Comparison of single- and two-layer Percoll separation for selection of motile spermatozoa

被引:0
|
作者
Sharma, RK [1 ]
Seifarth, K [1 ]
Agarwal, A [1 ]
机构
[1] Cleveland Clin Fdn, Dept Urol, Androl Res & Clin Labs, Cleveland, OH 44195 USA
关键词
spermatozoa; Percoll separation; viability; hypoosmotic swelling; morphology;
D O I
暂无
中图分类号
R71 [妇产科学];
学科分类号
100211 ;
摘要
Objective-Sperm recovery using a single-layer Percoll procedure is significantly better than using the swim-up technique for infertile men and patients with normal sperm characteristics; however, in normal men results have been contradictory. Some studies have shown further improvement in semen quality with multiple layers. Therefore, this study compared the effect of single-layer and two-layer Percoll procedures on sperm characteristics of normozoospermic men. Methods-Semen specimens from 10 normal donors were processed by layering 1 mt of the liquefied ejaculate on a single layer of 80% Percoll or on a two-layer (47% and 90%) Percoll gradient. Computer-assisted semen analysis was done to examine total motile sperm, percentage of recovery of motile cells, percent motility, curvilinear velocity, linearity, and amplitude of lateral head displacement. Each speciemn was evaluated by the hypo-osmotic swelling (HOS) test, bovine cervical mucus penetration test, viability (eosin-nigrosin stain), and sperm morphology (World Health Organization and Kruger's strict criteria). Results-Specimens processed with the two-layer Percoll procedure had significantly better recovery of spermatozoa, and significantly better percentage motility, linearity, amplitude of lateral head displacement, percentage tail swelling, and percentage viability than those separated on single-layer Percoll. Results for sperm morphology using WHO and Kruger's criteria were similar between the two methods (P = 0.92 for both sets of criteria). Conclusions-In normozoospermic men, the two-layer Percoll separation procedure significantly improves semen characteristics compared with separation on a single layer.
引用
收藏
页码:412 / 417
页数:6
相关论文
共 50 条
  • [21] Experimental investigation and comparison of prestressed single-layer and repaired two-layer reinforced concrete beams
    Iskhakov, Iakov
    Ribakov, Yuri
    Holschemacher, Klaus
    Kaeseberg, Stefan
    STRUCTURAL CONCRETE, 2020, 21 (06) : 2396 - 2407
  • [22] Transport AC Loss Measurements in Single- and Two-Layer Parallel Coated Conductor Arrays With Low Turn Numbers
    Jiang, Zhenan
    Long, N. J.
    Staines, Mike
    Li, Quan
    Slade, R. A.
    Amemiya, Naoyuki
    Caplin, A. D.
    IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY, 2012, 22 (06)
  • [23] BOUNDARY LAYER SEPARATION OF A TWO-LAYER ROTATING FLOW ON AN F PLANE.
    Brevdo, L.
    Merkine, L.
    Proceedings of The Royal Society of London, Series A: Mathematical and Physical Sciences, 1985, 400 (1818) : 75 - 95
  • [24] Flow separation and mixing caused by sills in two-layer flow
    Dittrich, A
    Wang, Y
    Nestmann, F
    ENVIRONMENTAL AND COASTAL HYDRAULICS: PROTECTING THE AQUATIC HABITAT, PROCEEDINGS OF THEME B, VOLS 1 & 2, 1997, 27 : 635 - 640
  • [25] On the gas-separation properties of two-layer porous membranes
    V. M. Zhdanov
    V. I. Roldughin
    E. E. Sherysheva
    Colloid Journal, 2010, 72 : 633 - 639
  • [26] On the gas-separation properties of two-layer porous membranes
    Zhdanov, V. M.
    Roldughin, V. I.
    Sherysheva, E. E.
    COLLOID JOURNAL, 2010, 72 (05) : 633 - 639
  • [27] Laparoscopic single and two-layer vaginal cuff closure
    Ramirez, C.
    Mansuria, S.
    AMERICAN JOURNAL OF OBSTETRICS AND GYNECOLOGY, 2018, 218 (02) : S962 - S962
  • [28] Selection of mold materials for electroforming of monolithic two-layer microstructure
    C. K. Chung
    C. J. Lin
    L. H. Wu
    Y. J. Fang
    Y. Z. Hong
    Microsystem Technologies, 2004, 10 : 467 - 471
  • [29] Planform selection in two-layer Benard-Marangoni convection
    Engel, A
    Swift, JB
    PHYSICAL REVIEW E, 2000, 62 (05): : 6540 - 6553
  • [30] Selection of mold materials for electroforming of monolithic two-layer microstructure
    Chung, CK
    Lin, CJ
    Wu, LH
    Fang, YJ
    Hong, YZ
    MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS, 2004, 10 (6-7): : 467 - 471