Solution Treatment Effects on Microstructure and Mechanical Properties of Al-(1 to 13 pct)Si-Mg Cast Alloys

The effects of solution treatment time and Si content and morphology on microstructures and mechanical properties of heat-treated Al-Si-Mg cast alloys were investigated systematically. Five alloys, with Si levels ranging from 1 to 13 pct, were tested in as-cast, T4, and T61 conditions. The eutectic Si was both unmodified and Sr-modified. Results show that the microstructures are affected significantly by alloy composition, eutectic Si morphology, and solution treatment time. Si content has significant effects on ultimate tensile strength (UTS), yield strength (YS), and elongation as well as a strong influence on solution treatment response. In T61 treatment with different solutionizing times, UTS and YS reach their maximum values in ~1 hour of solutionizing followed by a decrease, then a slight increase, and finally, a plateau close to the maximum level. Elongation of alloys with a high Si content, 7 pct and 13 pct, increases rapidly at solutionizing times of 1 to 2 hours then varies in a wide range, showing improvements in the 4 to 10 hours range. The data indicate that a solution treatment time of ~1 hour is sufficient to achieve maximum strength. The changes in mechanical properties were correlated to changes in microstructure evolution—Mg-Si precipitation, Si particle fragmentation, and microstructure homogenization. Empirical models uniquely relating Si content to UTS and YS are given for T61 heat-treated alloys.