Producing deep holes by means of numerically controlled machine tools

被引：0
|
作者：
Pini B.E. [1 ]
Kurets A.M. [2 ]
机构：
[1] MAMI Moscow State Technical University, Moscow
[2] ZAO ST Grupp, Moscow
来源：
Russian Engineering Research | 2014年 / 34卷 / 9期
关键词：
chip; cutting conditions; gun drill; numerically controlled machine tools; oil mist; pilot hole;
D O I：
10.3103/S1068798X1409010X
中图分类号：
学科分类号：
摘要：
The use of the Hammond system for the machining of deep holes on numerically controlled machine tools is considered, so as to improve the precision in machining holes of length up to 3 m (diameter up to 40 mm) by gun drills. © 2014, Allerton Press, Inc.
引用
收藏
页码：560 / 563
页数：3
相关论文
共 50 条
  • [41] Fault propagation analysis of computer numerically controlled machine tools
    Huang, Shoujin
    Lu, Ningyun
    Jiang, Bin
    Simani, Silvio
    Li, Ronghua
    Huang, Binda
    Cao, Jie
    JOURNAL OF MANUFACTURING SYSTEMS, 2023, 70 : 149 - 159
  • [42] POSTPROCESSOR GENERATOR FOR NUMERICALLY CONTROLLED MACHINE-TOOLS PROGRAMMING
    CVJETICANIN, M
    STROJARSTVO, 1986, 28 (05): : 291 - 299
  • [43] MOTION TIME CALCULATION FOR NUMERICALLY CONTROLLED MACHINE-TOOLS
    PALLOT, B
    DUCHAMP, R
    INTERNATIONAL JOURNAL OF PRODUCTION RESEARCH, 1991, 29 (12) : 2433 - 2441
  • [44] CONTRIBUTION TO AUTOMATIC PROGRAMMING FOR NUMERICALLY CONTROLLED MACHINE-TOOLS
    UDILJAK, T
    STROJARSTVO, 1993, 35 (3-4): : 97 - 101
  • [45] Energy planning in production shops with numerically controlled machine tools
    Safarov D.T.
    Kondrashov A.G.
    Safarova L.R.
    Glinina G.F.
    Russian Engineering Research, 2017, 37 (9) : 827 - 834
  • [46] Functional modeling of numerically controlled machine tools for group machining of blanks
    V. V. Epifanov
    A. A. Kozina
    Russian Engineering Research, 2007, 27 (11) : 802 - 805
  • [47] CAD/CAE systems in the design of numerically controlled multipurpose machine tools
    Kul’ga K.S.
    Vinogradov P.V.
    Gaitova A.A.
    Russian Engineering Research, 2016, 36 (4) : 303 - 308
  • [48] REDUCTION GEARS WITHOUT BACKLASH FOR NUMERICALLY-CONTROLLED MACHINE TOOLS
    STARODUB.VS
    RUSSIAN ENGINEERING JOURNAL-USSR, 1966, 46 (03): : 16 - &
  • [49] Optimization of control programs for numerically controlled machine tools by dynamic programming
    Pereverzev P.P.
    Pimenov D.Y.
    Russ. Eng. Res., 2 (135-142): : 135 - 142
  • [50] USE OF THE LASER INTERFEROMETER IN THE CALIBRATION OF NUMERICALLY CONTROLLED MACHINE-TOOLS
    TIPTON, H
    PROCEEDINGS OF THE SOCIETY OF PHOTO-OPTICAL INSTRUMENTATION ENGINEERS, 1983, 376 : 15 - 19
12345