Alloy Composition Screening for Ni-Base Turbine Disc Superalloys Using the Creep Property of Single Crystal

This paper proposes a method for alloy composition screening using the creep property of a single crystal (SC) for designing new Ni-base powder metallurgy (P/M) turbine disc superalloys. A commercial Ni-base disc alloy, U720Li (R), a Ni-Co-base disc alloy, TMW-4M3, and a Ni-base conventionally cast alloy, TM-47, were selected for investigation. Their SC and P/M samples were prepared such that their gamma/gamma ' structures were similar. Moreover, tensile creep tests were performed on SC samples, and compressive creep tests were performed on SC and P/M samples. The tensile creep test results of SC samples at 1073 K (800 degrees C) and 735 MPa indicate that 0.2 and 1 pct creep times, as well as rupture life, are long in the order of TM-47 SC, TMW-4M3 SC, and U720Li SC. These results simulate the intragranular creep resistances of the corresponding P/M alloys. Furthermore, there is no significant difference in 0.2 and 1 pct compressive creep times between the SC and P/M samples of each alloy. Additionally, the 0.2 and 1 pct creep times of tensile and compressive creep tests of every alloy had an identical order. Therefore, alloy composition screening using SC creep property enables the design of new disc alloys with excellent creep resistance.