EXPERIMENTAL STUDY OF STRUCTURE FORMATION OF EUTECTIC BY ELECTRON MICROSCOPY IN NEW AS CAST Al-Cu15-Mg-Ti ALLOYS

被引：0
|
作者：
Zlaticanin, Biljana [1 ]
机构：
[1] Univ Montenegro, Fac Met & Technol, Podgorica 81000, Montenegro
来源：
FRESENIUS ENVIRONMENTAL BULLETIN | 2022年 / 31卷 / 1A期
关键词：
Al-Cul 5-Mg -Ti system; Al2Cu phase; Al2CuMg phase; crystal structure; ALUMINUM; MICROSTRUCTURE;
D O I：
暂无
中图分类号：
X [环境科学、安全科学];
学科分类号：
08 ; 0830 ;
摘要：
Two new as -cast alloys based on high copper Al-Cu15-Mg-Ti system were developed. The microstructure of the Al-Cu15-Mg-Ti alloys mainly consists of c( -Al, Al2Cu and Al2CuMg phases. In this paper, the structure of eutectic Al2Cu and Al2CuMg phases in Al-Cu15-Mg-Ti system has been determined by using a high-resolution electron microscopy. The Al-Cu 15-Mgt-Ti and Al-Cul5-Mg5-Ti alloys had similar microstructures that consisted of et -Al grains and eutectic structure. With the increase in eutectic fraction the hardness and strength of AlCul5-Mg-Ti alloys increased.
引用
收藏
页码：1034 / 1044
页数：11
相关论文
共 50 条
  • [41] Microstructure of die-cast alloys Mg-Zn-Al(-Ca): a study by electron microscopy and small-angle neutron scattering
    Vogel, M
    Kraft, O
    Staron, P
    Clemens, H
    Rauh, R
    Arzt, E
    ZEITSCHRIFT FUR METALLKUNDE, 2003, 94 (05): : 564 - 571
  • [42] STUDY ON STRENGTH AND FRACTURE TOUGHNESS OF Al-Zn-Mg-Cu-Ti(-Sn) ALLOYS
    Yan, A.
    Chen, L.
    Liu, H. S.
    Xiao, F. F.
    Li, X. Q.
    JOURNAL OF MINING AND METALLURGY SECTION B-METALLURGY, 2015, 51 (01) : 73 - 79
  • [43] FORMATION OF MICROGRAIN STRUCTURE AND SUPERPLASTIC STATE IN ALLOYS OF THE Al - Cu - Mg - Fe - Ni SYSTEM
    Kotov, A. D.
    Mikhailovskaya, A. V.
    Portnoi, V. K.
    Sagalova, T. B.
    METAL SCIENCE AND HEAT TREATMENT, 2012, 54 (7-8) : 340 - 344
  • [44] Formation of micrograin structure and superplastic state in alloys of the Al–Cu–Mg–Fe–Ni system
    A. D. Kotov
    A. V. Mikhailovskaya
    V. K. Portnoi
    T. B. Sagalova
    Metal Science and Heat Treatment, 2012, 54 : 340 - 344
  • [45] A STUDY OF PRECIPITATION PHENOMENA IN AL-LI AND AL-LI-CU-MG ALLOYS BY POSITRON-ANNIHILATION AND TRANSMISSION ELECTRON-MICROSCOPY
    DLUBEK, G
    KRAUSE, S
    KRAUSE, H
    WELPMANN, K
    PETERS, M
    SCRIPTA METALLURGICA ET MATERIALIA, 1992, 27 (08): : 1049 - 1054
  • [46] A quantitative study by transmission electron microscopy of nanoscale precipitates in Al-Mg-Si alloys
    Donnadieu, P
    Roux-Michollet, M
    Chastagnier, V
    PHILOSOPHICAL MAGAZINE A-PHYSICS OF CONDENSED MATTER STRUCTURE DEFECTS AND MECHANICAL PROPERTIES, 1999, 79 (06): : 1347 - 1366
  • [47] Structure Determination of Al2CuMg Precipitates in AlCu15Mg5 Alloys by High-Resolution Electron Microscopy
    Zlaticanin, Biljana
    INDIAN JOURNAL OF ENGINEERING AND MATERIALS SCIENCES, 2022, 29 (05) : 637 - 641
  • [48] Effect of cooling rate and eutectic modification on texture and grain structure of Al-Si-Cu-Mg die cast alloy
    Zamani, M.
    Seifeddine, S.
    Ghassemali, E.
    METALLURGIA ITALIANA, 2016, (06): : 29 - 32
  • [49] Microstructure and mechanical properties of new die-cast quaternary Al-Cu-Si-Mg alloys
    Cai, Qing
    Mendis, Chamini L.
    Chang, Isaac T. H.
    Fan, Zhongyun
    MATERIALS SCIENCE AND ENGINEERING A-STRUCTURAL MATERIALS PROPERTIES MICROSTRUCTURE AND PROCESSING, 2021, 800
  • [50] Microstructure and mechanical properties of new die-cast quaternary Al-Cu-Si-Mg alloys
    Cai Q.
    Mendis C.L.
    Chang I.T.H.
    Fan Z.
    Materials Science and Engineering: A, 2021, 800
12345