Modelling of isothermal formation of pearlite and subsequent reaustenitisation in eutectoid steel during continuous heating

被引：10
|
作者：
Caballero, FG
Capdevila, C
de Andrés, CG
机构：
[1] CSIC, Ctr Nacl Invest Met, Dept Met Phys, Madrid 28040, Spain
[2] Univ Cambridge, Dept Mat Sci & Met, Cambridge CB2 3QZ, England
来源：
MATERIALS SCIENCE AND TECHNOLOGY | 2001年 / 17卷 / 06期
关键词：
D O I：
10.1179/026708301101510401
中图分类号：
T [工业技术];
学科分类号：
08 ;
摘要：
Three different morphologies of pearlite have been formed isothermally at three different temperatures in a eutectoid steel. Moreover, the interlamellar spacing of the pearlite was calculated using the Zener and Hillert theoretical method. Experimental results suggest that the growth of pearlite is mainly controlled by volume diffusion of carbon in austenite, in the temperature range studied in this steel, In addition, a model that describes pearlite to austenite transformation during continuous heating in a eutectoid steel has been developed. The influence of structural parameters, such as interlamellar spacing and edge length of pearlite colonies, an the transformation kinetics has been experimentally studied and considered in the modeling. It has been found that the kinetics of pearlite to austenite transformation are slower the coarser the initial pearlite microstructure, Experimental validation of this model has been carried out and a good agreement (an accuracy level of higher than 90% in square correlation factor) between the experimental and calculated values has been found.
引用
收藏
页码：686 / 692
页数：7
相关论文
共 50 条
  • [1] ISOVELOCITY AND ISOTHERMAL PEARLITE GROWTH IN A EUTECTOID STEEL
    CHEETHAM, D
    RIDLEY, N
    JOURNAL OF THE IRON AND STEEL INSTITUTE, 1973, 211 (SEP): : 648 - 652
  • [2] Cluster formation of pearlite colonies during the austenite/pearlite phase transformation in eutectoid steel
    Offerman, SE
    van Wilderen, LJGW
    van Dijk, NH
    Rekveldt, MT
    Sietsma, J
    van der Zwaag, S
    PHYSICA B-CONDENSED MATTER, 2003, 335 (1-4) : 99 - 103
  • [3] ISOTHERMAL TRANSFORMATION OF AUSTENITE TO PEARLITE AND UPPER BAINITE IN EUTECTOID STEEL
    KENNON, NF
    KAYE, NA
    METALLURGICAL TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 1982, 13 (06): : 975 - 978
  • [4] KINETICS OF PEARLITE TRANSFORMATION OF A EUTECTOID STEEL BY CONTINUOUS COOLING
    RUSSEV, K
    BUDUROV, S
    DANAILOV, D
    LAZAROWA, T
    ZEITSCHRIFT FUR METALLKUNDE, 1974, 65 (11): : 686 - 691
  • [5] Modelling of kinetics and dilatometric behavior of non-isothermal pearlite-to-austenite transformation in an eutectoid steel
    de Andres, CG
    Caballero, FG
    Capdevila, C
    Bhadeshia, HKDH
    SCRIPTA MATERIALIA, 1998, 39 (06) : 791 - 796
  • [6] Influence of pearlite morphology and heating rate on the kinetics of continuously heated austenite formation in a eutectoid steel
    Caballero, FG
    Capdevila, C
    De Andrés, CG
    METALLURGICAL AND MATERIALS TRANSACTIONS A-PHYSICAL METALLURGY AND MATERIALS SCIENCE, 2001, 32 (06): : 1283 - 1291
  • [7] Influence of pearlite morphology and heating rate on the kinetics of continuously heated austenite formation in a eutectoid steel
    F. G. Caballero
    C. Capdevila
    C. García de Andrés
    Metallurgical and Materials Transactions A, 2001, 32 : 1283 - 1291
  • [8] PARTITIONING OF SILICON DURING PEARLITE GROWTH IN A EUTECTOID STEEL
    ALSALMAN, SA
    LORIMER, GW
    RIDLEY, N
    ACTA METALLURGICA, 1979, 27 (08): : 1391 - 1400
  • [9] PARTITIONING OF CO DURING PEARLITE GROWTH IN A EUTECTOID STEEL
    RIDLEY, N
    BURGESS, D
    METAL SCIENCE, 1984, 18 (01): : 7 - 11
  • [10] In-situ study of pearlite nucleation and growth during isothermal austenite decomposition in nearly eutectoid steel
    Offerman, SE
    van Wilderen, LJGW
    van Dijk, NH
    Sietsma, J
    Rekveldt, MT
    van der Zwaag, S
    ACTA MATERIALIA, 2003, 51 (13) : 3927 - 3938
12345