Coupling effect of axial ultrasonic vibration and tool thread on the microstructure and properties of the friction stir lap welding joint of Al/Mg dissimilar alloys

In this study, three tools with different thread characteristics were designed for the ultrasonic-assisted friction stir lap welding (UAFSLW) of a 3-mm-thick 6061-T6 aluminum alloy and an AZ31 magnesium alloy. The coupling effect of different thread characteristics and axial ultrasonic vibrations on the size, amount, and dis-tribution of intermetallic compounds (IMCs) and the tensile-shear strength of welded joints was analyzed. Experimental results confirmed the formation of IMCs in the stir zone (SZ) and the bottom interface in the SZ in all joints, with Al3Mg2 predominating in the Al-Mg configuration (in which the 6061-T6 aluminum and AZ31 magnesium alloys were placed at the upper and lower plates, respectively) and Al12Mg17 predominating in the Mg-Al configuration (in which the alloys on the upper and lower plates were reversed). The bottom interfaces of the joints in the Mg-Al configuration were tortuous, forming a mechanical interlocking structure; consequently, the joints welded in the Mg-Al configuration exhibited higher tensile-shear strength than those welded in the Al -Mg configuration. Furthermore, the tool with a variable-pitch thread pin achieved welds with excellent tensile-shear strength in both the configurations (223.2 and 268.3 N/mm in the Al-Mg and Mg-Al configurations, respectively). This performance improvement was attributed to the strong coupling of the tool with axial ul-trasonic vibrations, which enlarged the mixing zone and increased the uniformity of the IMCs distribution in the joints.