High-pressure thin-wall drift tubes

被引：0
|
作者：
V. I. Davkov
K. I. Davkov
V. V. Myalkovskiy
V. D. Peshekhonov
机构：
[1] Laboratory of Particle Physics,Joint Institute for Nuclear Research
来源：
Instruments and Experimental Techniques | 2008年 / 51卷
关键词：
29.40.Gx;
D O I：
暂无
中图分类号：
学科分类号：
摘要：
The design of thin-wall drift tubes filled with a gas at a high differential pressure (up to 4 bar) is described, and the results of studying them are presented. A method for strengthening the tube walls with carbon filaments for compensating for changes in their linear dimensions upon changes in the differential pressure is considered. It is shown that these tubes can be used for developing planar position detectors of charged particles and photons.
引用
收藏
页码：787 / 791
页数：4
相关论文
共 50 条
  • [41] FABRICATION OF THIN-WALL BETA''-ALUMINA TUBES FROM SPIRALLY WOUND TAPE
    MERLAU, DJ
    AMERICAN CERAMIC SOCIETY BULLETIN, 1981, 60 (09): : 937 - 937
  • [42] Dynamic response of thin-wall circular tubes under transverse blast loading
    Yu B.
    Feng G.
    Li S.
    Liu Z.
    Baozha Yu Chongji/Explosion and Shock Waves, 2019, 39 (10):
  • [43] Fabrication of nanoceramic thin-wall tubes by magnetic pulsed compaction and thermal sintering
    Ivanov, VV
    Ivin, SY
    Khrustov, VR
    Kotov, YA
    Murzakaev, AM
    Nikonov, AV
    Paranin, SN
    Spirin, AV
    SCIENCE OF SINTERING, 2005, 37 (01) : 55 - 60
  • [44] Simplified Assessment of Embedded Crack in Thin-wall Pressure Vessel
    Tang Wei
    Sun Jian
    2009 INTERNATIONAL CONFERENCE ON MEASURING TECHNOLOGY AND MECHATRONICS AUTOMATION, VOL III, 2009, : 863 - 866
  • [45] New "high-speed" for thin-wall parts
    Dimmler, G
    Steinbichler, G
    Wobbe, H
    KUNSTSTOFFE-PLAST EUROPE, 2005, 95 (09): : 112 - +
  • [46] Premature water-slide corrosion of furnace wall tubes in a high-pressure boiler
    Mobin, A.
    Malik, A. U.
    Andijani, I. N.
    Al-Muaili, F.
    Al-Hajri, M.
    MATERIALS PERFORMANCE, 2006, 45 (09) : 44 - 49
  • [47] HIPS FOR THIN-WALL PARTS
    不详
    PLASTICS TECHNOLOGY, 1983, 29 (03) : 59 - 59
  • [48] Thin-wall injection molding
    Chen, SC
    Peng, HS
    Huang, LT
    Chang, CT
    Wei, DY
    Ruo, RC
    ANTEC 2000: SOCIETY OF PLASTICS ENGINEERS TECHNICAL PAPERS, CONFERENCE PROCEEDINGS, VOLS I-III, 2000, : 543 - 546
  • [49] Designing with thin-wall tubing
    Pedersen, Chris
    Machine Design, 1989, 61 (09)
  • [50] FASTENERS FOR THIN-WALL JOINTS
    HAWES, RG
    MACHINE DESIGN, 1978, 50 (03) : 94 - 97
12345