Lu Junjun
    Zhang Jingchao
    Li Wei
    JOURNAL OF WUHAN UNIVERSITY OF TECHNOLOGY-MATERIALS SCIENCE EDITION, 2013, 28 (04): : 844 - 848
  • [2] Low temperature degradation of alumina-toughened zirconia in artificial saliva
    Yongqi Zhao
    Li Jiang
    Yunmao Liao
    Chuanyong Wang
    Junjun Lu
    Jingchao Zhang
    Wei Li
    Journal of Wuhan University of Technology-Mater. Sci. Ed., 2013, 28 : 844 - 848
  • [3] Low-Temperature Aging Behavior of Alumina-Toughened Zirconia
    Schneider, Jens
    Begand, Sabine
    Kriegel, Ralf
    Kaps, Christian
    Glien, Wilfried
    Oberbach, Thomas
    JOURNAL OF THE AMERICAN CERAMIC SOCIETY, 2008, 91 (11) : 3613 - 3618
  • [4] Low Temperature Degradation of Alumina-toughened Zirconia in Artificial Saliva
    赵永旗
    JIANG Li
    LIAO Yunmao
    WANG Chuanyong
    LU Junjun
    ZHANG Jingchao
    李伟
    Journal of Wuhan University of Technology(Materials Science), 2013, 28 (04) : 844 - 848
  • [5] Low Temperature Degradation of Alumina-toughened Zirconia in Artificial Saliva
    赵永旗
    JIANG Li
    LIAO Yunmao
    WANG Chuanyong
    LU Junjun
    ZHANG Jingchao
    李伟
    Journal of Wuhan University of Technology(Materials Science Edition), 2013, (04) : 844 - 848
  • [6] Room-temperature plasticity of alumina-toughened zirconia with silica addition
    Dmitrievskiy, Alexander A.
    Efremova, Nadezhda Yu.
    Zhigacheva, Darya G.
    Ovchinnikov, Peter N.
    V. Vasyukov, Vladimir
    V. Kobzev, Vadim
    Rabotyagova, Diana I.
    INTERNATIONAL JOURNAL OF REFRACTORY METALS & HARD MATERIALS, 2024, 119
  • [7] Effect of graphene and CNFs addition on the mechanical and electrical properties of dense alumina-toughened zirconia composites
    Rincon, Acacio
    Moreno, Rodrigo
    Chinelatto, Adriana S. A.
    Gutierrez, Carlos F.
    Dolores Salvador, Maria
    Borrell, Arnparo
    CERAMICS INTERNATIONAL, 2016, 42 (01) : 1105 - 1113
  • [8] Formation of a protective alumina layer after sintering for the deceleration of low temperature degradation in alumina-toughened zirconia ceramics
    Bocanegra-Bernal, M. H.
    Dominguez-Rios, C.
    Echeberria, J.
    Reyes-Rojas, A.
    Garcia-Reyes, A.
    Aguilar-Elguezabal, A.
    CERAMICS INTERNATIONAL, 2016, 42 (14) : 16417 - 16423
  • [9] Structural, morphological, and electrical properties of doped ceria as a solid electrolyte for intermediate-temperature solid oxide fuel cells
    Stojmenovic, M.
    Zunic, M.
    Gulicovski, J.
    Bajuk-Bogdanovic, D.
    Holclajtner-Antunovic, I.
    Dodevski, V.
    Mentus, S.
    JOURNAL OF MATERIALS SCIENCE, 2015, 50 (10) : 3781 - 3794
  • [10] Effects of Calcium Hexaluminate Addition on The Mechanical Properties of Zirconia-Toughened-Alumina
    Hu, MeiLing
    Fang, MingHao
    Cheng, ShuSen
    Yang, Tao
    Huang, Zhaohui
    Liu, YanGai
    TESTING AND EVALUATION OF INORGANIC MATERIALS III, 2013, 544 : 286 - 290