Critical Analysis of Coefficient of Friction Derivation Methods for Fretting under Gross Slip Regime

被引：22

作者：

Llavori, I. ^{[1
]}

Zabala, A. ^{[1
]}

Aginagalde, A. ^{[1
]}

Tato, W. ^{[1
]}

Ayerdi, J. J. ^{[1
]}

Gomez, X. ^{[1
]}

机构：

[1] Mondragon Univ, Surface Technol, Fac Engn, Loramendi 4, Arrasate Mondragon 20500, Spain

来源：

TRIBOLOGY INTERNATIONAL | 2020年 / 143卷

关键词：

Friction; Coefficient of friction; Fretting loop; Fretting; WEAR; TI-6AL-4V; BEHAVIOR; FATIGUE; SIMULATION; DEBRIS; DAMAGE;

D O I：

10.1016/j.triboint.2019.105988

中图分类号：

TH [机械、仪表工业];

学科分类号：

0802 ;

摘要：

This work presents a critical analysis of coefficient of friction derivation methods for fretting under gross slip regime. A mass review of tribology journals revealed that 41% of papers did not specify the derivation method used and 37% employed the least effective methods. Following an analytical and experimental study, the use of the geometric independent coefficient of friction method (GICoF) is suggested for gross slip regime due to its robustness, followed by the energy method (ECoF). This study highlights the importance of the correct selection of the coefficient of friction method and it quantifies potential errors.

引用

页数：10

共 50 条

[31] Finite element analysis of stress singularity in partial slip and gross sliding regimes in fretting wear
Yue, Tongyan
Wahab, M. Abdel
WEAR, 2014, 321 : 53 - 63
[32] Transition of friction and wear by stick-slip phenomenon in various environments under fretting conditions
Jeong, Sung-Hoon
Park, Jung-Min
Lee, Young-Ze
ADVANCED NONDESTRUCTIVE EVALUATION I, PTS 1 AND 2, PROCEEDINGS, 2006, 321-323 : 1344 - 1347
[33] Introduction of a new sliding regime criterion to quantify partial, mixed and gross slip fretting regimes: Correlation with wear and cracking processes
Heredia, S.
Fouvry, S.
WEAR, 2010, 269 (7-8) : 515 - 524
[34] Experimental and modelling aspects of abrasive wear of a A357 aluminium alloy under gross slip fretting conditions
Elleuch, K
Fouvry, S
WEAR, 2005, 258 (1-4) : 40 - 49
[35] Comparison coefficient of friction curves of wet friction contacts in controlled slip mode under dynamic excitation
Kemper, Christian
Wantzen, Knut
Bischofberger, Arne
Ott, Sascha
Albers, Albert
FORSCHUNG IM INGENIEURWESEN-ENGINEERING RESEARCH, 2019, 83 (02): : 239 - 246
[36] Stress and fatigue analysis of fretting on a stressed specimen under partial slip conditions
Fouvry, Siegfried
Ruiz, Franscisco
Kapsa, Philippe
Vincent, Leo
TriboTest, 1996, 3 (01): : 23 - 44
[37] Sensitivity of critical value of friction coefficient for brake squeal analysis
Huang, Jinchun
Krousgrill, Charles M.
Bajaj, Anil K.
PROCEEDINGS OF THE ASME INTERNATIONAL DESIGN ENGINEERING TECHNICAL CONFERENCE AND INFORMATION IN ENGINEERING CONFERENCE, VOL 1, PTS A-C, 2008, : 2095 - 2103
[38] Estimation of critical value of friction coefficient for brake squeal analysis
Huang, Jinchun
Krousgrill, Charles M.
Bajaj, Anil K.
Proceedings of the ASME International Design Engineering Technical Conferences and Computers and Information in Engineering Conference, Vol 1, Pts A-C, 2005, : 941 - 949
[39] Derivation of a wear scar geometry-independent coefficient of friction from fretting loops exhibiting non-Coulomb frictional behaviour
Jin, X.
Sun, W.
Shipway, P. H.
TRIBOLOGY INTERNATIONAL, 2016, 102 : 561 - 568
[40] Theoretical analysis of fatigue cracking under dry friction for fretting loading conditions
Fouvry, S
Kapsa, P
Vincent, L
Van, KD
WEAR, 1996, 195 (1-2) : 21 - 34

← 1 2 3 4 5 →