INJECTION-MOLDING FOR STRUCTURAL CERAMICS

被引：0

作者：

GAY, BM ^{[1
]}

机构：

[1] N CAROLINA STATE UNIV, RALEIGH, NC 27607 USA

来源：

AMERICAN CERAMIC SOCIETY BULLETIN | 1983年 / 62卷 / 08期

关键词：

D O I：

暂无

中图分类号：

TQ174 [陶瓷工业]; TB3 [工程材料学];

学科分类号：

0805 ; 080502 ;

摘要：

引用

页码：859 / 859

页数：1

共 50 条

[41] PROCESS PARAMETERS ESTIMATION FOR STRUCTURAL REACTION INJECTION-MOLDING AND RESIN TRANSFER MOLDING
GONZALEZROMERO, VM
MACOSKO, CW
POLYMER ENGINEERING AND SCIENCE, 1990, 30 (03): : 142 - 146
[42] WHISKER LENGTH DEGRADATION DURING THE PREPARATION OF COMPOSITE CERAMICS FOR INJECTION-MOLDING
STEDMAN, SJ
EVANS, JRG
WOODTHORPE, J
JOURNAL OF MATERIALS SCIENCE, 1990, 25 (2A) : 1025 - 1032
[43] FABRICATION OF MICROSTRUCTURES OF EXTREME STRUCTURAL HEIGHTS BY REACTION INJECTION-MOLDING
HAGMANN, P
EHRFELD, W
INTERNATIONAL POLYMER PROCESSING, 1989, 4 (03) : 188 - 195
[44] FABRICATION OF MICROSTRUCTURES WITH EXTREME STRUCTURAL HEIGHTS BY REACTION INJECTION-MOLDING
HAGMANN, P
EHRFELD, W
VOLLMER, H
MAKROMOLEKULARE CHEMIE-MACROMOLECULAR SYMPOSIA, 1989, 24 : 241 - 251
[45] NEURAL NETWORKS IN INJECTION-MOLDING
SCHMIDBERGER, E
GUTBROD, O
HEINZELMANN, F
OHNGEMACH, D
KUNSTSTOFFE-PLAST EUROPE, 1995, 85 (05): : 620 - &
[46] ANALYSIS OF THE INJECTION-MOLDING PROCESS
DIJKSMAN, JF
PHILIPS TECHNICAL REVIEW, 1989, 44 (07): : 212 - 217
[47] INJECTION-MOLDING IN THE CLEAN ROOM
GREIVE, MH
F&M-FEINWERKTECHNIK & MESSTECHNIK, 1989, 97 (11): : ZM166 - ZM167
[48] INJECTION-MOLDING THERMOPLASTIC FOAMS
COCHRAN, LD
OSBORN, CW
SPE JOURNAL, 1969, 25 (09): : 20 - &
[49] REACTION INJECTION-MOLDING - PREFACE
KRESTA, JE
ACS SYMPOSIUM SERIES, 1985, 270 : R9 - R9
[50] OPTIMIZATION IN INJECTION-MOLDING DESIGN
PANDELIDIS, I
ZOU, Q
IMPROVING COMPETITIVENESS THROUGH PLASTICS INNOVATION ( PREPRINT ), 1988, : M1 - M6