EFFECT OF W ON MECHANICAL PROPERTIES OF 12%Cr HEAT-RESISTANT STEEL

被引:0
|
作者
FUJITA Toshio
机构
[1] The University of Tokyo Tokyo
[2] Japan
关键词
12%Cr-W-V-Nb steel; martensitic heat-resistant steel; Laves phase; precipitation behavior;
D O I
暂无
中图分类号
学科分类号
摘要
The effect of W on mechanical properties of 12% Cr-W-V-Nb heat resistant steel at hightemperatures and room temperature is reported.The experimental results indicated that if theW content was about 2.2—3.0 wt-%,there was no obviously change of R.T.tensile strength,but impact toughness decreased with the rise of W content.On the other hand,the increase ofW content enhanced the short time stress rupture strength,but did not for the long time one.The increase of W have two effects on the precipitation behavior,promoting Laves formationof type FeW,increasing the precipitated phase amount and speeding up the coarsening pro-cess of precipitated phase at high temperatures.The effect of W on the mechanical propertiesis closely associated with precipitation behaviors.When the rupture life is short,there has noenough time to coarsen the precipitated phases,so the increase of precipitated phases results instrengthening effect,i.e.the W increases the high temperature strength.After prolonged expo-sure,the evident coarsening took plaee,that decreased the effect of precipitation.
引用
收藏
页码:95 / 100
页数:6
相关论文
共 50 条
  • [1] Effect of W on mechanical properties of 12% Cr heat-resistant steel
    Liu, Xingyang
    Fujita, Toshio
    Acta Metallurgica Sinica Series A, Physical Metallurgy & Materials Science, 1992, 5 A (02): : 95 - 100
  • [2] MECHANICAL-PROPERTIES OF 12 CR HEAT-RESISTANT STEEL CASTINGS FOR ADVANCED STEAM-TURBINES
    YAMADA, M
    TETSU TO HAGANE-JOURNAL OF THE IRON AND STEEL INSTITUTE OF JAPAN, 1985, 71 : 1444 - 1444
  • [3] Quench Brittleness of 12%Cr Martensitic Heat-Resistant Steel
    Yang Gang
    Liu Zheng-dong
    Cheng Shi-chang
    Yang Muxin
    ENGINEERING MATERIALS V, 2011, 479 : 8 - 12
  • [4] Microstructure and Mechanical Properties of Modern 11%Cr Heat-Resistant Steel Weld Joints
    Golanski, Grzegorz
    Slania, Jacek
    Sroka, Marek
    Wieczorek, Pawel
    Urzynicok, Michal
    Krawczyk, Ryszard
    MATERIALS, 2021, 14 (12)
  • [5] Combined Effect of Co and W on Deformation Resistance of 12Cr Heat-Resistant Steel for USC Steam Turbines
    Huiran Cui
    Feng Sun
    Ke Chen
    Jiansheng Wu
    Journal of Materials Engineering and Performance, 2011, 20 : 1613 - 1619
  • [6] Combined Effect of Co and W on Deformation Resistance of 12Cr Heat-Resistant Steel for USC Steam Turbines
    Cui, Huiran
    Sun, Feng
    Chen, Ke
    Wu, Jiansheng
    JOURNAL OF MATERIALS ENGINEERING AND PERFORMANCE, 2011, 20 (09) : 1613 - 1619
  • [7] EFFECT OF PRECIPITATION PHASES ON MECHANICAL PROPERTIES OF 25CR-20NI HEAT-RESISTANT CAST STEEL
    YOKOYAMA, T
    KATAURA, Y
    OTOTANI, T
    TRANSACTIONS OF THE IRON AND STEEL INSTITUTE OF JAPAN, 1970, 10 (03) : 225 - &
  • [8] Microstructure Evolution and Mechanical Properties of Dissimilar Material Diffusion-Bonded Joint for High Cr Ferrite Heat-Resistant Steel and Austenitic Heat-Resistant Steel
    Hua Yu
    Chen Jianguo
    Yu Liming
    Si Yonghong
    Liu Chenxi
    Li Huijun
    Liu Yongchang
    ACTA METALLURGICA SINICA, 2022, 58 (02) : 141 - 154
  • [9] Effect of Carbon Content on Microstructure and Mechanical Properties of 9 to 12 pct Cr Ferritic/Martensitic Heat-Resistant Steels
    Feng-Shi Yin
    Li-Qian Tian
    Bing Xue
    Xue-Bo Jiang
    Li Zhou
    Metallurgical and Materials Transactions A, 2012, 43 : 2203 - 2209
  • [10] Effect of Carbon Content on Microstructure and Mechanical Properties of 9 to 12 pct Cr Ferritic/Martensitic Heat-Resistant Steels
    Yin, Feng-Shi
    Tian, Li-Qian
    Xue, Bing
    Jiang, Xue-Bo
    Zhou, Li
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2012, 43A (07): : 2203 - 2209