Self-Calibration Sensor for Contactless Voltage Measurement Based on Dynamic Capacitance

被引:5
|
作者
Suo, Chunguang [1 ]
Huang, Rujin [1 ]
Zhou, Guoqiong [1 ]
Zhang, Wenbin [2 ]
Wang, Yanyun [1 ]
He, Mingxing [1 ]
机构
[1] Kunming Univ Sci & Technol, Coll Sci, Kunming 650504, Peoples R China
[2] Kunming Univ Sci & Technol, Coll Mech & Elect Engn, Kunming 650504, Peoples R China
关键词
noncontact; voltage measurement; dynamic capacitance; self-calibration; voltage sensor;
D O I
10.3390/s23083851
中图分类号
O65 [分析化学];
学科分类号
070302 ; 081704 ;
摘要
Noncontact voltage measurement has the advantages of simple handling, high construction safety, and not being affected by line insulation. However, in practical measurement of noncontact voltage, sensor gain is affected by wire diameter, wire insulation material, and relative position deviation. At the same time, it is also subject to interference from interphase or peripheral coupling electric fields. This paper proposes a noncontact voltage measurement self-calibration method based on dynamic capacitance, which realizes self-calibration of sensor gain through unknown line voltage to be measured. Firstly, the basic principle of the self-calibration method for noncontact voltage measurement based on dynamic capacitance is introduced. Subsequently, the sensor model and parameters were optimized through error analysis and simulation research. Based on this, a sensor prototype and remote dynamic capacitance control unit that can shield against interference are developed. Finally, the accuracy test, anti-interference ability test, and line adaptability test of the sensor prototype were conducted. The accuracy test showed that the maximum relative error of voltage amplitude was 0.89%, and the phase relative error was 1.57%. The anti-interference ability test showed that the error offset was 0.25% when there were interference sources. The line adaptability test shows that the maximum relative error in testing different types of lines is 1.01%.
引用
收藏
页数:13
相关论文
共 50 条
  • [21] An overview of self-calibration in sensor array processing
    Li, Q
    Gan, L
    Ye, ZF
    2003 6TH INTERNATIONAL SYMPOSIUM ON ANTENNAS, PROPAGATION AND EM THEORY, PROCEEDINGS, 2003, : 279 - 282
  • [22] In-Sensor Learning for Pressure Self-Calibration
    Saccani, Francesco
    Pau, Danilo
    Amoretti, Michele
    2024 IEEE SENSORS APPLICATIONS SYMPOSIUM, SAS 2024, 2024,
  • [23] A Self-Calibration Method for an Implantable Displacement Sensor
    Hao, Shiying
    2013 IEEE INTERNATIONAL CONFERENCE ON MICROWAVES, COMMUNICATIONS, ANTENNAS AND ELECTRONICS SYSTEMS (IEEE COMCAS 2013), 2013,
  • [24] On the self-calibration of stochastic magnetic sensor arrays
    Rohrer, S
    Reifschneider, N
    Hentschke, S
    ICCDCS 98: PROCEEDINGS OF THE 1998 SECOND IEEE INTERNATIONAL CARACAS CONFERENCE ON DEVICES, CIRCUITS AND SYSTEMS, 1998, : 378 - 380
  • [25] Nanoradian angle sensor and in situ self-calibration
    Zhang, SZ
    Kiyono, S
    Uda, Y
    APPLIED OPTICS, 1998, 37 (19): : 4154 - 4159
  • [26] Voltage Distortion Measurement Using a Contactless Sensor
    Chen, Kun-Long
    Xu, Wilsun
    2016 IEEE POWER AND ENERGY SOCIETY GENERAL MEETING (PESGM), 2016,
  • [27] Nonparametric belief propagation for sensor self-calibration
    Ihler, AT
    Fisher, JW
    Moses, RL
    Willsky, AS
    2004 IEEE INTERNATIONAL CONFERENCE ON ACOUSTICS, SPEECH, AND SIGNAL PROCESSING, VOL III, PROCEEDINGS: IMAGE AND MULTIDIMENSIONAL SIGNAL PROCESSING SPECIAL SESSIONS, 2004, : 861 - 864
  • [28] Study of self-calibration for ion sensor based on LS-SVM
    Department of Automation, University of Science and Technology of China, Hefei 230027, China
    Moshi Shibie yu Rengong Zhineng, 2007, 1 (115-118):
  • [29] SELF-CALIBRATION COMPENSATION TECHNIQUE FOR MICROCONTROLLER-BASED SENSOR ARRAYS
    KOLEN, PT
    IEEE TRANSACTIONS ON INSTRUMENTATION AND MEASUREMENT, 1994, 43 (04) : 620 - 623
  • [30] A self-calibration method for robotic measurement system
    Gong, CH
    Yuan, JX
    Ni, J
    JOURNAL OF MANUFACTURING SCIENCE AND ENGINEERING-TRANSACTIONS OF THE ASME, 2000, 122 (01): : 174 - 181