Stress and Pressure Pulsation Analysis of Low Temperature Compressor Piping System in LNG Vaporizing Station

被引:2
|
作者
Wang, Baoqing [1 ]
Zhang, Zhi [2 ]
Huang, Kun [2 ]
Zhang, Yaotong [1 ]
Zhang, Zhenwu [3 ]
Gao, Hui [1 ]
Fu, Lingdi [4 ]
机构
[1] Sinopec Tianjin LNG Co Ltd, Tianjin 300457, Peoples R China
[2] Southwest Petr Univ, Petr Engn Sch, Chengdu 610500, Peoples R China
[3] Anhui Prov Nat Gas Dev Co Ltd, Hefei 230051, Peoples R China
[4] PetroChina Southwest Oil & Gasfield Co, Environm & Technol Supervis Res Inst, Chengdu 610041, Peoples R China
关键词
LNG vaporizing station; low temperature compressor; piping system; stress analysis; modal analysis; pressure pulsation; SUPPRESSION; TESTS; MODEL;
D O I
10.3390/en15051874
中图分类号
TE [石油、天然气工业]; TK [能源与动力工程];
学科分类号
0807 ; 0820 ;
摘要
LNG (Liquefied Natural Gas) vaporizing stations are usually built in the cities and towns, and the BOG (Boiled Off Gas) pressurizing system is a very important element. In the pressurizing system, the severe vibration of the low-temperature reciprocating compressor may lead to a failure of the pipeline system and the equipment. Therefore, this paper analyzes the stress and pressure pulsation of the BOG compressor piping system in the LNG vaporizing station. The beam model was used to establish the pipe model. The static, harmonic and modal analysis were carried out based on the plane-wave theory and the pressure-fluctuation theory, and the influence factors of support spacing, the settlement of the fulcrum foundation, pipe pressure and elbow angle were analyzed. The main conclusions are as follows: (1) the unbalanced excited force caused by pressure pulsation greatly affects the stress of the exhaust pipe and compressor outlet pipe, and has less influence on the stress of the suction pipe and compressor inlet pipe; (2) although unbalanced excited force is generated in the elbow, it also has an impact on the straight pipe stress; (3) adding an expansion joint to the pipe of the BOG compressor can effectively reduce the stress of the pipe its the displacement, and can increase the flexibility of the pipe.
引用
收藏
页数:21
相关论文
共 50 条
  • [31] The Stress Analysis of New Pressure Piping Model
    Wang, Bin
    Liu, Cai
    Wu, Xueli
    Qiao, Xuefei
    ADVANCED MATERIALS AND COMPUTER SCIENCE, PTS 1-3, 2011, 474-476 : 1215 - +
  • [32] PRESSURE PULSATION IN A CENTRIFUGAL PUMP-PIPING SYSTEM (2ND REPORT, PRESSURE DISTRIBUTION IN A PIPE AND EFFECTS OF PUMP CONFIGURATION ON PRESSURE PULSATION).
    Goto, Masanori
    Nippon Kikai Gakkai Ronbunshu, B Hen/Transactions of the Japan Society of Mechanical Engineers, Part B, 1988, 54 (502): : 1371 - 1377
  • [33] Vibration analysis and control of a screw compressor outlet piping system
    Zhao, Ying
    Feng, Jianmei
    Zhao, Bin
    Zhou, Shuangmei
    Tang, Zhou
    Peng, Xueyuan
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART E-JOURNAL OF PROCESS MECHANICAL ENGINEERING, 2019, 233 (02) : 403 - 411
  • [34] Thermal Stress Analysis of Process Piping System Installed on LNG Vessel Subject to Hull Design Loads
    Hwang, Se-Yun
    Kim, Min-Seok
    Lee, Jang-Hyun
    JOURNAL OF MARINE SCIENCE AND ENGINEERING, 2020, 8 (11) : 1 - 16
  • [35] Prediction of Pressure Pulsation for the Reciprocating Compressor System Using Finite Disturbance Theory
    Xu, Bin
    Feng, Quanke
    Yu, Xiaoling
    JOURNAL OF VIBRATION AND ACOUSTICS-TRANSACTIONS OF THE ASME, 2009, 131 (03): : 0310071 - 0310077
  • [36] ACTIVE CONTROL OF PRESSURE PULSATION IN A PIPING SYSTEM USING MEASURED DYNAMIC FLOW RATE
    Pan, Min
    Johnston, D. Nigel
    Plummer, Andrew
    Kudzma, Sylwester
    Hillis, Andrew
    PROCEEDINGS OF THE ASME/BATH SYMPOSIUM ON FLUID POWER AND MOTION CONTROL, 2013, 2014,
  • [37] Pulsation attenuation in a reciprocating compressor piping system using a volume-perforated pipe-volume suppressor
    Ma, Quyang
    Wu, Zhenhuan
    Li, Mengjun
    Yang, Guoan
    PROCEEDINGS OF THE INSTITUTION OF MECHANICAL ENGINEERS PART C-JOURNAL OF MECHANICAL ENGINEERING SCIENCE, 2018, 232 (17) : 3074 - 3084
  • [38] VIBRATION OF PIPING SYSTEM BY PULSATION OF CONTAINING FLUID (2ND REPORT, COUPLED RESPONSE ANALYSIS OF FLUID PULSATION AND SHELL MODE VIBRATION OF PIPING).
    Tanaka, Mamoru
    Fujita, Katsuhisa
    Nippon Kikai Gakkai Ronbunshu, C Hen/Transactions of the Japan Society of Mechanical Engineers, Part C, 1987, 53 (491): : 1363 - 1367
  • [39] STATION LOW-PRESSURE PIPING, SUBMERSIBLE PUMPS AND TAILWATER DEPRESSION SYSTEMS
    TAYLOR, MW
    BUSSE, DE
    SOUTH AFRICAN MECHANICAL ENGINEER, 1982, 32 (08): : 217 - 218
  • [40] EXPERIENCES IN DEVELOPING A PRACTICAL ALGORITHM OF IDENTIFICATION AND ATTENUATION OF PRESSURE PULSATION AND PIPING VIBRATION IN GAS RECIPROCATING COMPRESSOR PLANTS AND OTHER SYSTEMS
    Rydlewicz, Maciej
    Rydlewicz, Wojciech
    PROCEEDINGS OF THE ASME PRESSURE VESSELS AND PIPING CONFERENCE, 2018, VOL 4, 2019,