Experimental investigation on heat transfer effect of conical strip inserts in a circular tube under laminar flow

被引：0

作者：

M. Arulprakasajothi

K. Elangovan

K. Hema Chandra Reddy

S. Suresh

机构：

[1] Jawaharlal Nehru Technological University Anantapur,Department of Mechanical Engineering

[2] Cambridge Institute of Technology,Department of Mechanical Engineering

[3] National Institute of Technology,Department of Mechanical Engineering

来源：

Frontiers in Energy | 2016年 / 10卷

关键词：

Nusselt number; friction factor; conical strip;

D O I：

暂无

中图分类号：

学科分类号：

摘要：

The aim of this paper is to observe the Nusselt number and friction factor behavior of the circular tube with conical strip inserts as turbulators in a laminar flow condition, using staggered and non-staggered conical strips with three different twist ratios (Y = 2, 3 and 5). The conical strip is inserted in the forward and backward direction individually compared to the flow of water which is the working fluid. The results indicate that the conical strip inserts increases the Nusselt number when compared to the plain surface tube. It is observed that the strip geometry has a major effect on the thermal performance of the circular tube. On examination of different strips for determining the enhancement of Nusselt number, the staggered conical strip with the twist ratio of Y = 3 has given a better result compared to the other two strips. Finally, correlations have been derived using regression analysis for predicting the Nusselt number and friction factor.

引用

页码：136 / 142

页数：6

共 50 条

[21] AN EXPERIMENTAL AND NUMERICAL STUDY OF HEAT TRANSFER AND FLOW CHARACTERISTICS OF LAMINAR FLOW IN A CIRCULAR TUBE WITH WEDGE-SHAPED WAVY-TAPE INSERTS
Liang, Yunmin
Liu, Peng
Zheng, Nianben
Shan, Feng
Liu, Zhichun
Liu, Wei
PROCEEDINGS OF THE ASME INTERNATIONAL MECHANICAL ENGINEERING CONGRESS AND EXPOSITION, 2018, VOL 8B, 2019,
[22] Modeling for thermal augmentation of turbulent flow in a circular tube fitted with twisted conical strip inserts
Pourramezan, Mandi
Ajam, Hossein
APPLIED THERMAL ENGINEERING, 2016, 105 : 509 - 518
[23] Experimental and numerical investigation on heat transfer augmentation in a circular tube under forced convection with annular differential blockages/inserts
D. R. Waghole
Heat and Mass Transfer, 2018, 54 : 1841 - 1846
[24] Experimental investigation on heat transfer in laminar, transitional and turbulent circular pipe flow
Bertsche, Dirk
Knipper, Paul
Wetzel, Thomas
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2016, 95 : 1008 - 1018
[25] Experimental Investigation of Heat Transfer and Pressure Drop Performance of a Circular Tube with Coiled Wire Inserts
Kapse, Arvind A.
Shewale, Vinod C.
Barahate, Sanjay D.
Kakade, Amol B.
Surywanshi, Satish J.
ENGINEERING TECHNOLOGY & APPLIED SCIENCE RESEARCH, 2024, 14 (01) : 12512 - 12517
[26] Experimental and numerical investigation on heat transfer augmentation in a circular tube under forced convection with annular differential blockages/inserts
Waghole, D. R.
HEAT AND MASS TRANSFER, 2018, 54 (06) : 1841 - 1846
[27] Experimental and numerical study on the heat transfer and flow performance for the circular tube fitted with drainage inserts
Li, Pengxiao
Liu, Peng
Liu, Zhichun
Liu, Wei
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2017, 107 : 686 - 696
[28] HEAT TRANSFER FOR PULSATING LAMINAR FLOW IN A CIRCULAR TUBE.
Mochizuki, Sadanari
Heat Transfer - Japanese Research, 1976, 5 (03): : 51 - 74
[29] Heat and fluid flow behaviors in a laminar tube flow with circular protruded twisted tape inserts
Harish, H., V
Manjunath, K.
CASE STUDIES IN THERMAL ENGINEERING, 2022, 32
[30] Effect of flow geometry parameters on transient heat transfer for turbulent flow in a circular tube with baffle inserts
Tandiroglu, A
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2006, 49 (9-10) : 1559 - 1567

← 1 2 3 4 5 →