Improved Poly(3,4-Ethylenedioxythiophene) (PEDOT) for Neural Stimulation

被引:34
|
作者
Mandal, Himadri Shekhar [1 ]
Kastee, Jemika Shrestha [1 ]
McHail, Daniel Glenn [2 ]
Rubinson, Judith Faye [3 ]
Pancrazio, Joseph Jewell [1 ]
Dumas, Theodore Constantine [2 ]
机构
[1] George Mason Univ, Dept Bioengn, 4400 Univ Dr,MS 1G5, Fairfax, VA 22030 USA
[2] George Mason Univ, Krasnow Inst Adv Study, Dept Mol Neurosci, Fairfax, VA 22030 USA
[3] Georgetown Univ, Dept Chem, Washington, DC 20057 USA
来源
NEUROMODULATION | 2015年 / 18卷 / 08期
关键词
Conductive polymer; neural stimulation; PEDOT; SILICON MICROELECTRODE ARRAYS; TISSUE-RESPONSE; MORPHOLOGY; IRIDIUM; FILMS; ENCAPSULATION; ELECTRODES; INTERFACES; STABILITY; CORTEX;
D O I
10.1111/ner.12285
中图分类号
R-3 [医学研究方法]; R3 [基础医学];
学科分类号
1001 ;
摘要
Objective: This study compares the stability of three variations of the conductive polymer poly(3,4-ethylenedioxythiophene) or PEDOT for neural micro-stimulation under both in vitro and in vivo conditions. We examined PEDOT films deposited with counterions tetrafluoroborate (TFB) and poly(styrenesulfonate) (PSS), and PEDOT:PSS combined with carbon nanotubes (CNTs). Methods: For the in vitro stability evaluation, implantable micro-wires were coated with the polymers, placed in a vial containing phosphate buffered saline (PBS) under accelerated aging conditions (60 degrees C), and current pulses were applied. The resulting voltage profile was monitored over time. Following the same polymer deposition protocol, chronic neural micro-probes were modified and implanted in the motor cortex of two rats for the in vivo stability comparison. Similar stimulating current pulses were applied and the output voltage was examined. The electrochemical impedance spectroscopic (EIS) data were also recorded and fit to an equivalent circuit model that incorporates and quantifies the time-dependent polymer degradation and impedance associated with tissue surrounding each micro-electrode site. Results: Both in vitro and in vivo voltage output profiles show relatively stable behavior for the PEDOT:TFB modified micro-electrodes compared to the PEDOT:PSS and CNT:PEDOT:PSS modified ones. EIS modeling demonstrates that the time-dependent increase in the polymeric resistance is roughly similar to the rise in the respective voltage output in vivo and indicates that the polymeric stability and conductivity, rather than the impedance due to the tissue response, is the primary factor determining the output voltage profile. It was also noted that the number of electrodes showing unit activity post-surgery did not decay for PEDOT:TFB as was the case for PEDOT:PSS and CNT:PEDOT:PSS. Conclusions: PEDOT:TFB may be an enabling material for achieving long lasting micro-stimulation and recording.
引用
收藏
页码:657 / 663
页数:7
相关论文
共 50 条
  • [31] Thiophene oligomer as a 'redox mediator' for the biocatalytic synthesis of Poly(3,4-ethylenedioxythiophene) [PEDOT].
    Nagarajan, R
    Bruno, FF
    Samuelson, LA
    Kumar, J
    ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 2004, 228 : U398 - U398
  • [32] Poly(3,4-ethylenedioxythiophene) (PEDOT) Coatings for High-Quality Electromyography Recording
    Rossetti, Nicola
    Luthra, Prabhjot
    Hagler, Jo'Elen
    Lee, Ada Hyun Jae
    Bodart, Come
    Li, Xinda
    Ducharme, Guillaume
    Soavi, Francesca
    Amilhon, Benedicte
    Cicoira, Fabio
    ACS APPLIED BIO MATERIALS, 2019, 2 (11): : 5154 - 5163
  • [33] "Click"-modification of a functionalized poly(3,4-ethylenedioxythiophene) (PEDOT) soluble in organic solvents
    Bu, Hang-Beom
    Goetz, Guenther
    Reinold, Egon
    Vogt, Astrid
    Azumi, Reiko
    Segura, Jose L.
    Baeuerle, Peter
    CHEMICAL COMMUNICATIONS, 2012, 48 (21) : 2677 - 2679
  • [34] In situ electrochemical polymerization of poly(3,4-ethylenedioxythiophene) (PEDOT) for peripheral nerve interfaces
    Jamie M. Murbach
    Seth Currlin
    Adrienne Widener
    Yuxin Tong
    Shrirang Chhatre
    Vivek Subramanian
    David C. Martin
    Blake N. Johnson
    Kevin J. Otto
    MRS Communications, 2018, 8 : 1043 - 1049
  • [35] Non-mechanical variable apertures based on poly(3,4-ethylenedioxythiophene) (PEDOT)
    Roth, S.
    Ignatowitz, M.
    Mueller, P.
    Moench, W.
    Oesterschulze, E.
    MICROELECTRONIC ENGINEERING, 2011, 88 (08) : 2349 - 2351
  • [36] Comparisons of the Thermal Stability of Poly(3,4-Ethylenedioxythiophene) (PEDOT) and ITO on Flexible Substrates
    Alzoubi, Khalid
    Alkhazali, Atif S.
    Choi, Gihoon
    Hamasha, Mohammad M.
    Albahri, Shehab
    DeFranco, John
    Lu, Susan
    Westgate, Charles R.
    IEEE TRANSACTIONS ON COMPONENTS PACKAGING AND MANUFACTURING TECHNOLOGY, 2020, 10 (08): : 1259 - 1265
  • [37] Poly(3,4-ethylenedioxythiophene)-tosylate (PEDOT-Tos) electrodes in thermogalvanic cells
    Wijeratne, Kosala
    Vagin, Mikhail
    Brooke, Robert
    Crispin, Xavier
    JOURNAL OF MATERIALS CHEMISTRY A, 2017, 5 (37) : 19619 - 19625
  • [38] Poly(3,4-ethylenedioxythiophene) (PEDOT) prepared via electrochemical polymerization of EDOT, 2,2'-bis(3,4-ethylenedioxythiophene) (BiEDOT), and their TMS derivatives
    Sotzing, GA
    Reynolds, JR
    Steel, PJ
    ADVANCED MATERIALS, 1997, 9 (10) : 795 - &
  • [39] Poly(3,4-ethylenedioxythiophene)-Based Neural Interfaces for Recording and Stimulation: Fundamental Aspects and In Vivo Applications
    Bianchi, Michele
    De Salvo, Anna
    Asplund, Maria
    Carli, Stefano
    Di Lauro, Michele
    Schulze-Bonhage, Andreas
    Stieglitz, Thomas
    Fadiga, Luciano
    Biscarini, Fabio
    ADVANCED SCIENCE, 2022, 9 (12)
  • [40] Phenyl substituted poly(3,4-ethylenedioxythiophene).
    Kumar, A
    Morvant, MC
    Reynolds, JR
    ABSTRACTS OF PAPERS OF THE AMERICAN CHEMICAL SOCIETY, 1997, 213 : 87 - POLY