Tungsten coating on JET divertor tiles for erosion/deposition studies

被引：36
|
作者：
Lehto, S
Likonen, J
Coad, JP
Ahlgren, T
Hole, DE
Mayer, M
Maier, H
Kolehmainen, J
机构：
[1] EURATOM, VTT Proc, FIN-02044 Espoo, Finland
[2] EURATOM, UKAEA, Abingdon OX14 4DB, Oxon, England
[3] Univ Helsinki, Accelerator Lab, EURATOM Assoc, FIN-00014 Helsinki, Finland
[4] Univ Sussex, Sch Engn, Brighton BN1 9QH, E Sussex, England
[5] EURATOM, Max Planck Inst Plasmaphys, D-85748 Garching, Germany
[6] DIARC Technol Inc, FIN-02200 Espoo, Finland
来源：
FUSION ENGINEERING AND DESIGN | 2003年 / 66-68卷
关键词：
tungsten coating; erosion; deposition; divertor tiles; JET;
D O I：
10.1016/S0920-3796(03)00291-6
中图分类号：
TL [原子能技术]; O571 [原子核物理学];
学科分类号：
0827 ; 082701 ;
摘要：
Six Joint European Torus (JET) divertor tiles were coated with tungsten marker stripes for erosion/deposition studies. The average thickness was 3.4 mum and the film was uniform within 5% across and within 10% along the stripe. Small amounts of impurities C, Fe, Ni and Cr were found and the in-plane stress was 965 MPa. Resistance to high heat loads was tested in the Neutral Beam Test-bed at JET where a coated carbon fibre composite block was exposed to a total of 113 pulses with a maximum peak power density of 15.7 MW m(-2) and a maximum surface temperature of 1280 degreesC. No visible changes as a result of thermal cycling nor sputtering of the film by deuterium could be detected. (C) 2003 Elsevier Science B.V. All rights reserved.
引用
收藏
页码：241 / 245
页数：5
相关论文
共 50 条
  • [41] Spectroscopic measurements of tungsten erosion in the ASDEX upgrade divertor
    IPP-EURATOM Assoc, Berlin, Germany
    Plasma Phys Controlled Fusion, 9 (1487-1499):
  • [42] Divertor configuration studies on JET
    Lowry, C.G.
    Campbell, D.J.
    Davies, S.
    Guo, H.
    Harbour, P.J.
    von Hellermann, M.
    Horton, L.D.
    Loarte, A.
    Maggi, C.
    Matthews, G.
    Mohanti, R.
    Monk, R.
    Radford, G.J.
    Reichle, R.
    Saibene, G.
    Journal of Nuclear Materials, 241-243 : 438 - 443
  • [43] Divertor configuration studies on JET
    Lowry, CG
    Campbell, DJ
    Davies, S
    Guo, H
    Harbour, PJ
    vonHellermann, M
    Horton, LD
    Loarte, A
    Maggi, C
    Matthews, G
    Mohanti, R
    Monk, R
    Radford, GJ
    Reichle, R
    Saibene, G
    Spence, J
    Stamp, M
    Taroni, A
    Vlases, GC
    JOURNAL OF NUCLEAR MATERIALS, 1997, 241 : 438 - 443
  • [44] Deuterium retention in the divertor tiles of JET ITER-Like wall
    Lahtinen, A.
    Likonen, J.
    Koivuranta, S.
    Hakola, A.
    Heinola, K.
    Ayres, C. F.
    Baron-Wiechec, A.
    Coad, J. P.
    Widdowson, A.
    Raisanen, J.
    Abhangi, M.
    Abreu, P.
    Aftanas, M.
    Afzal, M.
    Aggarwal, K. M.
    Aho-Mantila, L.
    Ahonen, E.
    Aints, M.
    Airila, M.
    Albanese, R.
    Alegre, D.
    Alessi, E.
    Aleynikov, P.
    Alfier, A.
    Alkseev, A.
    Allan, P.
    Almaviva, S.
    Alonso, A.
    Alper, B.
    Alsworth, I.
    Alves, D.
    Ambrosino, G.
    Ambrosino, R.
    Amosov, V.
    Andersson, F.
    Andersson Sunden, E.
    Angelone, M.
    Anghel, A.
    Anghel, M.
    Angioni, C.
    Appel, L.
    Apruzzese, G.
    Arena, P.
    Ariola, M.
    Arnichand, H.
    Arnoux, G.
    Arshad, S.
    Ash, A.
    Asp, E.
    Asunta, O.
    NUCLEAR MATERIALS AND ENERGY, 2017, 12 : 655 - 661
  • [45] Deuterium retention on the tungsten-coated divertor tiles of JET ITER-like wall in 2015-2016 campaign
    Lahtinen, A.
    Likonen, J.
    Koivuranta, S.
    Alves, E.
    Baron-Wiechec, A.
    Catarino, N.
    Coad, J. P.
    Heinola, K.
    Raisanen, J.
    Widdowson, A.
    FUSION ENGINEERING AND DESIGN, 2019, 146 : 1979 - 1982
  • [46] Development and testing of a bulk tungsten tile for the JET divertor
    Hirai, T.
    Bondarchuk, E.
    Borovkov, A. I.
    Koppitz, Th
    Linke, J.
    Mertens, Ph
    Neubauer, O.
    Panin, A.
    Philipps, V.
    Pintsuk, G.
    Sadakov, S.
    Steinbrech, R. W.
    Schweer, B.
    Uytdenhouwen, I.
    Vassen, R.
    Samm, U.
    Sievering, R.
    PHYSICA SCRIPTA, 2007, T128 : 144 - 149
  • [47] Development and qualification of a bulk tungsten divertor row for JET
    Mertens, Ph.
    Altmann, H.
    Hirai, T.
    Philipps, V.
    Pintsuk, G.
    Rapp, J.
    Riccardo, V.
    Schweer, B.
    Uytdenhouwen, I.
    Samm, U.
    JOURNAL OF NUCLEAR MATERIALS, 2009, 390-91 : 967 - 970
  • [48] Helium jet-cooled tungsten divertor concept
    O'Dell, J. S.
    Raffray, A. R.
    22ND IEEE/NPSS SYMPOSIUM ON FUSION ENGINEERING, 2007, : 5 - +
  • [49] Comparison of erosion and deposition in JET divertor during the first three ITER-like wall campaigns
    Krat, S.
    Mayer, M.
    Baron-Wiechec, A.
    Brezinsek, S.
    Coad, P.
    Gasparyan, Yu
    Heinola, K.
    Jepu, I.
    Likonen, J.
    Petersson, P.
    Ruset, C.
    de Saint-Aubin, G.
    Widdowson, A.
    PHYSICA SCRIPTA, 2020, T171 (01)
  • [50] Impact of nitrogen seeding on carbon erosion in the JET divertor
    Brezinsek, S.
    Jachmich, S.
    Rapp, J.
    Meigs, A. G.
    Nicholas, C.
    O'Mullane, M.
    Pospieszczyk, A.
    van Rooij, G.
    JOURNAL OF NUCLEAR MATERIALS, 2011, 417 (1-3) : 624 - 628
12345