Effect of heterogeneity and anisotropy related to the construction method on transfer processes in waste rock piles

被引:27
|
作者
Lahmira, Belkacem [1 ]
Lefebvre, Rene [1 ]
Aubertin, Michel [2 ]
Bussiere, Bruno [3 ]
机构
[1] Ctr Eau Terre Environm INRS ETE, Inst Natl Rech Sci, Quebec City, PQ, Canada
[2] Ecole Polytech, Dept Genies Civil Geol & Mines CGM, Montreal, PQ H3C 3A7, Canada
[3] Univ Quebec Abitibi Temiscamingue, Rouyn Noranda, PQ, Canada
基金
加拿大自然科学与工程研究理事会;
关键词
Acid mine drainage; Multiphase fluid flow; Preferential flow; Heterogeneity; Anisotropy; ACID-MINE DRAINAGE; MULTIPHASE TRANSFER PROCESSES; PREFERENTIAL FLOW; CONCEPTUAL-MODEL; UNSTABLE FLOW; WATER-FLOW; HYDRAULIC CONDUCTIVITY; TRANSPORT PROCESSES; UNSATURATED ZONES; SOIL-STRUCTURE;
D O I
10.1016/j.jconhyd.2015.12.002
中图分类号
X [环境科学、安全科学];
学科分类号
08 ; 0830 ;
摘要
Waste rock piles producing acid mine drainage (AMD) are partially saturated systems involving multiphase (gas and liquid) flow and coupled transfer processes. Their internal structure and heterogeneous properties are inherited from their wide-ranging material grain sizes, their modes of deposition, and the underlying topography. This paper aims at assessing the effect of physical heterogeneity and anisotropy of waste rock piles on the physical processes involved in the generation of AMD. Generic waste rock pile conditions were represented with the numerical simulator TOUGH AMD based on those found at the Doyon mine waste rock pile (Canada). Models included four randomly distributed material types (coarse, intermediate, fine and very fine-grained). The term "randomly" as used in this study means that the vertical profile and spatial distribution of materials in waste rock piles (internal structure) defy stratigraphy principles applicable to natural sediments (superposition and continuity). The materials have different permeability and capillary properties, covering the typical range of materials found in waste rock piles. Anisotropy with a larger horizontal than vertical permeability was used to represent the effect of pile construction by benches, while the construction by end-dumping was presumed to induce a higher vertical than horizontal permeability. Results show that infiltrated precipitation preferentially flows in fine-grained materials, which remain almost saturated, whereas gas flows preferentially through the most permeable coarse materials, which have higher volumetric gas saturation. Anisotropy, which depends on pile construction methods, often controls global gas flow paths. Construction by benches favours lateral air entry close to the pile slope, whereas end-dumping leads to air entry from the surface to the interior of the pile by secondary gas convection cells. These results can be useful to construct and rehabilitate waste rock piles to minimize AMD, while controlling gas flow and oxygen supply. (C) 2015 Elsevier B.V. All rights reserved.
引用
收藏
页码:35 / 49
页数:15
相关论文
共 49 条
  • [31] The Shear Effect of Large-Diameter Piles under Different Lateral Loading Levels: The Transfer Matrix Method
    Liu, Jing
    Zhu, Mingxing
    Li, Xiaojuan
    Ling, Chen
    Wang, Tengfei
    Li, Xuan
    BUILDINGS, 2024, 14 (05)
  • [32] Stability analysis of soil slopes stabilized by piles considering effect of soil anisotropy using upper-bound method of limit analysis
    Nian, Ting-Kai
    Luan, Mao-Tian
    Yang, Qing
    Dalian Ligong Daxue Xuebao/Journal of Dalian University of Technology, 2005, 45 (06): : 858 - 864
  • [33] A novel network construction method based on degenerative chain transfer effect to toughen hydrogels
    Wang, Yi
    Ouyang, Hongyan
    Zhao, Lijuan
    Wu, Jinrong
    POLYMER, 2021, 231
  • [34] Simulation of hydro-mechanically coupled processes in rough rock fractures using an immersed boundary method and variational transfer operators
    Cyrill von Planta
    Daniel Vogler
    Xiaoqing Chen
    Maria G. C. Nestola
    Martin O. Saar
    Rolf Krause
    Computational Geosciences, 2019, 23 : 1125 - 1140
  • [35] Simulation of hydro-mechanically coupled processes in rough rock fractures using an immersed boundary method and variational transfer operators
    von Planta, Cyrill
    Vogler, Daniel
    Chen, Xiaoqing
    Nestola, Maria G. C.
    Saar, Martin O.
    Krause, Rolf
    COMPUTATIONAL GEOSCIENCES, 2019, 23 (05) : 1125 - 1140
  • [36] Load transfer method of rock-socketed anchoring rods under pile tip considering dilatancy effect
    Zhao Ming-hua
    Long Zhao
    Zou Xin-jun
    ROCK AND SOIL MECHANICS, 2008, 29 (07) : 1938 - 1942
  • [37] Modeling field-scale multiple tracer injection at a low-level waste disposal site in fractured rocks: Effect of multiscale heterogeneity and source term uncertainty on conceptual understanding of mass transfer processes
    Gwo, JP
    Jardine, PM
    Sanford, WE
    JOURNAL OF CONTAMINANT HYDROLOGY, 2005, 77 (1-2) : 91 - 118
  • [38] Bond properties and anisotropy performance of 3D-printed construction and demolition waste-based geopolymers: Effect of operational- and material-oriented parameters
    Ozkilic, Hamza
    Ilcan, Huseyin
    Aminipour, Ehsan
    Tugluca, Merve Sonmez
    Aldemir, Alper
    Sahmaran, Mustafa
    JOURNAL OF BUILDING ENGINEERING, 2023, 78
  • [39] A semi-analytical method for calculation of displacement and stress in processes of 3D water flow and heat transfer in a saturated sparsely fractured rock mass
    Zhang Yong
    Xiang Yan-yong
    ROCK AND SOIL MECHANICS, 2016, 37 (12) : 3481 - 3490
  • [40] MEASURING THE HUMAN HEAD-RELATED TRANSFER-FUNCTIONS - A NOVEL METHOD FOR THE CONSTRUCTION AND CALIBRATION OF A MINIATURE IN-EAR RECORDING-SYSTEM
    PRALONG, D
    CARLILE, S
    JOURNAL OF THE ACOUSTICAL SOCIETY OF AMERICA, 1994, 95 (06): : 3435 - 3444