EFFECTS OF OXY JET IN CROSS-FLOW ON THE COMBUSTION INSTABILITY AND NOx EMISSIONS IN LEAN PREMIXED FLAME

被引:1
|
作者
Tao, Chengfei [1 ]
Zhou, Hao [1 ]
机构
[1] Zhejiang Univ, State Key Lab Clean Energy Utilizat, Hangzhou, Peoples R China
来源
THERMAL SCIENCE | 2022年 / 26卷 / 03期
关键词
combustion instability; NOx emission; oxygen ratio; premixed flame; oxyfuel; jet in cross-flow; GAS-TURBINE COMBUSTOR; THERMOACOUSTIC INSTABILITIES; AIR INJECTION; N-2; CO2; SUPPRESSION; MIXTURE;
D O I
10.2298/TSCI201215178T
中图分类号
O414.1 [热力学];
学科分类号
摘要
Combustion instability and NOx emission are crucial factors for modern gas turbine combustors, which seriously hampers the research and development of advanced combustors. 7b eliminate combustion instability and NO, emissions simultaneously, effects of the oxy (CO2/O-2, N-2/O-2, Ar/O-2, and He/O-2) jet in cross-flow on combustion instability and NO, emissions are experimentally studied. In this research, the flow rate and oxygen ratio of the combustor are varied to evaluate the control effectiveness. Results denotes that all the four oxyfuel gas: CO2/O-2, N-2/O-2, Ar/O-2, and He/O-2, could suppress combustion instability and NOx emissions. The CO2/O-2 dilution can achieve a better damping results than the other three cases. There are peak values or lowest points of sound pressure amplitude as the parameter of oxy jet in cross-flow changes. Mode transition appears in both acoustic signal and CH - chemiluminescence of the flame. But the turning point of mode transition is different. Under the CO2/O-2 cases, the NO emission decreases from 22.3 ppm to 15.2 ppm, the damping ratio of NOx is 40.39%. The flame shape and length were changed under different jet in cross-flow dilutions. This research could promote the application of jet in cross-flow methods on combustion instability or pollutant emissions in gas turbines.
引用
收藏
页码:2053 / 2067
页数:15
相关论文
共 50 条
  • [31] Improvement of flame stability and NOx reduction in hydrogen-added ultra lean premixed combustion
    Cho, Eun-Seong
    Chung, Suk Ho
    JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, 2009, 23 (03) : 650 - 658
  • [32] The effects of cross-flow fuel injection on the reacting jet in vitiated cross-flow
    Pinchak, Matthew D.
    Shaw, Vincent G.
    Gutmark, Ephraim J.
    COMBUSTION AND FLAME, 2019, 199 : 352 - 364
  • [33] Suppression of combustion instabilities of swirled non-premixed liquid-fuel flame with CO2-O2 jet in cross-flow
    Liu, Zihua
    Zhou, Hao
    Fang, Hao
    Tao, Chengfei
    JOURNAL OF THE ENERGY INSTITUTE, 2021, 95 : 69 - 76
  • [34] Stabilization effects of perforated plates on the combustion instability in a lean premixed combustor
    Oh, Seungtaek
    Shin, Youngjun
    Kim, Yongmo
    APPLIED THERMAL ENGINEERING, 2016, 107 : 508 - 515
  • [35] Correlation analysis of oxy-fuel jet in cross-flow on thermoacoustic instability in a model gas turbine combustor
    Tao, Chengfei
    Zhou, Hao
    AEROSPACE SCIENCE AND TECHNOLOGY, 2020, 106
  • [36] Numerical Study of Emission Characteristics of a Jet Flame in Cross-Flow
    Lawal, M. S.
    Fairweather, M.
    Ingham, D. B.
    Ma, L.
    Pourkashanian, M.
    Williams, A.
    COMBUSTION SCIENCE AND TECHNOLOGY, 2010, 182 (10) : 1491 - 1510
  • [37] Temperature and velocity fluctuations of a jet diffusion flame in a cross-flow
    Tsue, M
    Kadota, T
    Kono, M
    PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2002, 29 (02) : 1937 - 1942
  • [38] On the characteristic flow and flame times for scaling oxy and air flame stabilization modes in premixed swirl combustion
    Taamallah, Soufien
    Chakroun, Nadim W.
    Watanabe, Hirotatsu
    Shanbhogue, Santosh J.
    Ghoniem, Ahmed F.
    PROCEEDINGS OF THE COMBUSTION INSTITUTE, 2017, 36 (03) : 3799 - 3807
  • [39] Combustion via multiple pairs of opposing premixed flames with a cross-flow
    Kamal, M. M.
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART A-JOURNAL OF POWER AND ENERGY, 2017, 231 (01) : 39 - 58
  • [40] Characteristics of a laminar diffusion flame in a cross-flow of combustion products
    Simon, M. A.
    Baird, B. D.
    Gollahalli, S. R.
    PROCEEDINGS OF THE ASME POWER CONFERENCE 2005, PTS A AND B, 2005, : 631 - 638