Pt4ZrO2/C cathode catalyst for improved durability in high temperature PEMFC based on H3PO4 doped PBI

In this paper, Pt4ZrO2/C was prepared and compared with commercial Pt/C (46.6 wt.% TKK) in terms of the durability as cathode catalyst in a high temperature proton exchange membrane fuel cell (PEMFC) based on H3PO4 doped polybenzimidazole (PBI) by a potential sweep test. The catalysts before and after the potential sweep test were characterized by rotating disk electrode (RDE), Xray diffraction (XRD), transmission electron microscopy (TEM) and inductively coupled plasma-atomic emission spectroscopy (ICP-AES). After 3000 cycles potential sweep test, the overall performance loss of the Pt4ZrO2/C membrane electrode assembly (MEA) was less than that of the Pt/C MEA. The RIDE results demonstrated that the oxygen reduction reaction (ORR) activity of the as-prepared Pt4ZrO2/C is nearly the same as TKK-Pt/C. The XRD and TEM results showed that Pt4ZrO2/C catalyst presented higher sintering resistance than commercial Pt/C catalyst during the potential sweep test. This may be attributed to the addition of ZrO2, which acts an anchor to inhibit the adjacent platinum particles to agglomerate. The ICP-AES results Of Pt4ZrO2/C cathode catalyst before and after the potential sweep test showed that the composition of Pt and Zr were very near the nominal atomic ratio of Pt:Zr, which reflected that Pt4ZrO2/C catalyst had a good stability during the potential sweep test. In brief, the preliminary results indicate that Pt4ZrO2/C catalyst is a good candidate of Pt/C catalyst in high temperature PEMFC based on H3PO4 doped PBI for achieving longer cell life-time and higher cell performance. (c) 2006 Elsevier B.V. All rights reserved.