Optimization of surface treatment to enhance fiber-matrix interface and performance of composites

Oxidation treatment with concentrated HNO3 was employed to the carbon fabric (CF) for various time intervals (30-180 min) to observe the effect of treatment on two simultaneous processes involved viz. improvement in its adhesion with the matrix and reduction of fiber strength which in turn is responsible for change in the performance properties of composites. Seven composites with untreated and acid treated CF were developed based on the polyetherimide (PEI) matrix and evaluated for adhesive wear properties under various loads (200-600 N) against mild steel disc. 90 min treated CF composite indicated the best tribological properties and showed 30% reduction in specific wear rate (K-0) and 23% in coefficient of friction (mu) respectively at 600 N load. Treatment beyond this time proved detrimental for improvement in properties. Field emission scanning electron microscopy (FE-SEM) showed increase in roughness with treatment time, while atomic force microscopy (AFM) studies indicated substantial increase in roughness value. Scanning electron microscopy (SEM) of worn surfaces supported the wear mechanisms and improvement in adhesion between fiber and matrix. (C) 2011 Elsevier B.V. All rights reserved.