Effect of beam offset on microstructure and mechanical properties of dissimilar electron beam welded high temperature titanium alloys

Electron beam welding was used to join dissimilar Ti55 to TA15 titanium alloys. The aim of this study was to investigate the effect of the beam offset on microstructure and mechanical properties of the welded joints. Micro structural characterization was investigated by optical microscopy, scanning electron microscopy and X-ray diffraction. Tensile test was conducted at room temperature and 550 C-omicron. Results indicated that the fusion zone consisted of martensite alpha' and acicular alpha. Heat affected zone (HAZ) in both Ti55 and TA15 sides consisted of two regions; Low temperature HAZ (LT-HAZ) was composed of primary alpha, secondary alpha and prior beta and high temperature HAZ (HT-HAZ) was composed of martensite alpha' and acicular alpha. The hardness of fusion zone was lower than HAZ of both Ti55 and TA15 alloy. Energy-dispersive spectroscopy was applied to display microstructure evolution inside the fusion zone. Tensile results showed that offsetting the beam position towards Ti55 alloy led to higher values of joint strength. Beam offsetting towards TA15 alloy lowered the hardness and strength of welded joints. Increasing the beam offset to the values > 0.3 mm towards Ti55 or TA15 resulted in premature fracture due to increasing the possibility of porosity formation inside the weld metal. (C) 2017 Elsevier Ltd. All rights reserved.