MHD-mixed convection flow in a lid-driven trapezoidal cavity under uniformly/non-uniformly heated bottom wall

被引:28
|
作者
Javed, T. [1 ]
Mehmood, Z. [1 ]
Pop, Ioan [2 ]
机构
[1] Int Islamic Univ, Dept Math & Stat, Islamabad, Pakistan
[2] Babes Bolyai Univ, Dept Appl Math, Cluj Napoca, Romania
关键词
Finite element method (FEM); Mixed convection; Penalty method; Lid-driven cavity; FINITE-ELEMENT SIMULATION; STAGNATION POINT FLOW; NATURAL-CONVECTION; SQUARE CAVITY; ENCLOSURES; ANGLES;
D O I
10.1108/HFF-01-2016-0029
中图分类号
O414.1 [热力学];
学科分类号
摘要
Purpose - The purpose of this paper is to analyze numerical results for heat transfer through mixed convection in an incompressible steady lid-driven fluid flow inside a trapezoidal cavity in the presence of a uniform magnetic field. Design/methodology/approach - In this study, the authors have considered three different cases, in which left and right walls of the cavity are tilted at different angles of 0, 30 and 45 degrees, respectively. Both left and right side walls of the cavity are taken cold and the upper wall is insulated and assumed moving with constant speed, whereas the bottom wall is considered to be heated uniformly/non-uniformly. To eliminate pressure term, penalty method is applied to governing Navier-Stokes' equations. The reduced equations are solved by Galerkin weighted residual technique of finite element method. Grid-independent results are obtained and shown in terms of plots for streamlines, isotherms, Nusselt number and average Nusselt number for a wide range of flow parameters, including Rayleigh numbers Ra, Prandtl number Pr and Hartman number Ha. Findings - It has been observed that the effects of moving lid become negligible for Ra = 100,000, whereas increasing Rayleigh number results in stronger streamline circulation and convection dominant effects inside the enclosure. Local Nusselt number Nu along the bottom wall is observed to be maximum at edges and it reduces while moving toward the center from edges, and attains minimum value at the center of the bottom wall. Research limitations/implications - The problem is modeled for laminar and incompressible flow, inducedmagnetic field has been considered negligibly small and local thermal equilibrium has been assumed. Originality/value - In this investigation, the authors have presented new and original results for mixed convection flow inside a lid-driven trapezoidal cavity under the influence of a magnetic field. Hence, this study would be important for the researchers working in the area of heat transfer in cavity flows involving magnetic effects to become familiar with the flow behavior and properties.
引用
收藏
页码:1231 / 1248
页数:18
相关论文
共 50 条
  • [21] MHD mixed convection and irreversibility analysis of hybrid nanofluids in a partially heated lid-driven cavity chamfered from the bottom side
    Korei, Zakaria
    Benissaad, Smail
    Berrahil, Farid
    Filali, Abdelkader
    INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2022, 132
  • [22] Mixed convection in a lid-driven cavity with partially heated porous block
    Colak, Eren
    Ekici, Ozgur
    Oztop, Hakan F.
    INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2021, 126
  • [23] MHD mixed convection in a chamfered lid-driven cavity with partial heating
    Colak, Eren
    Oztop, Hakan F.
    Ekici, Ozgur
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2020, 156
  • [24] Mixed convection in a double lid-driven sinusoidally heated porous cavity
    Chattopadhyay, Anirban
    Pandit, Swapan K.
    Sen Sarma, Sreejata
    Pop, I.
    INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2016, 93 : 361 - 378
  • [25] Laminar Mixed-Convection Heat Transfer in a Lid-Driven Cavity with Modified Heated Wall
    Yapici, Kerim
    Obut, Salih
    HEAT TRANSFER ENGINEERING, 2015, 36 (03) : 303 - 314
  • [26] On mixed convection in a cavity with sinusoidally heated moving lid and uniformly heated and cooled side walls
    Deborah S Ducasse
    Precious Sibanda
    Boundary Value Problems, 2013
  • [27] On mixed convection in a cavity with sinusoidally heated moving lid and uniformly heated and cooled side walls
    Ducasse, Deborah S.
    Sibanda, Precious
    BOUNDARY VALUE PROBLEMS, 2013,
  • [28] Mesoscopic simulation of MHD mixed convection of non-newtonian ferrofluids with a non-uniformly heated plate in an enclosure
    Hossain, Amzad
    Nag, Preetom
    Molla, Md Mamun
    PHYSICA SCRIPTA, 2023, 98 (01)
  • [29] Effect of heat generation on mixed convection in porous cavity with sinusoidal heated moving lid and uniformly heated or cooled bottom walls
    Adel Alblawi
    N. Zainuddin
    R. Roslan
    Mohammad Rahimi-Gorji
    N. A. Bakar
    Hoang-Thinh Do
    Microsystem Technologies, 2020, 26 : 1531 - 1542
  • [30] Simulations for MHD mixed convection in a partially heated lid-driven chamfered enclosure
    Akram, Bisma
    Ullah, Naeem
    Nadeem, Sohail
    Eldin, Sayed M. M.
    NUMERICAL HEAT TRANSFER PART A-APPLICATIONS, 2023,