The nonlinear vibration analysis of a clamped-clamped beam by a reduced multibody method

被引:3
|
作者
Kovacs, AP [1 ]
Ibrahim, RA [1 ]
机构
[1] WAYNE STATE UNIV,DEPT MECH ENGN,DETROIT,MI 48202
关键词
d'Alembert principle; reduced multibody method; constrained flexibility; nonlinear vibration; Galerkin's method; checking function; differential and algebraic equations (DAE); bifurcation;
D O I
10.1007/BF00044998
中图分类号
TH [机械、仪表工业];
学科分类号
0802 ;
摘要
The nonlinear response characteristics for adynamic system with a geometric nonlinearity is examined using a multibody dynamics method. The planar system is an initially straight clamped-clamped beam subject to high frequency excitation in the vicinity of its third natural mode. The model includes a pre-applied static axial load, linear bending stiffness and a cubic in-plane stretching force. Constrained flexibility is applied to a multibody method that lumps the beam into N elements for three substructures subjected to the nonlinear partial differential equation of motion and N - 1 linear modal constraints. This procedure is verified by d'Alembert's principle and leads to a discrete form of Galerkin's method. A finite difference scheme models the elastic forces. The beam is tuned by the axial force to obtain fourth order internal resonance that demonstrates bimodal and trimodal responses in agreement with low and moderate excitation test results. The continuous Galerkin method is shown to generate results conflicting with the test and multibody method. A new checking function based on Gauss' principle of least constraint is applied to the beam to minimize modal constraint error.
引用
收藏
页码:121 / 141
页数:21
相关论文
共 50 条
  • [41] Dynamics Modeling and Synchronization Control of Clamped-Clamped Beam MEM Silicon Resonator
    Chang S.
    Sun J.
    Dianzi Keji Daxue Xuebao/Journal of the University of Electronic Science and Technology of China, 2023, 52 (03): : 475 - 480
  • [42] Control of transversal vibrations of a clamped-clamped beam by a permanent magnet and a shunt circuit
    Stein, G. J.
    Darula, R.
    Sorokin, S.
    PROCEEDINGS OF THE 8TH INTERNATIONAL CONFERENCE ON STRUCTURAL DYNAMICS, EURODYN 2011, 2011, : 1735 - 1741
  • [43] Experimental validation of hardening and softening resonances in a clamped-clamped beam MEMS resonator
    Mestrom, R. M. C.
    Fey, R. H. B.
    Phan, K. L.
    Nijmeijer, H.
    PROCEEDINGS OF THE EUROSENSORS XXIII CONFERENCE, 2009, 1 (01): : 812 - +
  • [44] Analysis of tension-tunable clamped-clamped piezoelectric beams for harvesting energy from wind and vibration
    Chatterjee, Punnag
    Bryant, Matthew
    JOURNAL OF INTELLIGENT MATERIAL SYSTEMS AND STRUCTURES, 2019, 30 (16) : 2405 - 2420
  • [45] Simulations and experiments of hardening and softening resonances in a clamped-clamped beam MEMS resonator
    Mestrom, R. M. C.
    Fey, R. H. B.
    Phan, K. L.
    Nijmeijer, H.
    SENSORS AND ACTUATORS A-PHYSICAL, 2010, 162 (02) : 225 - 234
  • [46] Analysis of clamped-clamped piezoelectric energy harvester under vortex induced vibration considering the stretching effect
    Alimanesh, Mobin
    Zamanian, Mehdi
    JOURNAL OF INTELLIGENT MATERIAL SYSTEMS AND STRUCTURES, 2024, 35 (03) : 333 - 351
  • [47] A CLAMPED-CLAMPED BEAM STATIC SAG LIMITS UNDER PERPENDICULAR MAGNETIC FORCE
    Stein, G. J.
    Darula, R.
    Chmurny, R.
    ENGINEERING MECHANICS 2011, 2011, : 567 - 570
  • [48] Dynamic characteristics of rotating pretwisted clamped-clamped beam under thermal stress
    Zhang, Bo
    Li, Yueming
    Lu, Wei-Zhen
    JOURNAL OF MECHANICAL SCIENCE AND TECHNOLOGY, 2016, 30 (09) : 4031 - 4042
  • [49] Study of the nonlinearities in micromechanical clamped-clamped beam resonators using stroboscopic SEM
    Shao, L. C.
    Wong, C. L.
    Palaniapan, M.
    JOURNAL OF MICROMECHANICS AND MICROENGINEERING, 2008, 18 (08)
  • [50] A theoretical and experimental investigation on large amplitude free vibration behavior of a pretensioned beam with clamped-clamped ends using modified homotopy perturbation method
    Rezaee, Mousa
    Minaei, Masoud
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE, 2016, 230 (10) : 1615 - 1625