Local heat transfer coefficients at the inlet of an annular flow passage

被引：10

作者：

Dirker, Jaco ^{[1
]}

Meyer, Josua P. ^{[1
]}

Kohlmeyer, Berno W. ^{[1
]}

机构：

[1] Univ Pretoria, Dept Mech & Aeronaut Engn, Private Bag X20, ZA-0028 Hatfield, South Africa

来源：

INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER | 2017年 / 113卷

基金：

新加坡国家研究基金会;

关键词：

Local heat transfer coefficients; Turbulent flow; Liquid crystal thermography; Annulus; Developing flow; THERMAL ENTRANCE REGION; CONCENTRIC ANNULI; PRESSURE-DROP; TUBE; EXCHANGER; PIPE;

D O I：

10.1016/j.ijheatmasstransfer.2017.05.044

中图分类号：

O414.1 [热力学];

学科分类号：

摘要：

Annular flow geometries are commonly found in several heat exchange devices, however, relatively little experimental work has been done specifically to determine the local heat transfer coefficients in developing flow in annuli. In this experimental study circumferentially averaged local heat transfer coefficients were determined with water for a uniform heat flux boundary condition on the inner wall in a horizontal concentric annular test section with a length of 1.05 m, a hydraulic diameter of 14.8 mm, and a diameter ratio of 0.648. Local inner wall temperatures were obtained via liquid crystal thermography with the aid of an automated camera position system. Conventional on-centre and off-centre annular inlet configurations with three inlet sizes were evaluated for Reynolds numbers ranging from 2000 to 7500. It was found that the local heat transfer coefficients were significantly higher at the inlet, and decreased as the boundary layers developed. Local maximum and minimum heat transfer coefficients were identified which may be due to flow impingement caused by the inlet geometry. A new local heat transfer correlation for the turbulent flow in regions close to the inlet of an annular flow passage was developed. (C) 2017 Elsevier Ltd. All rights reserved.

引用

页码：268 / 280

页数：13

共 50 条

[21] Local pressure measurements and heat transfer coefficients of flow boiling in a rectangular microchannel
Mirmanto, M.
HEAT AND MASS TRANSFER, 2016, 52 (01) : 73 - 83
[22] SEMIEMPIRICAL METHOD OF LOCAL HEAT-TRANSFER COEFFICIENTS DETERMINATION AT SPHERE FLOW
KUDRYASHEV, LI
KLUYEV, NI
IZVESTIYA VYSSHIKH UCHEBNYKH ZAVEDENII AVIATSIONAYA TEKHNIKA, 1979, (01): : 107 - 109
[23] Local pressure measurements and heat transfer coefficients of flow boiling in a rectangular microchannel
M. Mirmanto
Heat and Mass Transfer, 2016, 52 : 73 - 83
[24] Annular flow heat transfer at convex surface
Dawande, S.D.
Giradkar, J.R.
Chemical Engineering World, 1994, 29 (06): : 101 - 104
[25] Heat transfer in annular channels with flow swirling
Il'in G.K.
Tarasevich S.E.
Yakovlev A.B.
Thermal Engineering, 2010, 57 (3) : 247 - 251
[26] Heat transfer in annular channels with flow twisting
Boltenko E.A.
Il'in G.K.
Tarasevich S.E.
Yakovlev A.B.
Russ. Aeronaut., 2007, 3 (287-291): : 287 - 291
[27] ANGULAR COEFFICIENTS OF RADIATIVE HEAT TRANSFER IN CYLINDRICAL AND ANNULAR CAVITIES
VAFIN, FM
HIGH TEMPERATURE, 1969, 7 (04) : 686 - &
[28] Stokes flow heat transfer in an annular, rotating heat exchanger
Saatdjian, E.
Rodrigo, A. J. S.
Mota, J. P. B.
APPLIED THERMAL ENGINEERING, 2011, 31 (8-9) : 1499 - 1507
[29] Heat transfer characteristics and parameter optimization of flow passage of herringbone heat transfer
Yang Y.
Ma Q.
Zuo Y.
Nongye Gongcheng Xuebao/Transactions of the Chinese Society of Agricultural Engineering, 2019, 35 (21): : 210 - 215
[30] LOCAL HEAT TRANSFER COEFFICIENTS IN CURVILINEAR CHANNELS
MIROPOLSKII, ZL
PIKUS, VY
INTERNATIONAL CHEMICAL ENGINEERING, 1968, 8 (01): : 78 - +

← 1 2 3 4 5 →