Understanding the Structural-Chemical Evolution of Epitaxial NbN/Al2O3/NbN Trilayers with Varying NbN Thickness

被引:0
|
作者
Sarker, Jith [1 ]
Garg, Prachi [1 ]
Zhu, Menglin [2 ]
Rouleau, Christofer M. [3 ]
Hwang, Jinwoo [2 ]
Osei-Agyemang, Eric [1 ]
Mazumder, Baishakhi [1 ]
机构
[1] SUNY Buffalo, Dept Mat Design & Innovat, Buffalo, NY 14260 USA
[2] Ohio State Univ, Dept Mat Sci & Engn, Columbus, OH 43212 USA
[3] Ctr Nanophase Mat Sci, Oak Ridge Natl Lab, Oak Ridge, TN 37830 USA
来源
ACS APPLIED ENGINEERING MATERIALS | 2023年 / 1卷 / 12期
基金
美国国家科学基金会;
关键词
Superconductors; Epitaxial growth; NbN/Al2O3/NbN trilayers; Crystallinity; Chemical inhomogeneity; Point defects; FILMS; STABILITY; XPS; DEFECTS;
D O I
10.1021/acsaenm.3c00555
中图分类号
T [工业技术];
学科分类号
08 ;
摘要
Epitaxial NbN/Al2O3/NbN trilayer structures with NbN thicknesses of 50-200 nm were grown by pulsed laser deposition. Within each trilayer configuration, it was observed that the top NbN layers exhibited slightly reduced crystallinity compared to the bottom NbN layers due to the strain-induced effects caused by the lattice mismatch between NbN and Al2O3. Notably, the trilayer structures exhibited epitaxial growth with consistent in-plane rotational orientations in the NbN layers. Significant deviations in the stoichiometry of the NbN layers were detected, primarily stemming from N-deficient and O-rich regions. Moreover, the chemical non-uniformity within the NbN layers intensified as the layer thickness decreased. The lateral N/Nb distribution showed a complementary distribution with O/Nb, resulting from a higher tendency for NbOx formation with lower NbN thicknesses. To gain a deeper understanding of the formation and impacts of local point defects, such as nitrogen vacancies and oxygen impurities, density functional theory (DFT) calculations were employed. The obtained defect formation energies suggest that O substitutional defects will prevail in an oxygen-rich environment over N vacancies. The investigation further explored the role of these defects in tuning the electronic states at the Fermi level.
引用
收藏
页码:3227 / 3236
页数:10
相关论文
共 50 条
  • [21] The effect of varying Al2O3 percentage in hydroxyapatite/Al2O3 composite materials:: Morphological, chemical and cytotoxic evaluation
    Epure, L. M.
    Dimitrievska, S.
    Merhi, Y.
    Yahia, L. H.
    JOURNAL OF BIOMEDICAL MATERIALS RESEARCH PART A, 2007, 83A (04) : 1009 - 1023
  • [22] Enhancement of high-frequency performances by Al2O3 interlayer in FeCoHf/Al2O3/FeCoHf trilayers
    Jing, Zhao-Xuan
    Zhang, Shou-Heng
    Li, Shandong
    AIP ADVANCES, 2022, 12 (05)
  • [23] Modification of α-Al2O3 platelet/ZrO2 matrix interface by epitaxial growth of β″-Al2O3 on the α-Al2O3
    Huang, Xue-Ning
    Kuo, Chu Kun
    Nicholson, Patrick S.
    Journal of the American Ceramic Society, 1995, 78 (04): : 892 - 896
  • [24] Epitaxial overgrowth of α-Al2O3 on Na-β″-and-β-Al2O3 substrates
    Kuo, Chu Kun
    Nicholson, Patrick S.
    Solid State Ionics, 1994, 74 (1-2) : 61 - 64
  • [25] STRUCTURAL EVOLUTION AND MORPHOLOGICAL CHANGES OF Al/Al2O3/Gr COMPOSITES
    Popescu, Gabriela
    Iacob, Gheorghe
    Buzatu, Mihai
    METALURGIA INTERNATIONAL, 2013, 18 : 104 - 107
  • [26] Structural evolution and morphological changes of Al/Al2O3/Gr composites
    Popescu, Gabriela
    Iacob, Gheorghe
    Buzatu, Mihai
    Metalurgia International, 2013, 18 (SPEC.1): : 104 - 107
  • [27] Morphological, chemical and structural study of sputtered Al/Al2O3 multilayers
    Le Paven-Thivet, C
    Aubert, P
    Fusil, S
    Zozime, A
    Malibert, C
    Houdy, P
    NEW METHODS, MECHANISMS AND MODELS OF VAPOR DEPOSITION, 2000, 616 : 81 - 86
  • [29] Defects and interfaces in epitaxial ZnO/α-Al2O3 and AlN/ZnO/α-Al2O3, heterostructures
    Narayan, J
    Dovidenko, K
    Sharma, AK
    Oktyabrsky, S
    JOURNAL OF APPLIED PHYSICS, 1998, 84 (05) : 2597 - 2601
  • [30] Chemical and structural characterization of aluminum oxide (Al2O3) slurries
    Lauwidjaja, M
    Popescu, G
    Richardson, K
    Dogariu, A
    CHEMICAL MECHANICAL PLANARIZATION IN INTEGRATED CIRCUIT DEVICE MANUFACTURING, 1998, 98 (07): : 235 - 245