High-strain deformation of polyethylenes in plane-strain compression at elevated temperatures

被引:5
|
作者
Lezak, E. [1 ]
Bartczak, Z. [1 ]
机构
[1] Polish Acad Sci, Ctr Mol Macromol Studies, PL-90363 Lodz, Poland
关键词
compression; polyethylene (PE); strain;
D O I
10.1002/app.26011
中图分类号
O63 [高分子化学(高聚物)];
学科分类号
070305 ; 080501 ; 081704 ;
摘要
The deformation and recovery behavior of several polyethylenes and ethylene-based copolymers with various molecular architectures and a broad range of molecular masses and molecular mass distributions was studied. Because of the differences in the molecular characteristic, this series exhibited a relatively broad range of crystallite sizes and crystallinity levels. The samples were subjected to high strain compression under plane-strain conditions at the elevated temperature of 80 degrees C. The unloading of the compressed samples led to substantial nonelastic recovery of the strain. The stress-strain and recovery behavior was related to the molecular parameters. The results confirmed the common deformation scheme with four crossover points related to the activation of subsequent deformation mechanisms, as proposed by Strobl. Although the critical strains, related to the activation of deformation of the crystalline component, are invariant, the critical strain of the last point, which is related to the activation of chain disentanglement in the amorphous component, depends on the temperature of deformation. That critical strain decreases from 1.0 to approximately 0.8-0.9 as the temperature of deformation increases from room temperature to 80 degrees C. This shift results from an increase in the chain mobility with increasing temperature, and this makes modification of the molecular network through chain disentanglements easier. (C) 2007 Wiley Periodicals, Inc.
引用
收藏
页码:14 / 24
页数:11
相关论文
共 50 条
  • [11] Plastic deformation of the γ phase in isotactic polypropylene in plane-strain compression
    Lezak, E.
    Bartczak, Z.
    Galeski, A.
    MACROMOLECULES, 2006, 39 (14) : 4811 - 4819
  • [12] STRAIN DISTRIBUTION PATTERNS DURING PLANE-STRAIN COMPRESSION
    BEYNON, JH
    SELLARS, CM
    JOURNAL OF TESTING AND EVALUATION, 1985, 13 (01) : 28 - 38
  • [13] Deformation of the ultra-high molecular weight polyethylene melt in the plane-strain compression
    Bartczak, Zbigniew
    Beris, Petra F. M.
    Wasilewski, Krzysztof
    Galeski, Andrzej
    Lemstra, Piet J.
    JOURNAL OF APPLIED POLYMER SCIENCE, 2012, 125 (06) : 4155 - 4168
  • [14] PLANE-STRAIN COMPRESSION TESTING OF POLYMERS
    WILLIAMS, JG
    TRANSACTIONS AND JOURNAL OF THE PLASTICS INSTITUTE, 1967, 35 (117): : 505 - &
  • [15] PLANE-STRAIN COMPRESSION OF ALUMINUM CRYSTALS
    HOSFORD, WF
    ACTA METALLURGICA, 1966, 14 (09): : 1085 - &
  • [16] Plane strain compression testing of polyoxymethylene at varying strain rates and elevated temperatures
    Vogiatzoglou, S.
    Barton, D. C.
    Mohanraj, J.
    PLASTICS RUBBER AND COMPOSITES, 2010, 39 (06) : 256 - 263
  • [17] PLANE-STRAIN DEFORMATION AND REBINDER EFFECT
    JOHNSTON, WG
    ATKINSON, RE
    LUBRICATION ENGINEERING, 1976, 32 (05): : 242 - 248
  • [18] FRICTION IN THE PLANE-STRAIN COMPRESSION TEST
    TAKAHASHI, H
    ALEXANDER, JM
    JOURNAL OF THE INSTITUTE OF METALS, 1961, 90 (03): : 72 - 79
  • [19] DEFORMATION OF POLYCRYSTALLINE NI3AL AT HIGH-STRAIN RATES AND ELEVATED-TEMPERATURES
    SIZEK, HW
    GRAY, GT
    ACTA METALLURGICA ET MATERIALIA, 1993, 41 (06): : 1855 - 1860
  • [20] High-strain, high-strain rate deformation, shear localization and recrystallization in tantalum
    Chen, YJ
    LaSalvia, JC
    Nesterenko, VF
    Meyers, MA
    Bondar, MP
    Lukyanov, YL
    JOURNAL DE PHYSIQUE IV, 1997, 7 (C3): : 435 - 440