Experimental study on eccentric compression of the prefabricated columns with a new type of column-column connection node

An assembled building is defined by a construction methodology wherein prefabricated components are fabricated off-site and subsequently assembled at the construction site. This methodology confers cost efficiency, expedites construction timelines, and enhances the quality of the prefabricated components. Furthermore, it mitigates a range of environmental concerns inherent to conventional poured-in-place construction methods. This paper introduces a novel assembled column-column connection node that utilizes a new adhesive potted rebar lap joint. The research was divided into two principal components. Firstly, 18 specimens of adhesive potted rebar lap joints were tested under tension, with the lap length being the variable parameter. Secondly, eccentric compression experiments were conducted on one poured-in-place column and six assembled columns, varying parameters such as stirrup configuration and the length of the post-poured section. The failure modes of the columns, as well as their bearing capacities, deflection, rebar strains, and concrete strains, were analyzed and recorded. The test results revealed the existence of two different failure modes in the tensile tests of adhesive potted rebar lap joints. It was found that the reasonable lap length of the specimen should be no less than 14 times the diameter of the rebar (d). Eq. (15) was employed to estimate the suitable lap length for specimens with different sleeve and rebar diameters. In the failure sections of the prefabricated columns, all failures occurred outside the nodes. Moreover, the mechanical properties of small eccentrically compressed columns were comparable to those of the poured-in-place column. The use of spiral stirrups enhances the bearing capacity of the specimen, and an increase in the length of the post-poured section corresponds to a greater bearing capacity. The lateral deflection of the poured-in-place column generally follows a sinusoidal curve, while the lateral deflection of prefabricated columns in the later stages of loading does not exhibit a sinusoidal pattern. Both align with the assumption of a flat section. The stress performance of adhesive potted rebar lap joints in eccentric columns meets the strength requirements. The inclusion of tenons minimally affects the stress distribution in the node, fulfilling construction specifications. The stress performance of the assembled column nodes is reliable. The proposed adhesive potted rebar lap joint technology, along with the novel prefabricated column-column node, provides significant insights into engineering design and construction applications.