Effect of Re addition on the crystallization, heat treatment and structure of the Cu–Ni–Si-Cr alloy

For determination of the structure and properties of those alloys, the following investigations were carried out: scanning microscopy and EDS X-ray analysis. Investigations concerning the optimal chemical composition and production method of Cu–Ni–Si alloys modified by Cr and Re as well as the improved properties in comparison with traditional alloys contribute to better understanding of mechanisms influencing the improvement of mechanical properties of the newly developed alloys. Thermal analysis of the crystallization process allows for accurate calculation of latent heat of various phases developed during solidification. Based on the assumption that the latent crystallization heat is proportional to the share of various phases in the alloy, the thermo-derivative analysis also allows the calculation of the amount of crystallized phases. Calculation of the properties as mentioned earlier is based on the characteristic points determined in a derivative curve. The adequately selected chemical composition of the alloy, as well as the appropriate cooling rate and heat treatment conditions, leads to improvement of functional properties of manufactured elements. For the analysed alloys, a thermal derivative analysis was used to determine the kinetics of crystallization and the temperature of the beginning and the end of a phase and eutectic crystallization, mainly the liquidus temperature (TL) and solidus temperature (TSOL). The TSOL temperature determined on thermal derivative analysis is the upper limit of supersaturation of the tested alloys. The conductivity and microhardness of the tested alloys were also measured in the function of the chemical composition and the state (i.e., heat treatment).