Interaction of Yttrium, Lanthanum, and Samarium Oxides at 1600°C

Phase equilibria and structural transformations in the La2O3–Y2O3–Sm2O3 system at 1600°C were studied by X-ray diffraction and petrography over the entire composition range. Solid solutions based on the hexagonal (A) modification of La2O3, cubic (C) modification of Y2O3, and monoclinic (B) modification of La2O3 (Sm2O3) were found to form in the system. The starting materials were La2O3, Sm2O3, and Y2O3 (99.99 %) powders. The samples were prepared from nitrate solutions with subsequent evaporation and decomposition at 800ºC for 2 h. The samples were subjected to heat treatment in three stages: at 1100°C (for 2464 h), at 1500°C (for 50 h), and then at 1600°C (for 10 h) in furnaces with Fechral (H23U5T) and Superkanthal (MoSi2) heating elements, respectively. The isothermal section of the La2O3–Y2O3–Sm2O3 phase diagram at 1600°C is characterized by three single-phase (A-La2O3, B-La2O3 (Sm2O3), C-Y2O3) and two-phase (A + B, B + C) regions. The ordered phase of perovskite-type was not found at 1600°C in this system. An infinite series of solid solutions based on the monoclinic modification of B-La2O3 (Sm2O3), which occupies the largest area of the isothermal section, forms in the system. Yttrium oxide stabilizes the total mutual solubility of lanthanum and samarium oxides. The lattice parameters of the B phase decrease, the lattice volume increases with the addition of a heavier ion, and the lattice of solid solutions based on the B modification of rare earth metal oxides becomes more densely packed with higher yttrium oxide. The lattice parameters of the B phase lattice vary from a = 1.3988 nm, b = 0.3774 nm, and c = 0.8427 nm in the single-phase sample containing 15 mol.% Y2O3–42.5 mol.% La2O3– 42.5 mol.% Sm2O3 to a = 1.3806 nm, b = 0.3709 nm, and c = 0.8312 nm in the two-phase sample containing 45 mol.% Y2O3–27.5 mol.% La2O3–27.5 mol.% Sm2O3.