Study on the transmission efficiency of electro-mechanical continuously variable transmission with adjustable clamping force

被引：15
|
作者：
Liu, Junlong [1 ,2 ]
Sun, Dongye [1 ,2 ]
Ye, Ming [3 ]
Liu, Xiaojun [1 ,2 ]
Li, Baogang [1 ,2 ]
机构：
[1] Chongqing Univ, State Key Lab Mech Transmiss, Chongqing 400044, Peoples R China
[2] Chongqing Univ, Sch Automot Engn, Chongqing 400044, Peoples R China
[3] Chongqing Univ Technol, Key Lab Mfg Test Tech Automobile Parts, Minist Educ, Chongqing 400054, Peoples R China
来源：
MECHANISM AND MACHINE THEORY | 2018年 / 126卷
基金：
中国国家自然科学基金;
关键词：
Continuously variable transmission; Electro-mechanical actuator; Frictional energy loss; Transmission efficiency; LOSS MECHANISMS; RATIO CONTROL; BELT; CVT; LOSSES; FRICTION;
D O I：
10.1016/j.mechmachtheory.2018.04.012
中图分类号：
TH [机械、仪表工业];
学科分类号：
0802 ;
摘要：
The purpose of this study is to analyze the EMCVT transmission efficiency. Power loss of a continuously variable transmission (CVT) consists of the energy consumed by an actuator and frictional energy loss in a CVT variator. The objective of studying electro-mechanical continuously variable transmission (EMCVT) is reducing the energy consumed by a CVT actuator. However, power loss resulting from frictional loss may increase owing to increases in the driven pulley clamping force. And then a simplified transmission efficiency model of an EMCVT was established to analyze the energy consumed by an electro-mechanical actuator and frictional energy loss. Under ECE (Economic Commission for Europe) and EUDC (Extra Urban Driving Cycle) driving cycles, the energy consumed by an EMCVT is compared with that consumed by an electro-hydraulic CVT (EHCVT). Comparison results indicate that the EMCVT transmission efficiency is lower than that of an EHCVT. Thus, an EMCVT with two actuator motors is proposed to reduce the frictional energy loss in the variator. Simulation results indicate that the transmission efficiency of the proposed EMCVT exceeds that of an EHCVT. The frictional energy loss is reduced by controlling the driven pulley clamping force, and this improves the EMCVT transmission efficiency. (C) 2018 Elsevier Ltd. All rights reserved.
引用
收藏
页码：468 / 478
页数：11
相关论文
共 50 条
  • [31] Study on the improvement in continuously variable transmission efficiency with a thermal management system
    Park, Minje
    Jung, Daebong
    Kim, Minjae
    Min, Kyoungdoug
    APPLIED THERMAL ENGINEERING, 2013, 61 (02) : 11 - 19
  • [32] Clamping Force Control of Sensor-less Electro-Mechanical Brake Actuator
    Wei, Zhen
    Xu, John
    Halim, Dunant
    2017 IEEE INTERNATIONAL CONFERENCE ON MECHATRONICS AND AUTOMATION (ICMA), 2017, : 764 - 769
  • [33] Design and implementation of a new clamping force estimator in Electro-Mechanical Brake systems
    Y. H. Ki
    K. J. Lee
    J. S. Cheon
    H. S. Ahn
    International Journal of Automotive Technology, 2013, 14 : 739 - 745
  • [34] DESIGN AND IMPLEMENTATION OF A NEW CLAMPING FORCE ESTIMATOR IN ELECTRO-MECHANICAL BRAKE SYSTEMS
    Ki, Y. H.
    Lee, K. J.
    Cheon, J. S.
    Ahn, H. S.
    INTERNATIONAL JOURNAL OF AUTOMOTIVE TECHNOLOGY, 2013, 14 (05) : 739 - 745
  • [35] Meshing force research of planetary gear for hydro-mechanical continuously variable transmission
    Xiao, Maohua (xiaomaohua@njau.edu.cn), 2018, Asian Association for Agricultural Engineering (27):
  • [36] Microcontroller Based Proportional Derivative Plus Conditional Integral Controller for Electro-Mechanical Dual Acting Pulley Continuously Variable Transmission Ratio Control
    Budianto, A.
    Tawi, K. B.
    Hussein, M.
    Supriyo, B.
    Ariyono, S.
    Kob, M. S. Che
    Zulkifli, Mohd Ezlamy
    Khairuldean, A. K.
    Daraoh, Aishah
    1ST INTERNATIONAL CONFERENCE ON MECHANICAL ENGINEERING RESEARCH 2011 (ICMER2011), 2012, 36
  • [37] Experimental and simulation-based investigation of power consumption of an electro-mechanical dual acting pulley continuously variable transmission for electric vehicle powertrain
    Mazali, Izhari Izmi
    Daud, Zul Hilmi Che
    Kob, Mohd Salman Che
    Hamid, Mohd Kameil Abdul
    Jubair, Abdullah
    Abu Bakar, Saiful Anuar
    Abu Husain, Nurulakmar
    Ab Talib, Mat Hussin
    RESULTS IN ENGINEERING, 2025, 25
  • [38] TESTING FUEL EFFICIENCY OF A TRACTOR WITH A CONTINUOUSLY VARIABLE TRANSMISSION
    Coffman, B. A.
    Kocher, M. F.
    Adamchuk, V. I.
    Hoy, R. M.
    Blankenship, E. E.
    APPLIED ENGINEERING IN AGRICULTURE, 2010, 26 (01) : 31 - 36
  • [39] Research on the dynamic power control strategy of the two-mode electro-mechanical variable transmission
    Wang, Weida
    Liu, Hui
    Han, Lijin
    Ma, Wenjie
    Han, Quanfu
    Jixie Gongcheng Xuebao/Journal of Mechanical Engineering, 2015, 51 (12): : 101 - 109
  • [40] Research on a novel discrete adjustable radiuses type continuously variable transmission
    Lin, Xiaochuan
    Peng, Yun
    Hong, Rongjing
    Wang, Yawen
    MECCANICA, 2022, 57 (05) : 1155 - 1171
12345