Effect of segmental baffles on the shell-and-tube heat exchanger effectiveness

被引：9

作者：

Vukic, Mica V. ^{[1
]}

Tomic, Mladen A. ^{[2
]}

Zivkovic, Predrag M. ^{[1
]}

Ilic, Gradimir S. ^{[1
]}

机构：

[1] Univ Nis, Fac Mech Engn, Nish, Serbia

[2] Sch Higher Tech Profess Educ, Nish, Serbia

来源：

HEMIJSKA INDUSTRIJA | 2014年 / 68卷 / 02期

关键词：

shell and tube heat exchanger; experiment; effectiveness; baffles; PRESSURE-DROP;

D O I：

10.2298/HEMIND130127041V

中图分类号：

TQ [化学工业];

学科分类号：

0817 ;

摘要：

The results of the experimental investigations of fluid flow and heat transfer in laboratory experimental shell-and-tube heat exchanger are presented in this paper. Shell-and-tube heat exchanger is with one pass of warm water on the shell side and two passes of cold water in tube bundle. Shell-and-tube heat exchanger is with 24x2 tubes (U-tube) in triangle layout. During each experimental run, the pressure drops and the fluid temperatures on shell side, along the shell-and-tube heat exchanger (at positions defined in advance) have been measured. The special attention was given to the investigation of the segmental baffles number influence of the shell-and-tube heat exchanger effectiveness.

引用

页码：171 / 177

页数：7

共 50 条

[31] Effectiveness improvement and optimization of shell-and-tube heat exchanger with entransy method
Chahartaghi, Mahmood
Eslami, Pouya
Naminezhad, Alireza
HEAT AND MASS TRANSFER, 2018, 54 (12) : 3771 - 3784
[32] Shell and tube heat exchanger with new segmental baffles configurations: A comparative experimental investigation
El-Said, Emad M. S.
Abou Al-Sood, M. M.
APPLIED THERMAL ENGINEERING, 2019, 150 : 803 - 810
[33] Comparison of Performance of Shell-and-Tube Heat Exchangers with Conventional Segmental Baffles and Continuous Helical Baffle
Ahmed, Asif
Ferdous, Imam Ul
Saha, Sumon
7TH BSME INTERNATIONAL CONFERENCE ON THERMAL ENGINEERING (ICTE), 2017, 1851
[34] Numerical investigation on the multi-objective optimization of a shell-and-tube heat exchanger with helical baffles
Wen, Jian
Gu, Xin
Wang, Mengmeng
Wang, Simin
Tu, Jiyuan
INTERNATIONAL COMMUNICATIONS IN HEAT AND MASS TRANSFER, 2017, 89 : 91 - 97
[35] Multi-objective optimization on the structural parameters of shell-and-tube heat exchanger with helical baffles
School of Chemical Engineering and Technology, Xi'an Jiaotong University, Xi'an
710049, China
不详
710049, China
Hsi An Chiao Tung Ta Hsueh, 11 (14-19 and 109):
[36] Configuration Optimization of a Shell-and-Tube Heat Exchanger with Segmental Baffles Based on Combination of NSGAII and MOPSO Embedded Grouping Cooperative Coevolution Strategy
Xu, Zhe
Ning, Xin
Li, Rui
Wan, Xiuying
Zhao, Changyin
PROCESSES, 2023, 11 (11)
[37] NUMERICAL STUDIES OF A NOVEL COMBINED MULTIPLE SHELL-PASS SHELL-AND-TUBE HEAT EXCHANGER WITH HELICAL BAFFLES
Wang, Qiuwang
Chen, Guidong
Chen, Qiuyang
Zeng, Min
Zhang, Dahai
HT2008: PROCEEDINGS OF THE ASME SUMMER HEAT TRANSFER CONFERENCE - 2008, VOL 2, 2009, : 23 - 31
[38] Numerical investigation on combined multiple shell-pass shell-and-tube heat exchanger with continuous helical baffles
Wang, Qiuwang
Chen, Qiuyang
Chen, Guidong
Zeng, Min
INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER, 2009, 52 (5-6) : 1214 - 1222
[39] Experimental performance comparison of shell-side heat transfer for shell-and-tube heat exchangers with middle-overlapped helical baffles and segmental baffles
Zhang, Jian-Fei
Li, Bin
Huang, Wen-Jiang
Lei, Yong-Gang
He, Ya-Ling
Tao, Wen-Quan
CHEMICAL ENGINEERING SCIENCE, 2009, 64 (08) : 1643 - 1653
[40] Exergoeconomic optimization of a shell-and-tube heat exchanger
Jamil, Muhammad Ahmad
Goraya, Talha S.
Shahzad, Muhammad Wakil
Zubair, Syed M.
ENERGY CONVERSION AND MANAGEMENT, 2020, 226

← 1 2 3 4 5 →